Redox:1989: Ammeter Reading (A)
Redox:1989: Ammeter Reading (A)
Redox:1989: Ammeter Reading (A)
4. (a) A student used the set-up below to study the conductivity of aqueous solution of
several solutes:
(i) Why was there no ammeter reading in experiment I, while ammeter readings
were obtained in experiment II and III?
(ii) In experiment II, name the gas liberated at
(1) electrode Q.
(2) electrode R.
Explain why gas bubbles were liberated at different rates.
(iii) In experiment III,
(1) explain the observations by writing ionic equations for the reactions which
occurred at electrodes Q and R respectively.
(2) describe briefly how you would confirm that the deposit was copper by a
chemical test. State the reagents you would use and give the observations
expected.
(11 marks)
3. (b) The results of experiments with iron and three other metals X, Y, Z and their oxides
are summarized in the following tables:
Metal
Iron X Y Z
Experiment
Action of metal on iron(II) No immediate
Iron is deposited A gas is evolved No reaction
sulphate solution reaction
Metal
oxide Fe2O3 XO Y2O Z2O
Experiment
Action of heat on metal Metal Z is
No reaction No reaction No reaction
oxide formed
(i) What was the gas evolved in the reaction of Y with iron(II) sulphate solution?
Write an equation for the reaction involved. (State symbols should be given.)
Page 1
(ii) Arrange the four metals in descending order of activity, and briefly explain your
answer.
(iii) One of the three metals, X, Y or Z was used to form a chemical cell with an iron
rod, as shown in the diagram below:
(1) Which of the three metals, X, Y or Z would be the most suitable as the metal
strip? Give two reasons for your choice.
(2) Suggest one reason why aqueous sodium sulphate solution is used in this
cell.
(3) Write an ionic equation for the oxidation reaction taking place in the cell.
(4) Explain how the principle behind this experiment can be applied to protect
iron from rusting.
(12 marks)
Redox :1990
4. (a)
Diagram I shows a set-up for the electrolysis of 0.5 M potassium bromide solution.
After passing electricity for some time, gas bubbles were observed at electrode A,
while the solution around electrode B turned yellowish-brown. This colouration
gradually extended to the bottom of the U-tube and a steady colour boundary was
formed as shown in diagram II.
Page 2
Redox :1991
2. (c) Iron sheets can be tin-plated by electrolysis of either tin(II) or tin(IV) compounds
before they are used to make food cans.
(i) In the above electrolysis, what material should be used as the anode?
(ii) Give one reason to explain why iron is first tin-plated before food cans are made
from it.
(iii) If the tin-plated iron sheet has been scratched to expose the iron, can it still be
used to make a food can?
(6 marks)
4. (b) The following diagram shows the longitudinal section of a dry cell:
Redox :1992
Page 3
Redox :1993
2. (a) Tuning knobs on radios are often made of plastics plated with metal coatings.
(i) State two reasons why plastics are used in the manufacture of tuning knobs.
(ii) What is the purpose of plating the knob with metal?
The plastic knobs are first coated with copper and then electroplated with nickel. The
electroplating can be conducted using the following set-up:
(iii) Why is the plastic knob first coated with copper before electroplating?
(iv) Write an ionic equation for the reaction that occurs at the cathode during
electroplating.
(6 marks)
Redox :1994
7. (a)
In the above diagram, P and Q are two different metals. When the circuit is closed, a
current flows in the external circuit. After some time, 0.36 g of copper is deposited on
the carbon electrode R.
(i) What is the direction of electron flow in the external circuit? Explain your
answer.
(ii) After the circuit has been closed for some time, what would be observed
(1) at the carbon electrode S?
(2) in the copper(II) sulphate solution?
(iii) What is the function of set-up X in this experiment?
(iv) Which of the metals, P or Q, occupies a higher position in the electrochemical
series? Explain your answer.
(8 marks)
Page 4
Redox :1995
9. (b)
When the circuit in the set-up shown above is closed, the acidified potassium
permanganate solution loses its colour gradually.
(i) Write a half equation for the reaction that occurs in the acidified potassium
permanganate solution. Explain whether the permanganate ion is oxidized or
reduced.
(ii) What would be observed in the potassium iodide solution after some time?
Write a half equation for the reaction that would occur.
(iii) Identify the direction of electron flow in the external circuit.
(iv) Write an ionic equation for the reaction that occurs when an acidified potassium
permanganate solution and a potassium iodide solution are mixed together.
(v) (1) What is the function of the salt bridge in the set-up?
(2) Explain whether a sodium sulphite solution can be used instead of a
potassium nitrate solution in the salt bridge.
(8 marks)
Redox :1996
6. (a) The table below lists the oxidation number of iron in two compounds:
(i) (1) What would be observed when sodium hydroxide solution is added to
iron(II) sulphate solution?
(2) Explain whether this reaction is a redox reaction.
(ii) When iron(II) sulphate solution is mixed with dilute sulphuric acid and a small
amount of a purple solution, a reaction occurs and the oxidation number of iron
changes from +2 to +3. Suggest what the purple solution may be.
(1) What would be observed in this reaction?
(2) Write an ionic equation for the reaction involved.
(iii) When iron (II) sulphate solution reacts with an element X, the oxidation number
of iron changes from +2 to 0.
(1) Suggest what X may be.
(2) What would be observed in this reaction? Explain whether iron(II) sulphate
solution acts as a reducing agent or an oxidizing agent in this reaction.
(10 marks)
Page 5
9. (b) A student carried out a copper-plating experiment in the laboratory using the set-up
shown below:
Redox :1997
8. (b) Read the following paragraph concerning chromium and answer the questions that
follow:
Page 6
12. Essay Question
Briefly describe how you would conduct an experiment, using the materials and
apparatus listed below, to nickel-plate a clean metal spoon. (Diagrams are not required.)
State the expected observation of the experiment.
Redox :1998
6. (b) The table below includes some information about three types of dry cells. The voltage
of each type of cell is 1.5 V.
(The life of a cell has been determined from its use in a test with a motorized toy.)
(i) Describe and explain which type of cell should be used in a small CD-player
(Discman).
(ii) A package of 24 zinc-carbon cells is now being ofeered at a special price of
$49.90. Assuming that your radio consumes one zinc-carbon cell per month,
would you buy a package of these specially-priced cells for the use of your
radio? Explain your answer.
(iii) The half-equations below show the changes at the two electrodes, A and B, of a
silver oxide cell during discharge:
A : Zn(s) + 2OH-(aq) → ZnO(s) + H2O() + 2e-
B : Ag2O(s) + H2O() + 2e- → 2Ag(s) + 2OH-(aq)
(1) Describe and explain which electrode, A or B, is the anode.
(2) Write the overall equation for the reason that would occur in the cell during
discharge.
(iv) The following information was found on the package of a brand of zinc-carbon
cells:
Caution : 1. Do not dispose of used cells in fire.
2. Remove cells when not in use for prolonged periods.
(1) Explain why used cells should not be disposed of in fire.
(2) Explain why the cells should be removed when not in use for prolonged
periods.
(9 marks)
2. For each of the following experiment, state the expected observation and write a relevant
chemical equation.
(c) A sodium sulphite solution is added to an iodine solution (iodine dissolved in aqueous
potassium iodide.)
Page 7
(2 marks)
9. (b) Each of the following experiments produces a sodium hydroxide solution.
Experiment I
Action of sodium on water
(i) What would be observed when a small piece of sodium is added to water?
(ii) Explain whether experiment I or experiment II is preferred for preparing a
sodium hydroxide solution.
(iii) During the electrolysis of brine, chlorine and hydrogen are liberated at the
anode and cathode respectively. A sodium hydroxide solution remains in the
electrolytic cell after some time.
(1) Explain why hydrogen, instead of sodium is liberated at the cathode.
(2) Suppose that 50.0 cm3 of hydrogen is liberated at the cathode at room
temperature and pressure. Deduce the theoretical volume of chlorine
liberated at the anode under the same conditions.
(3) Explain why a sodium hydroxide solution remains in the electrolytic cell.
(iv) Draw a labeled diagram to show the laboratory set-up for the electrolysis of
brine and the collection of the gaseous products.
(10 marks)
Redox :1999
8. (a) The diagram below shows the longitudinal section of a zinc-carbon cell.
(i) Write a half-equation for the reaction that occurs at the zinc case of the cell
during discharge.
(ii) State the function of following substances in a zinc-carbon cell.
(1) carbon rod
(2) manganese(IV) oxide
(iii) Suggest a chemical test to show the presence of ammonium ions in the moist
paste of ammonium chloride.
(iv) Explain whether you agree with the following statement.
‘Zinc-carbon cells cause more environmental problems than nickel-cadmium
cells do.’
(v) Complete and balance the following half-equations for the reactions that occur
at the electrodes of a nickel-cadmium cell.
Cd + OH- → Cd(OH)2
NiO2 + H2O → Ni(OH)2 + OH-
Page 8
(9 marks)
6. (a) Water is a compound of hydrogen and oxygen. Under suitable conditions, 80.0 cm3 of
hydrogen and 60.0 cm3 of oxygen (with one of the reactants in excess) react to give
water. The volumes of both gases are measured at room temperature and pressure.
(i) Draw the electronic diagram of water, showing electrons in the outermost shells
only.
(ii) Assume that the two gases undergo complete reaction. Deduce the volume of
the remaining gas, measured at room temperature and pressure, at the end of the
reaction.
(iii) Water can be decomposed by electrolysis with the following set-up to give
hydrogen and oxygen.
(1) Explain why a little sulphuric acid has been added to the water used.
(2) Suggest a suitable material for the electrodes.
(3) Write the half-equation for the formation of oxygen.
(4) Suggest a chemical test for each product obtained in the electrolysis.
(8 marks)
Page 9