Breaking new ground in

Sterilisation

Disinfecting

Water
purification

© 2009. The written and pictorial material in this document is the property of
Envirolyte Industries International Ltd and its partners and may not be copied,
disseminated or reproduced in any form without the written permission of Envirolyte
Industries International Ltd.
 On-site production of solutions for cleaning, disinfecting and sterilizing

Safe, Effective and Non-toxic, Excellent Return on Investment

Envirolyte ELA units are designed to generate, on-site, cleaning, disinfecting and sterilizing
solutions out of 0.05% - 1.0% salt brine (NaCl or Kcl).

EL-1200
The units electrolyze the salt water and, using polymer or ceramic membranes, separate the
positive and negative ions. As a result of these electrochemical reactions various types of
activated solutions are produced. The purpose is to control and/or eliminate pathogens such
as bacteria, viruses, spores, mold and fungi, as well as cleaning and removing heavy metals.

The merits of chlorination as a means of destroying pathogens is firmly and universally

established. In recent years, however, the appearance of resistant strains of bacteria, the
discovery of Legionella, plus other problems associated with chlorine compounds have
promoted an interest in alternative water disinfection technologies. Envirolyte fs technologies
produce chlorine based compounds but with significant reduction in cost, danger and
ecological impact.

Key Features

• Easy and safe to use

• Efficient: reduced sterilization contact time
• Self-cleaning
• Biodegradable fluids
• Easy operating procedures give the added benefits
to rapid delivery of safe and fast acting disinfectant
- Neutral Anolyte.
• The strength of Neutral Anolyte in terms of active
chlorine concentration can be adjusted by current set-
ting.

EL-1200

© 2009. The written and pictorial material in this document is the property of Envirolyte
Industries International Ltd and its partners and may not be copied, disseminated or reproduced
in any form without the written permission of Envirolyte Industries International Ltd.
 • A flow controller is installed in the Hydraulic part to shut
the Envirolyte unit if there is interruption of water supply
and to start the unit as soon as water flow resumes.
• A simple on/off switch with power indicator starts and
stops the ELA units manually.
• Capacity depends on the model and varies between 40
LPH and 4000 LPH

EL-1200

Technical characteristics and requirements

Output capacity 120 LPH of ANK-Neutral Anolyte ONLY with possibility

for Catholyte isolation for Ph correction of ANK or
Acidic Anolyte (50%-80%) and Catholyte (50%-20%)
ONLY
FAC (Minimum) 500 ppm
Water supply 2-3 bar
Salt consumption per 1 ~5-7 g depending on the source water
liter of Anolyte * EL-1200 generators with lower salt consumption
are available upon request
Power source 230 VAC
Power consumption 1,8 KW/H
Special note Specially designed EL-1200 units are available
with ~1,75 - 2,0 g per 1 L of anolyte or ~3,5 -
4,0 g per 1,0 g of FAC salt consumption and 715
W/H power consumption.
Specially designed units with lower parameters
of salt and energy consumption are available
upon request.
Flushing mode Manual
Brine delivery Venture
Type of cell R-120
Piping & fittings LLDPE tubing & Kynar fittings
Cabinet(s) size & 600X400x220
material Polyester
Weight ~ 25 kg.

© 2009. The written and pictorial material in this document is the property of Envirolyte
Industries International Ltd and its partners and may not be copied, disseminated or reproduced
in any form without the written permission of Envirolyte Industries International Ltd.
 The Envirolyte Solutions

ANK-Neutral Anolyte solution is used wherever pH is important (e.g. corrosion) and where
possible evaporation of active chlorine cannot be avoided. Neutral Anolyte is highly effective
against a broad range of pathogens including bacteria, viruses, spores, mold and fungi.

Active Ingridient pH ORP/REDOX

500 - 700 ppm of active chlorine 5.0 to 8.5 700 to 900

Acidic Anolyte solution can be used wherever there is a need to disinfect or sterilize in
applications where the pH is unimportant and where there is no danger of corrosion. Acidic
Anolyte is a very powerful and fast acting disinfectant against all bacteria, viruses, spores,
mold, fungi and algae even when it is diluted in water or sprayed in the air.

Active Ingridient pH ORP/REDOX

500 - 700 ppm of active chlorine 2.0 to 3.5 1000 to 1200

Catholyte Solution is alkaline and serves as an excellent washing liquid, plus it removes
heavy metals from water through precipitation.

Active Ingridient pH ORP/REDOX

Sodium Hydroxide 10.0 to 13.0 -900 to -950

Every Envirolyte unit can be set to generate either ANK- Neutral Anolyte only with
isolation of a certain volume of Catholyte for Ph correction of ANK or Acidic Anolyte
and Catholyte only. Setting of the unit for production of specific fluids is done at the
Envirolyte factory

Producing Solutions

Typically, Anolyte produced by an Envirolyte unit is collected in a container and then dosed
into the incoming water. The dosing regime depends on the water flow and quality (properties)
of the water and is controlled by a flow meter connected with a dosing pump. The units can
stand alone (e.g. for spraying, hand cleaning, CIP disinfection, etc.) or they can be used as
part of a continuous process in more complex systems. Design facilities are available for
customized units.

Based on extensive research, both anolyte and catholyte solutions:

-Are environmentally friendly
-Are non-toxic to both humans and animals
-Do not require special handling;
-Are powerful biocides

© 2009. The written and pictorial material in this document is the property of Envirolyte
Industries International Ltd and its partners and may not be copied, disseminated or reproduced
in any form without the written permission of Envirolyte Industries International Ltd.
 -Can be safely disposed of in sewage systems
-Are fast-acting;
-Can be used in all stages of disinfection and cleaning;
-At recommended concentrations, do not bleach surfaces or materials;
-Can be applied in liquid, ice or aerosol (fog) form;
-Are hypoallergenic;
-Yield by-products that are non-toxic, environmentally friendly and leave no synthetic
chemical residue;
-Can be generated on-site, thus eliminating handling and storage of chemicals;
-Can be produced on-site from tap water and salt in required quantities and
concentrations of active ingredients, pH and salinity (mineralization).

In addition, anolyte application, as a hard-surface disinfectant on a daily basis for

more than ten years, demonstrated that microorganisms do not develop resistance against
anolyte over time.

The characteristics described above position Envirolyte equipment for potential

applications in a number of areas directly related to personal health and safety.

Separate Anolyte and Catholyte Layout

This layout would be used when the disinfectant fluid (Anolyte) and the cleaning fluid
(Catholyte) are required as separate liquids. This configuration is often used in applications
such as surface cleaning where the Catholyte is added to warm water to facilitate its degrease
action. The generator is connected to a level sensor in the first buffer tank and it will start
or stop depending on the levels set at installation. Pumps can be connected to the tanks to
move the fluids either into a water system or to connect to high pressure sprayers or fogging
equipment for surface cleaning. In addition in the waste water industry Catholyte and Anolyte
are often required as separate fluids.

© 2009. The written and pictorial material in this document is the property of Envirolyte
Industries International Ltd and its partners and may not be copied, disseminated or reproduced
in any form without the written permission of Envirolyte Industries International Ltd.
 Water Systems

• Effective biocide at low dosage, including Legionella

• Removes bio-film and algae
• Neutralizes odor compounds
• Less formation of toxic by-products

Industrial Cleaning and Disinfection

• Cleans and disinfects surfaces

• Effective biocide, including Legionella
• Removes bio-film and algae
• Clean-in-place (CIP) cleaning and disinfection

Health Care/Medical

• Cold sterilization of medical instruments

• Cleans surfaces, including walls, furniture and floors
• Produces sterile water
• Used in the laundry, it disinfects linen
• Disinfects air through misting
• Eliminates/reduces chemical usage

Veterinary

• Increases vitality and resistance

• Improves fertility
• Residue free treatment of mastitis, diarrhea and infection
• Better feed stuff utilization
• Reduces tension
• Enhances growth and yields.
• Effectively controls and cures the most serious diseases

Poultry Industry

• General disinfection
• Surface cleaning and misting medium for aerobic and
anaerobic bacteria
• Fodder assimilation
• Promotion of general health as a drinking water additive
(reduced mortality)
• Pest control on feathers (lice)
• De feathering, aerobic and anaerobic bacteria control through
misting
• Equipment cleaning without further additives.
• Disease control and cure

© 2009. The written and pictorial material in this document is the property of Envirolyte
Industries International Ltd and its partners and may not be copied, disseminated or reproduced
in any form without the written permission of Envirolyte Industries International Ltd.
 Pig Farming
• General disinfection
• Surface cleaning and misting medium for aerobic and
anaerobic bacteria
• Fodder assimilation
• Promotion of general health as a drinking water additive
(reduced mortality)
• Pest control on the skin.
• Aerobic and anaerobic bacteria control through misting
• Equipment cleaning without further additives
• Disease control and cure

Dairy Farming

• General disinfection
• Surface cleaning and misting medium for aerobic and
anaerobic bacteria
• Fodder assimilation
• Promotion of general health as a drinking water additive
(reduced mortality)
• Pest control on the skin.
• Aerobic and anaerobic bacteria control through misting
• Equipment cleaning without further additives
• Disease control and cure

Horticulture/Agriculture

• Disinfect grain for storage

• Preserves fodder/silage
• Suppresses pathogenic fungi on plants
• Prolongs the shelf life of vegetables, fruit and cut flowers
• Disinfects irrigation water and decreases the effluent toxicity
• Disinfects seeds, accelerating the growth of the plants,
increasing the number of flowers and yield

Waste Water

• Disinfects municipal effluent

• Disinfects livestock manure
• Neutralization and flocculates heavy metals

Cooling Towers

• Prevents formation of insoluble calcium and magnesium salts

(scale and calcification).
• Prevents the growth of algae, bio-film and anaerobic bacteria
such as Legionella

© 2009. The written and pictorial material in this document is the property of Envirolyte
Industries International Ltd and its partners and may not be copied, disseminated or reproduced
in any form without the written permission of Envirolyte Industries International Ltd.
 Breweries

• Treatment of incoming water and brewing water.

• Disinfection of all surfaces in the production process.
• Bottle washing.
• Filling plants, pumps, filters, reservoirs, water tanks, wells.
• Rinsing of installations.
• Disinfection of all installations, pipelines, working cloths etc.
• Pipeline protection.
• Cooling installations, air cleaning systems

Food Processing

• Disinfection of incoming and rinse water.

• Prolongs the shelf life of vegetables, fruit and cut flowers.
• Disinfection of all surfaces in the production process.
• Equipment cleaning without further additives.
• General disinfection, control of fungi growth in the premises.
• Clean-in-place (CIP) cleaning and disinfection.
• Disinfection of various produce before packaging.

Swimming Pools

• Effective biocide
• Does not irritate eyes and skin
• Does not have such sharp chlorine smell as other chemical
products
• Does not irritate airway
• Does not cause allergy
• Easy to use and handle - it is prepared on site and on demand
• Cheap (1m³ of ANK Anolyte cost about €1.9)

Envirolyte Industries International Ltd.

Narva str. 1-330

10111 Tallinn
Estonia

Phone +372 6626 630

Fax +372 6626 631

envirolyte@envirolyte.com
www.envirolyte.com
© 2009. The written and pictorial material in this document is the property of Envirolyte
Industries International Ltd and its partners and may not be copied, disseminated or reproduced
in any form without the written permission of Envirolyte Industries International Ltd.