Looking After Your Radio Installing the Battery LED Status Indicator

MXP600 Never leave your radio or battery in extreme temperatures (over +85 °C). 4
1 Emergency Button 1 2

QUICK START GUIDE For example, behind a windscreen in direct sunlight. 1 2 LED Status Indicator Indication Status when Status when Charging
Not Charging
The radio is submersible (compliant with the IP68 standard), but only with the 3 GCAI-Mini Connector
battery and antenna attached. Solid green In use Fully charged
To clean your radio, use a moistened or antistatic cloth. 2 4 Antenna
Ensure no contamination is on the gore port membrane, that is the area labelled In TMO service or idle/
5 Rotary Knob 1. Insert the battery into the compartment at a high entry angle. Blinking green 90% charged
as VENT on the back of the radio chassis. 3 Switching from TMO to DMO
2. Slide the battery under the two catches.
6 Programmable Button 3. Press down the battery until it clicks in place. Solid red Out of service Rapid charge
Holding Your Radio
7 Push-To-Talk Button (PTT) Connecting to a network/
The radio has three microphones: Removing the Battery Blinking red Faulty or invalid battery
8 Soft Key Switching from DMO to TMO
• A top front microphone for Simplex group, dispatcher, or private calls.

Knowing Your Radio

5 Radio is powering on/
• A top back microphone for optional noise cancellation. 19 9 Near-Field Communication Tag 3 2 Solid orange Not applicable
Transmit Inhibit mode in service

Getting Started
• A bottom microphone for Duplex, telephone-like calls.
18 10 Send Key Incoming private or Battery on standby to
6 1 Blinking orange
phone call rapid charge
1. When using high audio, hold your radio 11 Bottom Microphone Radio powered off/
vertically with the top microphone 5–10 cm away No indication Not applicable
17 12 Backlight Sensor Radio in covert mode
from your mouth. 7 1. Slide the battery latch to the right and hold it.
2. Speak into the top microphone. 16
5–10 cm 13 Keypad 2. Lift the battery. Battery Capacity Information
3. Listen through the speaker. 8 3. Remove the battery from the compartment.
4. Keep the antenna at least 2.5 cm away from 8 14 Speaker
Simplex Calls
your head and body. 6 Information Description
15 15 On/Off/End/Home Key
9 Attaching the Antenna
16 Menu Key Full (80%–100% capacity)
www.motorolasolutions.com 14

www.motorolasolutions.com
1. When using low audio, hold your radio as you 2.5 cm 1. Turn off the radio before attaching the antenna.
would a telephone. 10 17 Display 2. Insert the threaded base of the antenna into
2. Speak into the bottom microphone. 13 the terminal on top of the radio. Middle (60%–80% capacity)
3. Listen through the earpiece. 18 Top Microphone
3. Turn the antenna clockwise until snug.
4. Keep the antenna at least 2.5 cm away from Do not force. Low (25%–60% capacity)
11 12 19 Earpiece
your head and body.
Duplex Calls 20 Bottom Connector Very low (5%–25% capacity)
20 Turning the Radio On or Off
To turn the radio on or off, press and hold the On/Off key. Less than 5% capacity
More Information on the Radio Status Icons Unlocking the Radio Making TMO or DMO Emergency Group Calls
Visit the Motorola Solutions Web site at: To unlock the radio after powering on, enter the code at the prompt. 1. Press and hold the Emergency button.
http://www.motorolasolutions.com/ The default code is 0000. Your service provider may change this number before The emergency alarm is sent automatically (if configured).
Icon Description Icon Description you receive your radio. 2. Press and hold PTT.
Learning Experience Portal 3. Wait for the Talk Permit Tone (if configured) and talk. Release PTT to listen.
User documentation available at: In Service (TMO) Low Audio If using the Hot Mic feature, wait for the Emergency Mic On message to appear on the
https://learning.motorolasolutions.com/ Unlocking or Locking 1 display, then talk without pressing PTT.
No Service (TMO) High Audio the Keypad 4. To exit Emergency Mode, press and hold the Exit soft key.
Open Source Software Legal Notices
To unlock or lock the keypad, press the
Available in Customer Programming Software Plus (CPS Plus) DVD Signal Strength Earpiece Connected Menu key followed by the * key. Making Simplex Private Calls
2
High RF Power New Message Has Arrived In DMO:
Using the Radio Menu 1. From the home screen, dial a number.

Using the Terminal

Direct Mode (DMO) 2. Press and hold PTT to make a call.
New Message In Inbox To enter the menu, press the Menu key. 3. Wait for the Talk Permit Tone (if configured) and talk. Release PTT to listen.
To scroll through the menu, press the Up or 4. To terminate the call, press the End key.
Emergency Mode Packet Data Down Navigation button.

Icons
To select a menu item, press the Select soft key In TMO:

m
This document is copyright protected. Duplications for the purpose of the use of Motorola Solutions products
Battery Strength Keys Locked or the Right Navigation key.
To return to the previous level, press Back or
1. From the home screen, dial a number.
2. Press PTT to make a call. Wait for the called party to pick up.
3. When the call is connected, press and hold PTT to talk. Wait for the Talk Permit Tone (if
Battery Charging GNSS the Left Navigation key.
are permitted to an appropriate extent. Duplications for other purposes, changes, additions or other
To exit the menu, press the Back key. configured). Release PTT to listen.
processing of this document are not permitted. Only this electronically-saved document is considered to be 4. To terminate the call, press the End key.
the original. Duplications are considered merely copies. Motorola Solutions, Inc., and its subsidiaries and All Ring Tones Off Non-Formatted SD Card
affiliates do not vouch for the correctness of such kinds of copies.
Selecting TMO or DMO
MOTOROLA, MOTO, MOTOROLA SOLUTIONS and the Stylized M Logo are trademarks or registered Simplex Ring Muted USB Connected Making Duplex Private, Phone, or PABX Calls
trademarks of Motorola Trademark Holdings, LLC and are used under license. The Bluetooth® word mark and From the home screen, select Options → Trunked Mode or Direct Mode.
www.motorolasolutions.com

www.motorolasolutions.com
logos are registered trademarks owned by the Bluetooth SIG, Inc. and are used under license. All other 1. From the home screen, dial a number.
trademarks are the property of their respective owners. Duplex Ring Muted Bluetooth Enabled 2. Press the Send key. The ring tone sounds till the called party answers.
© 2020 Motorola Solutions, Inc. All rights reserved. 3. To terminate the call, press the End key.
Scan Wi-Fi Strength Making TMO or DMO Group Calls
MN006359A01-AA 1. From the home screen, press the Navigation keys or turn the Rotary Knob to Sending Status Message
Migration Wi-Fi OTAP highlight the desired talkgroup.
*MN006359A01* 2. Press Select.
3. Press and hold PTT.
1. From the home screen, press the Menu key.
2. Select Messages → Send Status.
4. Wait for the Talk Permit Tone (if configured) and talk. 3. Highlight the required status message and press the Send key.
5. To listen, release PTT. 4. If the list is empty, enter a 5-digit status message number and press the Send key.
MXP600 QUICK START GUIDE