SPA-400 Funkwerk ATR833
SPA-400 Funkwerk ATR833
SPA-400 Funkwerk ATR833
TIP
TO AIRCRAFT POINT A 12345
POWER BUSS (INTERCOM PIN 19 MIC AUDIO
12 / 28 VDC INTERCOM CENTRAL
CIRCUIT GROUND PIN 15 RADIO MIC KEY AIRCRAFT RADIO
BREAKER POINT) AIRCRAFT RING TIP
AIRCRAFT / INTERCOM HEADPHONE PIN 3 & 6 AUDIO GROUND
(1 AMP)
INTERFACE AREA JACK TO
PIN 7 NO CONNECTION
NOTES * 1/4
220 Ohm
watt
AIRCRAFT
HAND MIC SEE NOTE 3
1. IF PILOT PTT SWITCH IS CONNECTED TO THE AIRCRAFT HAND Resistor JACK
MIC JACK, IT MUST BE DISCONNECTED AND CONNECTED TO THE
WHITE / RED WIRE AS SHOWN.
2. AIRCRAFT CHASSIS GROUND.
3. SEE RADIO MANUFACTURERS INSTALLATION INSTRUCTIONS
FOR ALL POWER, GROUND, AND ANY ADDITIONAL HOOKUPS.
4. THIS INSTALLATION DIAGRAM IS FOR A SINGLE RADIO SYSTEM
(4) BLACK WITHOUT AUDIO PANEL. PILOT CO-PILOT
(7) RED
P1 (6) BROWN
J1 (5) WHITE
SQ ON VOL
(8) TAN
(3) BLUE
TO TO TO TO
TIP RING TIP TIP RING TIP TIP RING TIP TIP RING TIP
BARREL BARREL BARREL BARREL
BARREL BARREL BARREL BARREL
HEADPHONE MIC HEADPHONE MIC HEADPHONE MIC HEADPHONE MIC
JACK JACK JACK JACK JACK JACK JACK JACK
PASSENGER 2 PASSENGER 1 CO-PILOT PILOT
* ICS Load Modification. Add a 1/4 or 1/2 watt resistor per the drawing. The value of the resistor most commonly used is 220 ohms, however, optimum performance can be achieved by selecting the value right for your
particular installation. The resistor can be any value between 100 and 1000 ohms and is selected for the best balance between radio receive volume and intercom volume.
For more information about this resistor mod see the ICS Load Modification instructions. File Name: ICS-Load_1440_Mod.pdf
Sigtronics Corporation Telephone: (909) 305-9399 The above information has been checked for accuracy, however it is presented for use as is. Sigtronics is not liable for
E-mail: info@sigtronics.com S igtronics damage to radio equipment using this data. It is the sole responsibility of the technician to verify the usability of this
178 East Arrow Highway ®