Specification sheet

VEGASWING 61
Relay (DPDT)
Vibrating level switch for liquids
Technical data
Process pressure -1 … +64 bar/-100 … +6400 kPa
(-14.5 … +928 psig)
The function of the instrument is en-
sured up to an operating pressure of
100 bar/10000 kPa (1450 psig) at a
maximum process temperature of +50 °C
(+122 °F) (only with threaded versions).
Process temperature -50 … +250 °C (-58 … +482 °F)
Viscosity - dynamic 0.1 … 10000 mPa s
Density 0.7 … 2.5 g/cm³ (0.025 … 0.09 lbs/in³);
0.5 … 2.5 g/cm³ (0.018 … 0.09 lbs/in³) by
switching over
Ambient temperature -40 … +70 °C (-40 … +158 °F)
Hysteresis approx. 2 mm (0.08 in) with vertical instal-
lation
Process fitting Threads from G¾, ¾ NPT, flanges from
DN 25, 1", hygienic fittings
Operating voltage 20 … 253 V AC, 50/60 Hz; 20 … 72 V DC
Power consumption 1 … 8 VA (AC), approximately 1.5 W (DC)
Application area Switching voltage max. 253 V AC/DC
Switching current max. 3 A AC (cos phi > 0,9), 1 A DC
The VEGASWING 61 is used as a universal vibrating level switch for
Breaking capacity min. 50 mW, max. 750 VA AC, 40 W DC
all liquids. Independent of the mounting position, it detects reliably with
(with U < 40 V DC)
millimetre accuracy the limit level. The instrument can be used as empty
or full detector, as approved overfill protection, dry run protection or SIL qualification Optionally up to SIL2
pump protection in vessels and pipelines. The VEGASWING 61 offers
maximum reliability and safety in a wide application range.
Materials

The wetted parts of the instrument are made of stainless steel 316L.
Your benefit The supplied process seal is made of Klingersil C-4400.
• Minimum time and cost expenditure due to simple setup without A complete overview of the available materials and seals can be found
medium on our homepage.
• Precise and reliable function due to product-independent switching
point
Housing versions
• Low maintenance costs
The housings are available in plastic, stainless steel or Aluminium.

Function They are available with protection ratings up to IP 67.

The heart of the sensor is the vibration drive by which the tuning fork
is energized to vibrate at its resonance frequency. When covered Electronics versions
with medium, the frequency of the fork decreases. This frequency
change is processed by the integrated electronics and converted into The instruments are available in different electronics versions. Apart
a switching command. With the tuning fork with only 38 mm length, the from the versions with transistor output, contactless electronic switch
VEGASWING work reliably independent of the installation position in and relay output, a two-wire version for connection to a controller and a
any liquid. Pressure, temperature, foam, viscosity and the composition NAMUR version are also available.
of the liquid do not influence the switching accuracy.
Approvals

The instruments are suitable for use in hazardous areas and are ap-
proved, e.g. according to ATEX, FM, CSA and IEC. The instruments
also have different ship approvals such as e.g. GL, LRS or ABS and are
approved as overfill protection according to WHG.
You can find detailed information on the existing approvals with the ap-
propriate product on our homepage.

VEGA Grieshaber KG, Am Hohenstein 113, 77761 Schiltach/Germany, www.vega.com VEGASWING 61 - 34663-EN-190514
 Specification sheet

Adjustment In the download section on our homepage you'll find free operating
instructions, product information, brochures, approval documents,
The mode and sensitivity of the level switch can be adjusted on the instrument drawings and much, much more.
electronics module. A signal lamp shows the switching status of the
instrument.
Instrument selection

On our homepage under "Products" you can select the suitable meas-
uring principle and instrument for your application.
SW E60R

345678 A 0,5 g / cm3 1 You can find detailed information on the instrument versions at www.
20-72V DC
2 0 - 2 5 0 V AC
+
vega.com and "Products".
L N
B 0,7 g / cm3
2

3
1 2 3 4 5 6 7 8 Contact
4
5 You can find your personal contact person at VEGA on our homepage
www.vega.com and "Contact".

Electronics and connection compartment, single chamber housing

1 Control lamp
2 DIL switch for mode adjustment
3 DIL switch for switching point adaptation
4 Ground terminal
5 Connection terminals

Electrical connection

+
L N

1 2 3 4 5 6 7 8

Wiring plan
You can find details on electrical connection in the instrument operating
instructions on our homepage at www.vega.com/downloads.

Dimensions
18,5 mm
(0.73")

19 mm
(0.75")

SW 41 mm
(1.61")
36 mm
(1.42")

G1 A
69 mm
(2.72")

53 mm
(2.09")

53 mm
(2.09")

1 2 3

VEGASWING 61
1 Threaded version
2 Clamp version
3 Flange version

Information

You can find further information on the VEGA product line on our home-
page.

VEGA Grieshaber KG, Am Hohenstein 113, 77761 Schiltach/Germany, www.vega.com VEGASWING 61 - 34663-EN-190514