Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                

Running Gait

Download as pdf or txt
Download as pdf or txt
You are on page 1of 18

Running Gait

Introduction
➢Running is similar to walking in terms of locomotor activity.
➢But there are key differences.
➢Three phases:
➢Stance
➢Swing
➢Float
➢Running requires:
➢Greater balance
➢Greater muscle strength
➢Greater joint range of movement
Running Gait Cycle
Running:
Foot Striking
Difference between walking and Running
➢ Greater balance because the double support period present in walking is not
present when running.
➢ Addition of a double float period during which both feet are off the ground.
➢The amount of time that the runner spends in float, increases as the runner
increases in speed.
➢The muscles must produce greater energy to elevate the head, arms and trunk
(HAT) higher than in normal walking, and to support HAT during the gait cycle.
➢The muscles and joints, must also be able to absorb increased amounts of
energy to control the weight of HAT.
➢ The Ground reaction force (GRF) at the centre of pressure(COP) increases to
250% of the body weight
Kinematics: Joint motion During Running
HIP Joint Knee Joint Ankle Joint
❖ Hip is in about 50° flexion at ❖ Knee flexes to 40° as the heel ❖ Ankle is in 10° of dorsiflexion at
heel strike, then extend during strikes, then flexes to 60° during heel strike and then dorsiflexes
the rest of the stance phase. It the loading response. to 25° DF.
reaches 10° of hyperextension ❖ Then knee begins to extend and ❖ Plantarflexion happens almost
after toe off. reaches 40° flexion just before immediately, continuing
❖ The hip flexes to 55° flexion in toe-off. throughout the stance phase
the late swing phase. ❖ During swing phase and the and at also at entry to swing
❖ Before the end of the swing initial part of the float period, phase.
phase, the hip flexes to 50° to the knee flexes to reach ❖ Then ankle dorsiflexes
prepare for the heel strike. maximum flexion of 125° during throughout the swing phase to
the mid swing. 10° preparing for heel strike.
❖ The knee then prepares for heel ❖ The lower limb medially rotates.
strike by extending to 40 ❖ Then foot pronates at heel
strike.
Muscle Activity
Gluteus maximus and gluteus medius:
➢ Active at the beginning of stance phase, and also at the end of swing phase.
TFL:
➢ It is active from the beginning of stance, and also the end of swing phase. It is
also active between early and mid swing.
Adductor Magnus:
➢ It is active for about 25% of cycle, from late stance to early part of swing phase
Muscle Activity
Iliopsoas:
➢ Its activity occurs during swing phase for 35-60% of cycle.
Quadriceps:
➢ Works in an eccentric manner for the initial 10% of the stance phase.
➢ Its role is to control knee flexion as the knee goes through rapid flexion.
➢ It stops being active after the first part of the stance phase, there is then no activity
until the last 20% of swing phase.
➢ At this point it becomes concentric in behavior so it can extend the knee to prepare for
heel strike.
Muscle Activity
Medial Hamstring:
➢ It become active at the beginning of the stance phase(18-28% of stance),
➢ Being active throughout much of the swing phase(40-58% of initial swing then the last
20% of swing).
➢ It extends the hip and control the knee through concentric contraction.
➢in late swing, the hamstrings act eccentrically to control knee extension and take the hip
into extension again.
Muscle Activity
Gastrocnemius:
➢ Muscle activity starts just after loading at heel strike, remaining active up until 15% of
the gait cycle (this is where its activity begins in walking).
➢ It re-starts its activity in the last 15% of the swing phase.
Tibialis anterior:
➢ Muscle is active through both stance and swing phases in running. It is active for about
73% of the cycle (compared to 54% when walking).
➢ Thus, TA is considerably more active when running.
➢Its activity is mainly concentric or isometric, enabling the foot to clear the support
surface during the swing phase of the running gait.
Elastic Support Strategy
➢Joanne Elphinstone (2013) describes this as a mechanism for transferring force
from the lower control zone to the upper control zone and back again.
➢In runners the diagonal elastic support mechanism is utilized.
➢This is produced by a constant diagonal stretch and release that is enabled by the
body's counter rotation.
➢The force continually flows up and down these force pathways alternately.
➢The pattern of force distribution prevents force being concentrated in one area,
but allows wide distribution of force throughout the body.
➢it is crucial to have a well functioning central core area to allow this pattern of
force distribution to take place efficiently.
Rotation Through Kinetic Chain
➢ The kinetic chain can be described as a series of joint movements, that make
up a larger movement.
➢ Running mainly uses sagittal movements as the arms and legs move forwards.
➢ There is also a rotational component as the joints of the leg to support the
body weight on each side.
➢There is also an element of counter pelvic rotation as the chest moves forward
on the opposite side.
Rotation Through Kinetic Chain
➢ This rotation is produced at the spine, and is often referred to as the spinal
engine.
➢ This is also linked to running economy.- This enables the spinal forces to be
dissipated as the foot hits the ground.
➢ Runners may complain of a feeling of restriction in hamstrings or shoulders,
➢ when examined it may be found that there is actually limitation in rotation of
the pelvis, causing the problem.
Ideal Running
Overstriding

Often leads to inadequate hip


extension
Inadequate hip extension=
Inadequate power generation
THANK YOU!!!

You might also like