Data Centric and Content Based Networking

Data-centric and content-based
networking
Introduction
Routing protocols for WSNs fall into three

groups:
1. Data centric
2. Hierarchical
3. Location based
Data centric networking
In a wireless sensor network, the interest of an application is
not so much in the identity of a particular sensor node, it is
much rather in the actual information reported about the
physical environment. This is especially the case when a WSN
is redundantly deployed such that any given event could be
reported by multiple nodes it is of no concern to the
application precisely which of these nodes is providing data.
This fact that not the identity of nodes but the data are at the
center of attention is called data-centric networking.
Examples
Sensor Protocols for Information via
Negotiation(SPIN)
Directed diffusion
Gradiant based routing(GBR)
Constrained anisotropic diffusion routing(CADR)
COUGAR
ACQUIRE
SPIN
SPIN exploits data naming, use descriptive data to
perform negotiations before transmitting the
actual data
A receiver that expresses interest in the data
content can send a request to obtain the data
advertised.
Data are sent only to interested nodes, thereby
eliminating traffic implosion and reducing
significantly the transmission of redundant data
throughout the network.
A simulation-based performance study of
SPIN-1 shows that the protocol reduces
energy consump1on by a factor of 3.5
compared to flooding.
SPIN (cont.)- SPIN family
Protocols of the SPIN family
SPIN-PP
It is designed for a point to point communication, i.e., hop-
by-hop routing
SPIN-EC
It works similar to SPIN-PP, but, with an energy heuristic
added to it
SPIN-BC
It is designed for broadcast channels
SPIN-RL
When a channel is lossy, a protocol called SPIN-RL is used
where adjustments are added to the SPIN-PP protocol to
account for the lossy channel.
7
SPIN (cont.)- Three-stage handshake
protocol
SPIN-PP: A three-stage handshake protocol for point-
to-point media
ADV data advertisement
Node that has data to share can advertise this by
transmitting an ADV with meta-data attached
REQ request for data
Node sends a request when it wishes to receive some
actual data
DATA data message
Contain actual sensor data with a meta-data header
Usually much bigger than ADV or REQ messages
8
SPIN (cont.)- SPIN-EC (Energy-Conserve)
Add simple energy-conservation heuristic to
SPIN-PP
SPIN-EC: SPIN-PP with a low-energy threshold
Incorporate low-energy-threshold
Works as SPIN-PP when energy level is high
Reduce participation of nodes when approaching
low-energy-threshold
When node receives data, it only initiates protocol if it can
participate in all three stages with all neighbor nodes
When node receives advertisement, it does not request the
data
Node still exhausts energy below threshold by
receiving ADV or REQ messages
9
SPIN (cont.)- Conclusion
SPIN protocols hold the promise of achieving high
performance at a low cost in terms of complexity,
energy, computation, and communication
Pros
Each node only needs to know its one-hop neighbors
Significantly reduce energy consumption compared to flooding
Cons
Data advertisement cannot guarantee the delivery of data
If the node interested in the data are far from the source,
data will not be delivered
Not good for applications requiring reliable data delivery, e.g.,
intrusion detection
10
4.2.2
Directed Diffusion
A Scalable and Robust
Communication Paradigm for Sensor
Networks
11
Overview
Data-centric communication A sensor field

Sources
Data is named by attribute-value Event
pairs
Different form IP-style
communication
End-to-end delivery service
Directed
e.g. Diffusion
How many pedestrians do you
observe in the geographical
Sink Node
region X?
12
Overview (cont.)
Data-centric communication (cont.)
Human operators query (task) is diffused
Sensors begin collecting information about query
Information returns along the reverse path
Intermediate nodes aggregate the data
Combing reports from sensors
Directed Diffusion is an important milestone in the
data centric routing research of sensor networks
13
Directed Diffusion
Typical IP based networks

Requires unique host ID addressing
Application is end-to-end
Directed diffusion use publish/subscribe

Inquirer expresses an interest, I, using attribute values
Sensor sources that can service I, reply with data
14
Directed Diffusion (cont.)
Directed diffusion consists of

Interest - Query which specifies what a user wants
Data - Collected information
Gradient
Direction and data-rate
Events start flowing towards the originators of interests
Reinforcement
After the sink starts receiving events, it reinforces at
least one neighbor to draw down higher quality events
15
Reinforcement (1/4)
Positive reinforcement
Sink selects the neighboring node
Original interest message but with high data-rate
Neighboring node must also reinforce at least one neighbor
Low-delay path is selected
Exploratory gradients still exist: useful for faults
Reinforced gradient
Event Reinforced gradient
Source
A sensor field
Sink
16
Reinforcement (2/4)
Path failure and recovery

Link failure detected by reduced rate, data loss
Choose next best link (i.e., compare links based on
infrequent exploratory downloads)
Negatively reinforce lossy link
Either send interest with base (exploratory) data rate or
allow neighbors cache to expire over time
Link A-M lossy
Event D A reinforces B
M B reinforces C
Source A
C reinforces D
C
B Sink
or
A negative reinforces M
M negative reinforces D
17
Reinforcement (3/4)
Multipath routing B
Source
Consider each gradients link
quality Event
A
Sink
Using negative reinforcement
Path Truncation Multiple paths
Loop removal
For resource saving
Ex:
B gets same data from both A and D, but D
always delivers late due to looping D E
B negative reinforces D, D negative
reinforces E, E negative reinforces B
Loop BE D B eliminated A B C
Conservative negative reinforces A removable loop
useful for fault resilience
18
Directed Diffusion: Pros & Cons
Different from SPIN in terms of on-demand
data querying mechanism
Sink floods interests only if necessary (lots of energy savings)
In SPIN, sensors advertise the availability of data
Pros
Data centric: All communications are neighbor to neighbor
with no need for a node addressing mechanism
Each node can do aggregation & caching
Cons
On-demand, query-driven: Inappropriate for applications
requiring continuous data delivery, e.g., environmental
monitoring
Attribute-based naming scheme is application dependent
For each application it should be defined a priori
Extra processing overhead at sensor nodes
19

Data Centric and Content Based Networking

Uploaded by

Copyright:

Available Formats

Data Centric and Content Based Networking

Uploaded by

Document Information

Original Description:

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Data Centric and Content Based Networking

Uploaded by

Copyright:

Available Formats

What are the three groups that routing protocols for WSNs fall into?

What is data-centric networking and what are its key characteristics?

Data-centric and content-based

Routing protocols for WSNs fall into three

Data-centric communication A sensor field

Typical IP based networks

Directed diffusion use publish/subscribe

Directed diffusion consists of

Path failure and recovery

You might also like