This study aims at evaluating the performance of a two-chambered continuously fed microbial fuel ... more This study aims at evaluating the performance of a two-chambered continuously fed microbial fuel cell with new Ti-TiO₂ electrodes for bioelectricity generation from young landfill leachate at varying strength of wastewater (1-50 COD g/L) and hydraulic retention time (HRT, 0.25-2 days). The COD removal efficiency in the MFC increased with time and reached 45 % at full-strength leachate (50 g/L COD) feeding. The current generation increased with increasing leachate strength and decreasing HRT up to organic loading rate of 100 g COD/L/day. The maximum current density throughout the study was 11 A/m² at HRT of 0.5 day and organic loading rate of 67 g COD/L/day. Coulombic efficiency (CE) decreased from 57 % at feed COD concentration of 1 g/L to less than 1 % when feed COD concentration was 50 g/L. Increase in OLR resulted in increase in power output but decrease in CE.
The purpose of the study was to characterize ferric iron precipitates formed in batch experiments... more The purpose of the study was to characterize ferric iron precipitates formed in batch experiments over a temperature range of 2 to 40°C from ferric sulfate and mineral salts in sulfuric acid. With the exception of elevated levels of K+ to promote jarosite [KFe3(SO4)2(OH)6] formation, the solution composition was intended to simulate fully oxidized bioleaching solutions. Iron-oxidizing acidophilic bacteria were
Main objective of this study was to develop a statistical model for easier and faster Biochemical... more Main objective of this study was to develop a statistical model for easier and faster Biochemical Methane Potential (BMP) prediction of landfilled municipal solid waste by analyzing waste composition of excavated samples from 12 sampling points and three waste depths representing different landfilling ages of closed and active sections of a sanitary landfill site located in İstanbul, Turkey. Results of Principal Component Analysis (PCA) were used as a decision support tool to evaluation and describe the waste composition variables. Four principal component were extracted describing 76% of data set variance. The most effective components were determined as PCB, PO, T, D, W, FM, moisture and BMP for the data set. Multiple Linear Regression (MLR) models were built by original compositional data and transformed data to determine differences. It was observed that even residual plots were better for transformed data the R(2) and Adjusted R(2) values were not improved significantly. The best preliminary BMP prediction models consisted of D, W, T and FM waste fractions for both versions of regressions. Adjusted R(2) values of the raw and transformed models were determined as 0.69 and 0.57, respectively.
ABSTRACT Microbial Fuel Cells (MFC) are used to produce electricity while simultaneously treating... more ABSTRACT Microbial Fuel Cells (MFC) are used to produce electricity while simultaneously treating wastewater. This novel technology use bacteria to convert organic waste material into electrical energy through catabolic reactions of microorganisms under anaerobic conditions. In this study, wastewater treatment and production of electricity using different substrates is summarized in dual-chambered MFC.
The applicability of a fluidized-bed reactor (FBR)-based sulfate reducing bioprocess was investig... more The applicability of a fluidized-bed reactor (FBR)-based sulfate reducing bioprocess was investigated for the treatment of iron-containing (40-90 mg/L) acidic wastewater at low (8 degrees C) and high (65 degrees C) temperatures. The FBRs operated at low and high temperatures were inoculated with cultures of sulfate-reducing bacteria (SRB) originally enriched from arctic and hot mining environments, respectively. Ethanol was supplemented as carbon and electron source for SRB. At 8 degrees C, ethanol oxidation and sulfate reduction rates increased steadily and reached 320 and 265 mg/L.day, respectively, after 1 month of operation. After this point, the rates did not change significantly during 130 days of operation. Despite the complete ethanol oxidation and iron precipitation, the average sulfate reduction efficiency was 35 +/- 4% between days 30 and 130 due to the accumulation of acetate. At 65 degrees C, a rapid startup was observed as 99.9, 46, and 29% ethanol, sulfate, acetate removals, in respective order, were observed after 6 days. The feed pH was decreased gradually from its initial value of 6 to around 3.7 during 100 days of operation. The wastewater pH of 4.3-4.4 was neutralized by the alkalinity produced in acetate oxidation and the average effluent pH was 7.8 +/- 0.8. As in the low temperature FBR, acetate accumulated. Hence, the oxidation of acetate is the rate-limiting step in the sulfidogenic ethanol oxidation by thermophilic and psychrotrophic SRB. The sulfate reduction rate is three times and acetate oxidation rate is four times higher at 65 degrees C than at 8 degrees C.
An enrichment culture from a boreal sulfide mine environment containing a low-grade polymetallic ... more An enrichment culture from a boreal sulfide mine environment containing a low-grade polymetallic ore was tested in column bioreactors for simulation of low temperature heap leaching. PCR-denaturing gradient gel electrophoresis and 16S rRNA gene sequencing revealed the enrichment culture contained an Acidithiobacillus ferrooxidans strain with high 16S rRNA gene similarity to the psychrotolerant strain SS3 and a mesophilic Leptospirillum ferrooxidans strain. As the mixed culture contained a strain that was within a clade with SS3, we used the SS3 pure culture to compare leaching rates with the At. ferrooxidans type strain in stirred tank reactors for mineral sulfide dissolution at various temperatures. The psychrotolerant strain SS3 catalyzed pyrite, pyrite/arsenopyrite, and chalcopyrite concentrate leaching. The rates were lower at 5 degrees C than at 30 degrees C, despite that all the available iron was in the oxidized form in the presence of At. ferrooxidans SS3. This suggests that although efficient At. ferrooxidans SS3 mediated biological oxidation of ferrous iron occurred, chemical oxidation of the sulfide minerals by ferric iron was rate limiting. In the column reactors, the leaching rates were much less affected by low temperatures than in the stirred tank reactors. A factor for the relatively high rates of mineral oxidation at 7 degrees C is that ferric iron remained in the soluble phase whereas, at 21 degrees C the ferric iron precipitated. Temperature gradient analysis of ferrous iron oxidation by this enrichment culture demonstrated two temperature optima for ferrous iron oxidation and that the mixed culture was capable of ferrous iron oxidation at 5 degrees C.
Microbial fuel cell (MFC) is a generally considered to be a sustainable new technology converting... more Microbial fuel cell (MFC) is a generally considered to be a sustainable new technology converting to electricity the chemical energy in organic compounds. MFC consists of two components with anode and cathode chambers. In the anodic chamber, electrons and protons are generated due to the anaerobic oxidation of organics (1, 2). New studies about a novel reactor design, selection of a suitable membrane and anode/cathode materials are needed to perform for an utilizable electricity generation from wastewater (2). The studies have shown that there are varieties of factors that can affect the overall performance of an MFC, such as fouling on the membrane surface and membrane pores (3). Because, there is an interaction between the environmental and membrane during experimental has always been a problem. These interactions affect the physical and chemical structure properties of membranes. In order to develop new membranes or improve the existing ones, their physical and mechanical charact...
This study aims at evaluating the performance of a two-chambered continuously fed microbial fuel ... more This study aims at evaluating the performance of a two-chambered continuously fed microbial fuel cell with new Ti-TiO₂ electrodes for bioelectricity generation from young landfill leachate at varying strength of wastewater (1-50 COD g/L) and hydraulic retention time (HRT, 0.25-2 days). The COD removal efficiency in the MFC increased with time and reached 45 % at full-strength leachate (50 g/L COD) feeding. The current generation increased with increasing leachate strength and decreasing HRT up to organic loading rate of 100 g COD/L/day. The maximum current density throughout the study was 11 A/m² at HRT of 0.5 day and organic loading rate of 67 g COD/L/day. Coulombic efficiency (CE) decreased from 57 % at feed COD concentration of 1 g/L to less than 1 % when feed COD concentration was 50 g/L. Increase in OLR resulted in increase in power output but decrease in CE.
The purpose of the study was to characterize ferric iron precipitates formed in batch experiments... more The purpose of the study was to characterize ferric iron precipitates formed in batch experiments over a temperature range of 2 to 40°C from ferric sulfate and mineral salts in sulfuric acid. With the exception of elevated levels of K+ to promote jarosite [KFe3(SO4)2(OH)6] formation, the solution composition was intended to simulate fully oxidized bioleaching solutions. Iron-oxidizing acidophilic bacteria were
Main objective of this study was to develop a statistical model for easier and faster Biochemical... more Main objective of this study was to develop a statistical model for easier and faster Biochemical Methane Potential (BMP) prediction of landfilled municipal solid waste by analyzing waste composition of excavated samples from 12 sampling points and three waste depths representing different landfilling ages of closed and active sections of a sanitary landfill site located in İstanbul, Turkey. Results of Principal Component Analysis (PCA) were used as a decision support tool to evaluation and describe the waste composition variables. Four principal component were extracted describing 76% of data set variance. The most effective components were determined as PCB, PO, T, D, W, FM, moisture and BMP for the data set. Multiple Linear Regression (MLR) models were built by original compositional data and transformed data to determine differences. It was observed that even residual plots were better for transformed data the R(2) and Adjusted R(2) values were not improved significantly. The best preliminary BMP prediction models consisted of D, W, T and FM waste fractions for both versions of regressions. Adjusted R(2) values of the raw and transformed models were determined as 0.69 and 0.57, respectively.
ABSTRACT Microbial Fuel Cells (MFC) are used to produce electricity while simultaneously treating... more ABSTRACT Microbial Fuel Cells (MFC) are used to produce electricity while simultaneously treating wastewater. This novel technology use bacteria to convert organic waste material into electrical energy through catabolic reactions of microorganisms under anaerobic conditions. In this study, wastewater treatment and production of electricity using different substrates is summarized in dual-chambered MFC.
The applicability of a fluidized-bed reactor (FBR)-based sulfate reducing bioprocess was investig... more The applicability of a fluidized-bed reactor (FBR)-based sulfate reducing bioprocess was investigated for the treatment of iron-containing (40-90 mg/L) acidic wastewater at low (8 degrees C) and high (65 degrees C) temperatures. The FBRs operated at low and high temperatures were inoculated with cultures of sulfate-reducing bacteria (SRB) originally enriched from arctic and hot mining environments, respectively. Ethanol was supplemented as carbon and electron source for SRB. At 8 degrees C, ethanol oxidation and sulfate reduction rates increased steadily and reached 320 and 265 mg/L.day, respectively, after 1 month of operation. After this point, the rates did not change significantly during 130 days of operation. Despite the complete ethanol oxidation and iron precipitation, the average sulfate reduction efficiency was 35 +/- 4% between days 30 and 130 due to the accumulation of acetate. At 65 degrees C, a rapid startup was observed as 99.9, 46, and 29% ethanol, sulfate, acetate removals, in respective order, were observed after 6 days. The feed pH was decreased gradually from its initial value of 6 to around 3.7 during 100 days of operation. The wastewater pH of 4.3-4.4 was neutralized by the alkalinity produced in acetate oxidation and the average effluent pH was 7.8 +/- 0.8. As in the low temperature FBR, acetate accumulated. Hence, the oxidation of acetate is the rate-limiting step in the sulfidogenic ethanol oxidation by thermophilic and psychrotrophic SRB. The sulfate reduction rate is three times and acetate oxidation rate is four times higher at 65 degrees C than at 8 degrees C.
An enrichment culture from a boreal sulfide mine environment containing a low-grade polymetallic ... more An enrichment culture from a boreal sulfide mine environment containing a low-grade polymetallic ore was tested in column bioreactors for simulation of low temperature heap leaching. PCR-denaturing gradient gel electrophoresis and 16S rRNA gene sequencing revealed the enrichment culture contained an Acidithiobacillus ferrooxidans strain with high 16S rRNA gene similarity to the psychrotolerant strain SS3 and a mesophilic Leptospirillum ferrooxidans strain. As the mixed culture contained a strain that was within a clade with SS3, we used the SS3 pure culture to compare leaching rates with the At. ferrooxidans type strain in stirred tank reactors for mineral sulfide dissolution at various temperatures. The psychrotolerant strain SS3 catalyzed pyrite, pyrite/arsenopyrite, and chalcopyrite concentrate leaching. The rates were lower at 5 degrees C than at 30 degrees C, despite that all the available iron was in the oxidized form in the presence of At. ferrooxidans SS3. This suggests that although efficient At. ferrooxidans SS3 mediated biological oxidation of ferrous iron occurred, chemical oxidation of the sulfide minerals by ferric iron was rate limiting. In the column reactors, the leaching rates were much less affected by low temperatures than in the stirred tank reactors. A factor for the relatively high rates of mineral oxidation at 7 degrees C is that ferric iron remained in the soluble phase whereas, at 21 degrees C the ferric iron precipitated. Temperature gradient analysis of ferrous iron oxidation by this enrichment culture demonstrated two temperature optima for ferrous iron oxidation and that the mixed culture was capable of ferrous iron oxidation at 5 degrees C.
Microbial fuel cell (MFC) is a generally considered to be a sustainable new technology converting... more Microbial fuel cell (MFC) is a generally considered to be a sustainable new technology converting to electricity the chemical energy in organic compounds. MFC consists of two components with anode and cathode chambers. In the anodic chamber, electrons and protons are generated due to the anaerobic oxidation of organics (1, 2). New studies about a novel reactor design, selection of a suitable membrane and anode/cathode materials are needed to perform for an utilizable electricity generation from wastewater (2). The studies have shown that there are varieties of factors that can affect the overall performance of an MFC, such as fouling on the membrane surface and membrane pores (3). Because, there is an interaction between the environmental and membrane during experimental has always been a problem. These interactions affect the physical and chemical structure properties of membranes. In order to develop new membranes or improve the existing ones, their physical and mechanical charact...
Uploads
Papers by Bestamin Ozkaya