A Scalable Cryogenic LED Module for Selectively Illuminating Kinetic Inductance Detector Arrays
Authors:
Jordan E. Shroyer,
Matt Nelson,
Liam Walters,
Bradley R. Johnson
Abstract:
We present the design and measured performance of a light emitting diode (LED) module for spatially mapping kinetic inductance detector (KID) arrays in the laboratory. Our novel approach uses a multiplexing scheme that only requires seven wires to control 480 red LEDs, and the number of LEDs can be scaled up without adding any additional wires. This multiplexing approach relies on active surface m…
▽ More
We present the design and measured performance of a light emitting diode (LED) module for spatially mapping kinetic inductance detector (KID) arrays in the laboratory. Our novel approach uses a multiplexing scheme that only requires seven wires to control 480 red LEDs, and the number of LEDs can be scaled up without adding any additional wires. This multiplexing approach relies on active surface mount components that can operate at cryogenic temperatures down to 10 K. Cryogenic tests in liquid nitrogen and inside our cryostat demonstrate that the multiplexer circuit works at 77 and 10 K, respectively. The LED module presented here is tailored for our millimeter-wave detector modules, but the approach could be adapted for use with other KID-based detector systems.
△ Less
Submitted 11 January, 2023; v1 submitted 20 June, 2022;
originally announced June 2022.
The Simons Observatory: Design and Measured Performance of a Carbon Fiber Strut for a Cryogenic Truss
Authors:
Kevin D. Crowley,
Peter Dow,
Jordan E. Shroyer,
John C. Groh,
Bradley Dober,
Jacob Spisak,
Nicholas Galitzki,
Tanay Bhandarkar,
Mark J. Devlin,
Simon Dicker,
Patricio A. Gallardo,
Kathleen Harrington,
Bradley R. Johnson,
Delwin Johnson,
Anna M. Kofman,
Akito Kusaka,
Adrian Lee,
Michele Limon,
Jeffrey Iuliano,
Federico Nati,
John Orlowski-Scherer,
Lyman Page,
Michael Randall,
Grant Teply,
Tran Tsan
, et al. (3 additional authors not shown)
Abstract:
We present the design and measured performance of a new carbon fiber strut design that is used in a cryogenically cooled truss for the Simons Observatory Small Aperture Telescope (SAT). The truss consists of two aluminum 6061 rings separated by 24 struts. Each strut consists of a central carbon fiber tube fitted with two aluminum end caps. We tested the performance of the strut and truss by (i) cr…
▽ More
We present the design and measured performance of a new carbon fiber strut design that is used in a cryogenically cooled truss for the Simons Observatory Small Aperture Telescope (SAT). The truss consists of two aluminum 6061 rings separated by 24 struts. Each strut consists of a central carbon fiber tube fitted with two aluminum end caps. We tested the performance of the strut and truss by (i) cryogenically cycling and destructively pull-testing strut samples, (ii) non-destructively pull-testing the final truss, and (iii) measuring the thermal conductivity of the carbon fiber tubes. We found that the strut strength is limited by the mounting fasteners and the strut end caps, not the epoxy adhesive or the carbon fiber tube. This result is consistent with our numerical predictions. Our thermal measurements suggest that the conductive heat load through the struts (from 4 K to 1 K) will be less than 1 mW. This strut design may be a promising candidate for use in other cryogenic support structures.
△ Less
Submitted 18 January, 2022; v1 submitted 16 January, 2022;
originally announced January 2022.