| Age | Commit message (Collapse) | Author |
|---|
|
Backpatch-through: 13
|
|
Reported-by: Michael Paquier
Discussion: https://postgr.es/m/ZZKTDPxBBMt3C0J9@paquier.xyz
Backpatch-through: 12
|
|
Currently, for large transactions, the publisher sends the data in
multiple streams (changes divided into chunks depending upon
logical_decoding_work_mem), and then on the subscriber-side, the apply
worker writes the changes into temporary files and once it receives the
commit, it reads from those files and applies the entire transaction. To
improve the performance of such transactions, we can instead allow them to
be applied via parallel workers.
In this approach, we assign a new parallel apply worker (if available) as
soon as the xact's first stream is received and the leader apply worker
will send changes to this new worker via shared memory. The parallel apply
worker will directly apply the change instead of writing it to temporary
files. However, if the leader apply worker times out while attempting to
send a message to the parallel apply worker, it will switch to
"partial serialize" mode - in this mode, the leader serializes all
remaining changes to a file and notifies the parallel apply workers to
read and apply them at the end of the transaction. We use a non-blocking
way to send the messages from the leader apply worker to the parallel
apply to avoid deadlocks. We keep this parallel apply assigned till the
transaction commit is received and also wait for the worker to finish at
commit. This preserves commit ordering and avoid writing to and reading
from files in most cases. We still need to spill if there is no worker
available.
This patch also extends the SUBSCRIPTION 'streaming' parameter so that the
user can control whether to apply the streaming transaction in a parallel
apply worker or spill the change to disk. The user can set the streaming
parameter to 'on/off', or 'parallel'. The parameter value 'parallel' means
the streaming will be applied via a parallel apply worker, if available.
The parameter value 'on' means the streaming transaction will be spilled
to disk. The default value is 'off' (same as current behaviour).
In addition, the patch extends the logical replication STREAM_ABORT
message so that abort_lsn and abort_time can also be sent which can be
used to update the replication origin in parallel apply worker when the
streaming transaction is aborted. Because this message extension is needed
to support parallel streaming, parallel streaming is not supported for
publications on servers < PG16.
Author: Hou Zhijie, Wang wei, Amit Kapila with design inputs from Sawada Masahiko
Reviewed-by: Sawada Masahiko, Peter Smith, Dilip Kumar, Shi yu, Kuroda Hayato, Shveta Mallik
Discussion: https://postgr.es/m/CAA4eK1+wyN6zpaHUkCLorEWNx75MG0xhMwcFhvjqm2KURZEAGw@mail.gmail.com
|
|
Backpatch-through: 11
|
|
Backpatch-through: 10
|
|
Recently-added references to ParseState weren't covered by #include
references, creating unwanted ordering dependencies for users of
these headers.
Oversight in commit 2bfb50b3d. Per headerscheck/cpluspluscheck.
|
|
When reporting "conflicting or redundant options" errors, try to
ensure that errposition() is used, to help the user identify the
offending option.
Formerly, errposition() was invoked in less than 60% of cases. This
patch raises that to over 90%, but there remain a few places where the
ParseState is not readily available. Using errdetail() might improve
the error in such cases, but that is left as a task for the future.
Additionally, since this error is thrown from over 100 places in the
codebase, introduce a dedicated function to throw it, reducing code
duplication.
Extracted from a slightly larger patch by Vignesh C. Reviewed by
Bharath Rupireddy, Alvaro Herrera, Dilip Kumar, Hou Zhijie, Peter
Smith, Daniel Gustafsson, Julien Rouhaud and me.
Discussion: https://postgr.es/m/CALDaNm33FFSS5tVyvmkoK2cCMuDVxcui=gFrjti9ROfynqSAGA@mail.gmail.com
|
|
For the initial table data synchronization in logical replication, we use
a single transaction to copy the entire table and then synchronize the
position in the stream with the main apply worker.
There are multiple downsides of this approach: (a) We have to perform the
entire copy operation again if there is any error (network breakdown,
error in the database operation, etc.) while we synchronize the WAL
position between tablesync worker and apply worker; this will be onerous
especially for large copies, (b) Using a single transaction in the
synchronization-phase (where we can receive WAL from multiple
transactions) will have the risk of exceeding the CID limit, (c) The slot
will hold the WAL till the entire sync is complete because we never commit
till the end.
This patch solves all the above downsides by allowing multiple
transactions during the tablesync phase. The initial copy is done in a
single transaction and after that, we commit each transaction as we
receive. To allow recovery after any error or crash, we use a permanent
slot and origin to track the progress. The slot and origin will be removed
once we finish the synchronization of the table. We also remove slot and
origin of tablesync workers if the user performs DROP SUBSCRIPTION .. or
ALTER SUBSCRIPTION .. REFERESH and some of the table syncs are still not
finished.
The commands ALTER SUBSCRIPTION ... REFRESH PUBLICATION and
ALTER SUBSCRIPTION ... SET PUBLICATION ... with refresh option as true
cannot be executed inside a transaction block because they can now drop
the slots for which we have no provision to rollback.
This will also open up the path for logical replication of 2PC
transactions on the subscriber side. Previously, we can't do that because
of the requirement of maintaining a single transaction in tablesync
workers.
Bump catalog version due to change of state in the catalog
(pg_subscription_rel).
Author: Peter Smith, Amit Kapila, and Takamichi Osumi
Reviewed-by: Ajin Cherian, Petr Jelinek, Hou Zhijie and Amit Kapila
Discussion: https://postgr.es/m/CAA4eK1KHJxaZS-fod-0fey=0tq3=Gkn4ho=8N4-5HWiCfu0H1A@mail.gmail.com
|
|
Backpatch-through: 9.5
|
|
Backpatch-through: update all files in master, backpatch legal files through 9.4
|
|
Switch to 2.1 version of pg_bsd_indent. This formats
multiline function declarations "correctly", that is with
additional lines of parameter declarations indented to match
where the first line's left parenthesis is.
Discussion: https://postgr.es/m/CAEepm=0P3FeTXRcU5B2W3jv3PgRVZ-kGUXLGfd42FFhUROO3ug@mail.gmail.com
|
|
Backpatch-through: certain files through 9.4
|
|
Backpatch-through: certain files through 9.3
|
|
Change pg_bsd_indent to follow upstream rules for placement of comments
to the right of code, and remove pgindent hack that caused comments
following #endif to not obey the general rule.
Commit e3860ffa4dd0dad0dd9eea4be9cc1412373a8c89 wasn't actually using
the published version of pg_bsd_indent, but a hacked-up version that
tried to minimize the amount of movement of comments to the right of
code. The situation of interest is where such a comment has to be
moved to the right of its default placement at column 33 because there's
code there. BSD indent has always moved right in units of tab stops
in such cases --- but in the previous incarnation, indent was working
in 8-space tab stops, while now it knows we use 4-space tabs. So the
net result is that in about half the cases, such comments are placed
one tab stop left of before. This is better all around: it leaves
more room on the line for comment text, and it means that in such
cases the comment uniformly starts at the next 4-space tab stop after
the code, rather than sometimes one and sometimes two tabs after.
Also, ensure that comments following #endif are indented the same
as comments following other preprocessor commands such as #else.
That inconsistency turns out to have been self-inflicted damage
from a poorly-thought-through post-indent "fixup" in pgindent.
This patch is much less interesting than the first round of indent
changes, but also bulkier, so I thought it best to separate the effects.
Discussion: https://postgr.es/m/E1dAmxK-0006EE-1r@gemulon.postgresql.org
Discussion: https://postgr.es/m/30527.1495162840@sss.pgh.pa.us
|
|
perltidy run not included.
|
|
Disallow CREATE SUBSCRIPTION and DROP SUBSCRIPTION in a transaction
block when the replication slot is to be created or dropped, since that
cannot be rolled back.
based on patch by Masahiko Sawada <sawada.mshk@gmail.com>
|
|
|
|
|
|
- Add PUBLICATION catalogs and DDL
- Add SUBSCRIPTION catalog and DDL
- Define logical replication protocol and output plugin
- Add logical replication workers
From: Petr Jelinek <petr@2ndquadrant.com>
Reviewed-by: Steve Singer <steve@ssinger.info>
Reviewed-by: Andres Freund <andres@anarazel.de>
Reviewed-by: Erik Rijkers <er@xs4all.nl>
Reviewed-by: Peter Eisentraut <peter.eisentraut@2ndquadrant.com>
|
