The influence of in situ etching of Si-face n-4H-SiC wafers in H2 and propane on the surface morp... more The influence of in situ etching of Si-face n-4H-SiC wafers in H2 and propane on the surface morphology of the grown epi-layers were examined using differential interference contrast (DIC) optical microscopy and atomic force microscope (AFM). Two defect-selective etching techniques were applied in order to reveal the type and spatial distribution of defects in the substrates and epi-layers. It was found that for the flow applied in this experiment propane plays a significant role for the etching process. Depending on temperature and etching time we obtained completely different picture of substrate surface morphology. The propane etching was verified as a tool for substrate surface improvement.
A good selection of growth parameters (in-situ etching, C/Si ratio, growth rate) enables obtainin... more A good selection of growth parameters (in-situ etching, C/Si ratio, growth rate) enables obtaining of ~1nm high steps of epitaxial layers, which are comparable to the size of an elementary cell (8°off-axis) and achieve the density of BPD=8•103/cm2. Due to crystallization on substrates with low misorientation (<2°off-axis) it is possible to obtain epitaxial layers substantially lacking in BPD dislocations. However, a slightly more developed surface with Ra=1-2.5nm (1.25°, 2°off-axis) characterizes these layers. By lowering the C/Si ratio, morphology of layers crystallized on substrates with low misorientation was improved. Extending growth rate improved both the crystallographic quality of the grown layers and their polytype stability. Nevertheless, growth without BPDs, also referred to as the homogeneous (4H) polytypic growth on 4H-SiC on-axis substrates, is the most efficient way of defect elimination.
The electron backscatter diffraction (EBSD) detector placed inside a commercial scanning electron... more The electron backscatter diffraction (EBSD) detector placed inside a commercial scanning electron microscope (SEM) has been used to study of different SiC polytypes. Different growth conditions in chemical vapor deposition (CVD) method were applied to obtain the 3C- and 4H-SiC polytypes epitaxial layers. Growth processes were conducted on the Si-face on-axis 4H-SiC substrates. The growth temperature was in the range of 1300-1620°C and the reactor pressure was 75mbar. The initial C/Si ratio was varied from 0.075 reaching final value of 1.8. It was observed that intentional ramping of the C/Si ratio at the first stage of the growth clearly influences the 4H/3C factor. The growth temperature and ramping of the C/Si ratio were the main parameters to achieve a homogeneous 3C and 4H-SiC epitaxial layers.
The so-called “growth” of graphene was performed using a horizontal chemical vapor deposition (CV... more The so-called “growth” of graphene was performed using a horizontal chemical vapor deposition (CVD) hot-wall reactor. In-situ etching in the mixture (H2-C3H8) was performed prior to growth at 1600oC temperature under 100 mbar. Systematic studies of the influence of the decomposition temperature and time, substrates roughness, etching of the substrates, heating rate, SiC dezorientation and other process parameters on the graphene thickness and quality have been conducted. Morphology and atomic scale structure of graphene was examined by Scanning Tunnelling Microscopy (STM), Transmission Electron Microscopy (TEM) and Raman scattering methods.
The paper provides a deeper understanding of key-parameters of epitaxial graphene growth techniqu... more The paper provides a deeper understanding of key-parameters of epitaxial graphene growth techniques on SiC. At 16000C, the graphene layer is continuous and covers a large area of the substrate. Significant differences in the growth rate could be observed for different reactor pressures and the polarity of SiC substrates as well as for the substrate miscut and surface quality. In addition, graphene thickness uniformity and mechanism of ridges creation was examined.
4H-SiC single crystals grown by the seeded physical vapour transport method have been investigate... more 4H-SiC single crystals grown by the seeded physical vapour transport method have been investigated. These crystals were grown on 6H-SiC seeds. The influence of the seed temperature, form and granulation of SiC source materials on the stability and efficiency of the 4H polytype growth have been investigated. A new way of the seed mounting - with an open backside - has been used. Crystals obtained were free of structural defects in the form of hexagonal voids. The crystalline structure of SiC crystals was investigated by EBSD (Electron Backscatter Diffraction) and X-Ray diffraction methods. Moreover, defects in crystals and wafers cut from these crystals were examined by optical, scanning electron and atomic force microscopy combined with KOH etching.
In this work results of nitrogen doping in the amount of 0 vol.%, 3 vol.% and 10 vol.% on the gro... more In this work results of nitrogen doping in the amount of 0 vol.%, 3 vol.% and 10 vol.% on the growth of the 4H polytype on the 6H-SiC seed are presented. SiC crystals grown by PVT method on the (000-1) C-face of 6H seeds using the open seed backside design have been investigated. Structural and electrical properties of the crystals were studied by different experimental methods.
Results of vanadium doping in PVT SiC bulk growth by the use of the seeding technique with an ope... more Results of vanadium doping in PVT SiC bulk growth by the use of the seeding technique with an open seed backside are shown. Structural and electrical properties of 4H and 6H-SiC:V were investigated by a variety of experimental methods. In the crystal studied, the solubility limit of V in SiC was exceeded and structural defects consisting of V-rich precipitates occured. Electrical properties of this crystal were determined by the V3+/V4+ acceptor level. The V3+ charge state of vanadium was formed by compensating shallow donors (mainly nitrogen) and for both 4H and 6H polytypes it was detectable in optical absorption (in the near-IR range) and electron paramagnetic resonance.
In this work we present the growth of 4H-SiC crystals (2 inch in diameter) on the 8° off- axis C-... more In this work we present the growth of 4H-SiC crystals (2 inch in diameter) on the 8° off- axis C-face 6H-SiC seeds, inclined toward [11-20] direction. The growth of crystals by physical vapour transport method (PVT) was realized with the open seed backside in the experimental setup with graphite resistive heater. Some of the crystals were doped with cerium in the purpose of the 4H polytype growth stabilization. For Ce-doped crystals the seed backside carbonization process was decreased in comparison with such effect observed in the undoped SiC crystals.
The influence of in situ etching of Si-face n-4H-SiC wafers in H2 and propane on the surface morp... more The influence of in situ etching of Si-face n-4H-SiC wafers in H2 and propane on the surface morphology of the grown epi-layers were examined using differential interference contrast (DIC) optical microscopy and atomic force microscope (AFM). Two defect-selective etching techniques were applied in order to reveal the type and spatial distribution of defects in the substrates and epi-layers. It was found that for the flow applied in this experiment propane plays a significant role for the etching process. Depending on temperature and etching time we obtained completely different picture of substrate surface morphology. The propane etching was verified as a tool for substrate surface improvement.
A good selection of growth parameters (in-situ etching, C/Si ratio, growth rate) enables obtainin... more A good selection of growth parameters (in-situ etching, C/Si ratio, growth rate) enables obtaining of ~1nm high steps of epitaxial layers, which are comparable to the size of an elementary cell (8°off-axis) and achieve the density of BPD=8•103/cm2. Due to crystallization on substrates with low misorientation (<2°off-axis) it is possible to obtain epitaxial layers substantially lacking in BPD dislocations. However, a slightly more developed surface with Ra=1-2.5nm (1.25°, 2°off-axis) characterizes these layers. By lowering the C/Si ratio, morphology of layers crystallized on substrates with low misorientation was improved. Extending growth rate improved both the crystallographic quality of the grown layers and their polytype stability. Nevertheless, growth without BPDs, also referred to as the homogeneous (4H) polytypic growth on 4H-SiC on-axis substrates, is the most efficient way of defect elimination.
The electron backscatter diffraction (EBSD) detector placed inside a commercial scanning electron... more The electron backscatter diffraction (EBSD) detector placed inside a commercial scanning electron microscope (SEM) has been used to study of different SiC polytypes. Different growth conditions in chemical vapor deposition (CVD) method were applied to obtain the 3C- and 4H-SiC polytypes epitaxial layers. Growth processes were conducted on the Si-face on-axis 4H-SiC substrates. The growth temperature was in the range of 1300-1620°C and the reactor pressure was 75mbar. The initial C/Si ratio was varied from 0.075 reaching final value of 1.8. It was observed that intentional ramping of the C/Si ratio at the first stage of the growth clearly influences the 4H/3C factor. The growth temperature and ramping of the C/Si ratio were the main parameters to achieve a homogeneous 3C and 4H-SiC epitaxial layers.
The so-called “growth” of graphene was performed using a horizontal chemical vapor deposition (CV... more The so-called “growth” of graphene was performed using a horizontal chemical vapor deposition (CVD) hot-wall reactor. In-situ etching in the mixture (H2-C3H8) was performed prior to growth at 1600oC temperature under 100 mbar. Systematic studies of the influence of the decomposition temperature and time, substrates roughness, etching of the substrates, heating rate, SiC dezorientation and other process parameters on the graphene thickness and quality have been conducted. Morphology and atomic scale structure of graphene was examined by Scanning Tunnelling Microscopy (STM), Transmission Electron Microscopy (TEM) and Raman scattering methods.
The paper provides a deeper understanding of key-parameters of epitaxial graphene growth techniqu... more The paper provides a deeper understanding of key-parameters of epitaxial graphene growth techniques on SiC. At 16000C, the graphene layer is continuous and covers a large area of the substrate. Significant differences in the growth rate could be observed for different reactor pressures and the polarity of SiC substrates as well as for the substrate miscut and surface quality. In addition, graphene thickness uniformity and mechanism of ridges creation was examined.
4H-SiC single crystals grown by the seeded physical vapour transport method have been investigate... more 4H-SiC single crystals grown by the seeded physical vapour transport method have been investigated. These crystals were grown on 6H-SiC seeds. The influence of the seed temperature, form and granulation of SiC source materials on the stability and efficiency of the 4H polytype growth have been investigated. A new way of the seed mounting - with an open backside - has been used. Crystals obtained were free of structural defects in the form of hexagonal voids. The crystalline structure of SiC crystals was investigated by EBSD (Electron Backscatter Diffraction) and X-Ray diffraction methods. Moreover, defects in crystals and wafers cut from these crystals were examined by optical, scanning electron and atomic force microscopy combined with KOH etching.
In this work results of nitrogen doping in the amount of 0 vol.%, 3 vol.% and 10 vol.% on the gro... more In this work results of nitrogen doping in the amount of 0 vol.%, 3 vol.% and 10 vol.% on the growth of the 4H polytype on the 6H-SiC seed are presented. SiC crystals grown by PVT method on the (000-1) C-face of 6H seeds using the open seed backside design have been investigated. Structural and electrical properties of the crystals were studied by different experimental methods.
Results of vanadium doping in PVT SiC bulk growth by the use of the seeding technique with an ope... more Results of vanadium doping in PVT SiC bulk growth by the use of the seeding technique with an open seed backside are shown. Structural and electrical properties of 4H and 6H-SiC:V were investigated by a variety of experimental methods. In the crystal studied, the solubility limit of V in SiC was exceeded and structural defects consisting of V-rich precipitates occured. Electrical properties of this crystal were determined by the V3+/V4+ acceptor level. The V3+ charge state of vanadium was formed by compensating shallow donors (mainly nitrogen) and for both 4H and 6H polytypes it was detectable in optical absorption (in the near-IR range) and electron paramagnetic resonance.
In this work we present the growth of 4H-SiC crystals (2 inch in diameter) on the 8° off- axis C-... more In this work we present the growth of 4H-SiC crystals (2 inch in diameter) on the 8° off- axis C-face 6H-SiC seeds, inclined toward [11-20] direction. The growth of crystals by physical vapour transport method (PVT) was realized with the open seed backside in the experimental setup with graphite resistive heater. Some of the crystals were doped with cerium in the purpose of the 4H polytype growth stabilization. For Ce-doped crystals the seed backside carbonization process was decreased in comparison with such effect observed in the undoped SiC crystals.
Uploads