P-150 Mandibular reconstruction after segmental mandibulectomy: our experience and new perspectives

The fibular free flap is the gold standard for mandibular reconstruction. Accurate 3-dimensional contouring and precise alignment of the fibula is critical for reestablishing native occlusion and facial symmetry. Following segmental mandibulectomy, the remaining mandibular fragments become freely mobile. Various stabilization methods including external fixation, intermaxillary fixation, and preplating with reconstruction plate have been used. We describe a modification to the preplating technique. After wide resection of buccal squamous cell carcinoma, our patient had an 11-cm mandibular defect from the angle of the left mandible to the right midparasymphyseal region. A single 2.0-mm Unilock® (Synthes, Singapore) plate was used to span the defect. This was placed on the vestibular aspect of the superior border of the mandibular remnants before resection. Segmental mandibulectomy was then performed with the plate removed. The spanning plate was then reattached to provide rigid fixation. The fibular bone was contoured with a single osteotomy and reattached. The conventional technique involves molding of the plate at the inferior border of the mandible. This is time-consuming and not possible in patients with distorted mandibular contour. It is also difficult to fit the osteotomized fibula to the contoured plate. In comparison, the superiorly positioned spanning plate achieve rigid fixation of the mandible while leaving the defect completely free and unhampered by hardware, allowing space for planning osteotomies and easier fixation of the neomandible. Using this modified technique, we are able to recreate the original mandibular profile with ease.

A particulate cancellous bone and marrow (PCBM) graft combined with titanium (Ti-) mesh tray has become one of the most popular mandibular reconstruction methods. The technique has been applied to the mandibular discontinuity defects after segmental mandibulectomy. To the best of our knowledge, there are no reports on using the technique after hemimandibulectomy, during which a wide mandibular resection, including the condyle, is performed. Here we report firstly a case of mandibular reconstruction after hemimandibulectomy, using a plate and soft-tissue free flap, followed by a Ti-mesh and PCBM harvested from the bilateral posterior ilia, which was successful. This case report first revealed how bone resorption occurred clinically in mandibular reconstruction using PCBM and Ti-mesh tray after hemimandibulectomy. We also revealed the high predictability of the mandibular reconstruction using PCBM and Ti-mesh tray after hemimandibulectomy. Our report also provides a guiding principle to overcome the limitation of mandibular reconstruction using PCBM and Ti-mesh tray after hemimandibulectomy. However, our manuscript has limited evidence being a case report.