transmission network
Recently Published Documents

The law of free access to the transmission network obliges the transmission network to be in orbit, and on the other hand, the high loads in the transmission network, and economic uncertainties cause that the owners of transmission companies, don’t have sufficient motivation and resources to rebuild and develop the network. The main objective of this paper is the modeling the price of emergency power transmission lines in the reserve markets. This paper presents a method for calculating the reference price that a transmission line owner uses to bid on a price in excess of the nominal capacity of the transmission line under his ownership. For this purpose, first, the effects of operating a transmission line at a power greater than the rated power are described. After that, the reduction rate of the transmission line due to operation in these conditions is calculated, and finally the price determination is calculated based on the reduction rate of the generated life. In the next stage, this excess capacity is entered the two-stage model of energy market and reservation considering renewable energy sources as a price offer function. Numerical results of 6-Shin network show that the entry of renewable energy sources reduces energy costs, but the costs of the reserve market increases due to uncertainty. However, despite the emergency capacity, these costs are reduced due to the use of cheap resources in the network.

This article is devoted to the definition of the most important combinations of objects in critical network infrastructures. This study was carried out using the example of the Russian gas transmission network. Since natural gas is widely used in the energy sector, the gas transmission network can be exposed to terrorist threats, and the actions of intruders can be directed at both gas fields and gas pipelines. A defender–attacker model was proposed to simulate attacks. In this model, the defender solves the maximum flow problem to satisfy the needs of gas consumers. By excluding gas pipelines, the attacker tries to minimize the maximum flow in the gas transmission network. Russian and European gas transmission networks are territorially very extensive and have a significant number of mutual intersections and redundant pipelines. Therefore, one of the approaches to inflicting maximum damage on the system is modeled as an attack on a clique. A clique in this study is several interconnected objects. The article presents the list of the most interconnected sections of main gas pipelines, the failure of which can cause the greatest damage to the system in the form of a gas shortage among consumers. Conclusions were drawn about the applicability of the maximum clique method for identifying the most important objects in network critical infrastructures.

This paper presents a modeling and solution approach to the static and multistage transmission network expansion planning problem considering series capacitive compensation and active power losses. The transmission network expansion planning is formulated as a mixed integer nonlinear programming problem and solved through a highly efficient genetic algorithm. Furthermore, the Villasana Garver’s constructive heuristic algorithm is implemented to render the configurations of the genetic algorithm feasible. The installation of series capacitive compensation devices is carried out with the aim of modifying the reactance of the original circuit. The linearization of active power losses is done through piecewise linear functions. The proposed model was implemented in C++ language programming. To show the applicability and effectiveness of the proposed methodology several tests are performed on the 6-bus Garver system, the IEEE 24-bus test system, and the South Brazilian 46-bus test system, presenting costs reductions in their multi-stage expansion planning of 7.4%, 4.65% and 1.74%, respectively.

The feasibility of power transfer enhancement, through simultaneous AC–DC power transmission in a two-terminal transmission network, has been proposed earlier by the authors, and the concept is well established. To meet the increase in demand for electricity, a new technique is proposed in this article to increase the use of existing transmission lines in addition to independent control of AC and DC power flow. This paper extends the concept to a three-terminal transmission network by considering a power tapping from the middle of the line. DC is also superimposed in the already existing three-terminal AC transmission system. In the proposed topology, a multi-terminal simultaneous AC–DC system is used, which is integrated with a zig-zag transformer and more than two voltage source converter (VSC) stations. Each terminal may represent an area of the power system. Anyone/two-terminal(s) may act as sending end, whereas the remaining two/one terminal(s) may act as receiving end. Power can flow in either direction through each segment of the transmission system. At sending end, VSC converts a part of AC to DC and injects it into the neutral of the zig-zag transformer. On receiving terminal, DC power is tapped from neutral of zig-zag transformer and fed to VSC for conversion back to AC. The concept is verified in the digital simulation software PSCAD/EMTDC.

BACKGROUND The Surveillance Outbreak Response Management and Analysis System (SORMAS) contains a management module to support countries in epidemic response. It consists of documentation, linkage and follow-up of cases, contacts, and events. To allow SORMAS users to visualise, compute key surveillance indicators and estimate epidemiological parameters from such a network data in real time, we developed the SORMAS Statistics (SORMAS-Stats) application. OBJECTIVE The aim of this study is to describe the key visualisations, surveillance indicators and epidemiological parameters implemented in the SORMAS-Stats application, and illustrate the application of SORMAS-Stats to COVID-19 outbreak response. METHODS Based on literature review and user requests, we included the following visualisation and estimation of parameters in SORMAS-Stats: transmission network diagram, serial interval (SI), time-varying reproduction number (Rt), dispersion parameter (k) and additional surveillance indicators presented in graphs and tables. We estimated SI by fitting a lognormal, gamma, and Weibull distributions to the observed distribution of the number of days between symptoms onset dates of infector-infectee pairs. We estimated k by fitting a negative binomial distribution to the observed number of infectees per infector. We applied the Markov Chain Monte Carlo approach and estimated Rt using the incidence data and the observed SI data, computed from the transmission network data. RESULTS Using COVID-19 contact tracing data of confirmed cases reported between July 31, and October 29, 2021 in Bourgogne-Franche-Comté region of France, we constructed a network diagram containing 63570 nodes comprising 1.75% (1115/63570) events, 19.59% (12452/63570) case persons, and 78.66% (50003/63570) exposed persons, 1238 infector-infectee pairs, 3860 transmission chains with 24.69% (953/3860) having events as the index infector. The distribution with best fit to the observed SI data was lognormal distribution with mean 4.32 days (95% CI, 4.10–4.53 days). We estimated the dispersion parameter, k of 21.11 (95% CI, 7.57–34.66) and a reproductive number, R of 0.9 (95% CI, 0.58–0.60). The weekly estimated Rt values ranged from 0.80 to 1.61. CONCLUSIONS We provide an application for real-time estimation of epidemiological parameters, which are essential for informing outbreak response strategies. These estimates are commensurate with findings from previous studies. SORMAS-Stats application would greatly assist public health authorities in the regions using SORMAS or similar applications by providing extensive visualisations and computation of surveillance indicators.