elastically supported
Recently Published Documents

Abstract Slender cylindrical structures such as overhead transmission lines, skyscrapers, chimneys, risers, and pipelines can experience flow induced vibration (FIV). The vortex vibrations are a type of FIV; they arise because of oscillating forces caused by flow separation and the detachment of vortices. The paper presents a brief overview of experimental research on vortex induced vibration - VIV of short, rigid cylinders elastically supported (with a small aspect ratio). This overview summarizes the basic results of the vortex vibration (VIV) which have been performed in the last five decades. These studies were mainly related to determining the influence of selected parameters - mass, damping and Reynolds number on the cylinder response, either in one direction only or simultaneously in the flow direction and transverse to the flow direction, and with the search for a map of vortex images in the trace (vortex wake pattern map).

Abstract The aim of the research is to derive an analytical solution describing the vibrations of railway wagons caused by asymmetrical loading of cargo for prediction of dangerous conditions. A presumption for the dynamic analysis and assessment of the driving quality of railway vehicles is an important experimental determination and verification of the basic characteristics of the suspension respectively. A method for determining these characteristics for two-axle vehicles has been developed and applied. This method requires knowledge of the position of the center of gravity and the main central moments of inertia. Vehicle bodies, chassis frames, and wheelsets are assumed to be rigid bodies under the investigation of these characteristics. The characteristics of the springs are linear or can be linearized. The vehicle body performs a general spatial movement. The result of the investigation is an analytical method to obtain the required characteristics needed for the dynamic analysis of the vehicle.

Rolling waves have unconventional circular polarizations enabled by the equal-speed propagation of longitudinal and transverse waves in elastic solids. They can transport non-paraxial intrinsic (i.e. spin) mechanical angular momentum in the media. In this work, we analyze the rolling wave reflections and their effects on the non-paraxial spins in a cubic elastic half-space with an elastically supported boundary. Reflected waves from both normal and general oblique incidences are investigated. We show that, by adjusting the stiffness of the elastic boundary, we can precisely control the spin properties of the reflected waves, paving the way towards a broad category of spin manipulation techniques for bulk elastic waves.

Mechanical topological insulators have enabled a myriad of unprecedented characteristics that are otherwise not conceivable in traditional periodic structures. While rich in dynamics, new developments in the domain of mechanical topological systems are hindered by their inherent inability to exhibit negative elastic or inertial couplings owing to the inevitable loss of dynamical stability. The aim of this paper is, therefore, to remedy this challenge by introducing a class of architected inertial metamaterials (AIMs) as a platform for designing mechanical lattices with novel topological and dispersion traits. We show that carefully coupling elastically supported masses via moment-free rigid linkages invokes a dynamically stable negative inertial coupling, which is essential for topological classes in need of such negative interconnection. The potential of the proposed AIMs is demonstrated via three examples: (i) a mechanical analogue of Majorana edge states, (ii) a square diatomic AIM that can sustain the quantum valley Hall effect (classically arising in hexagonal lattices), and (iii) a square tetratomic AIM with topological corner modes. We envision that the presented framework will pave the way for a plethora of robust topological mechanical systems.