alkaline digestion
Recently Published Documents

Fluorine and chlorine are important tracers for geochemical and environmental studies. In this study, a rapid alkaline digestion (NaOH) method for the simultaneous determination of fluorine and chlorine in marine and stream sediment reference samples using ion chromatography is developed. The proposed method suppresses the volatilization loss of fluorine and chlorine and decreases the matrix effects. The results are in good agreement with fluorine ~100%, chlorine ranging from 90 to 95% of the expected concentrations. The detection limits of this method were 0.05 μg/g for fluorine and 0.10 μg/g for chlorine. This method is simple, economical, precise and accurate, which shows great potential for the rapid simultaneous determination of fluorine and chlorine in large batches of geological and environmental samples commonly analyzed for environmental geochemistry studies.

Abstract Regulation of hexavalent chromium is based on Waste Framework Directive 1994/62/EC, European Commission and publication of the World Health Organization. Herein, detection of hexavalent chromium was performed by alkaline digestion and instrumental analysis which was demonstrated in USEPA methods. However, UV-vis detection method could be affected by some metal ions reacted with diphenylcarbizide. Actually, various interfering elements, such as Ni, Fe, Al, and Cu, were detected and selected by ED-XRF in paper materials. In order to improve accuracy of analysis results of hexavalent chromium in paper materials based on USEPA methods, the interfering elements was removed by liquid–liquid extraction with carbonate media using tricaprylmethylammonium chloride and chloroform after alkaline digestion. Consequently, the temperature for alkaline digestion was between 85 and 95 °C. Hydrochloric acid was proper complex tricaprylmethylammonium-Cr(VI) in the procedure of liquid extraction. After that hexavalent chromium was completely extracted using of 1 M sodium hydroxide solution. The technique for analyzing the hexavalent chromium used in liquid–liquid extraction significantly reduced the errors caused by the interfering elements, Fe and Cu. Thus, application of the extraction method was efficient in removing the interfering elements, which increased the recovery ratio of the hexavalent chromium from paper materials by 90 %.

Phyllanthin and related lignans were found to be responsible, at least in part, for most of the activity of Phyllanthus species. This observation encouraged the authors to develop methods for the preparation of an extract rich in phyllanthin and related lignans from the aerial parts of P. niruri L. Direct extraction with solvents produced extracts with variable yields and contents of lignans. Lignans were identified by LC-ESI-MS analysis as phyllanthin (used as marker substance), hypophyllanthin, phylltetralin, nirtetralin, and niranthin. Extraction with boiling water produced 18.10 g% (w/w) extract with a trace amount of lignans (phyllanthin content of 0.33 ± 0.10 mg/g extract), while extraction with MeOH gave 3.6 g% w/w extract with a low phyllanthin content (3.1 mg/g extract), as determined by HPLC. However, Soxhlet extraction with hexane, CH2Cl2, or acetone gave extracts with low yields (0.82, 1.12, and 3.40 g% w/w, respectively) and a higher phyllanthin contents (36.2 ± 2.6, 11.7 ± 1.68, and 11.7 ± 1.10 mg/g extract, respectively). Extraction quality and efficiency were optimized by adopting the following three different approaches: (1) Alkaline digestion of the plant material with 30% potassium hydroxide yielded 3.1 g% w/w of purified extract with high phyllanthin content (22.34 ± 0.13 mg/g); (2) microwave-assisted extraction using 80% MeOH gave an extract with a better yield (8.13 g% w/w) and phyllanthin content (21.2 ± 1.30 mg/g) (after filtration through a Diaion HP-20 column); and (3) treatment of the ground plant material at 50 °C with two hydrolytic enzymes, cellulase (9 U/g for 12 h) and then, protease (4 U/g up to 72 h) optimized the yield of extract (13.92 g% w/w) and phyllanthin content (25.9 mg/g extract and total lignans content of 85.87 mg/g extract). In conclusion, the nonconventional methods presented here are superior for optimizing the yield of extract and its lignan contents from the aerial parts of P. niruri.