sagittal plane
Recently Published Documents

The present study was performed to investigate the validity of a wireless earbud-type inertial measurement unit (Ear-IMU) sensor used to estimate head angle during four workouts. In addition, relationships between head angle obtained from the Ear-IMU sensor and the angles of other joints determined with a 3D motion analysis system were investigated. The study population consisted of 20 active volunteers. The Ear-IMU sensor measured the head angle, while a 3D motion analysis system simultaneously measured the angles of the head, trunk, pelvis, hips, and knees during workouts. Comparison with the head angle measured using the 3D motion analysis system indicated that the validity of the Ear-IMU sensor was very strong or moderate in the sagittal and frontal planes. In addition, the trunk angle in the frontal plane showed a fair correlation with the head angle determined with the Ear-IMU sensor during a single-leg squat, reverse lunge, and standing hip abduction; the correlation was poor in the sagittal plane. Our results indicated that the Ear-IMU sensor can be used to directly estimate head motion and indirectly estimate trunk motion.

Abstract Background Filler injection for nose tip improvement remains a difficult subject due to efficacy and safety issues. Objectives To better the techniques and safety for nose tip improvement with a filler. Methods Patients seeking nose tip improvement were recruited regardless of their pre-treatment conditions. A hyaluronic acid filler is injected through the skin behind the nose tip into the potential septal space. To achieve tip elevation, the filler is retro injected from the anterior nasal spine, stopping at the mid-level of medial crura. To elongate the nose, the filler is deposited just in front of the caudal septal cartilage. The tip extends in the sagittal plane, causing the nose tip to move either caudally (tip elongation) or anteriorly (tip elevation), or both, as directed by the surgeon. Results Depending on the patients, the nose could be elongated by 2 to 6mm, and the tip could be elevated by 2 to 8 mm. Additionally, stronger columellar support, finer tip structures, and improved nasolabial angle are observed. Interestingly, the upper lip appears shorter. The nostril shapes and the alar widths are also improved. A total of 1288 cases are reported. Only two patients expressed dissatisfaction. Conclusions This technique is easy and safe to perform and, the results are natural and comparable to those from rhinoplasty surgeries. Further, this report of filler nose lengthening may be the first large series in the world. Finally, this technique works well in all populations.

Gait analysis is clinically relevant in persons with multiple sclerosis (PwMS) and consists of several joint angular displace-ment-time relationships and spatiotemporal parameters. However, it lacks representation by means of diagrams in which knee angle-hip angle and knee angle-ankle angle variations are plotted against each other at the same instants of time. Three-dimensional kinematic analysis was performed on 20 subjects (10 PwMS/10 healthy controls, HCs), and the knee-angle/hip-angle and knee-angle/ankle-angle diagrams of both lower limbs were determined in the sagittal plane while walking on a motorized treadmill. The area (a quantifier of conjoint range of motion) and the perimeter (a quantifier of coordina-tion) of angle-angle diagram loops were calculated. PwMS showed reduced knee-angle/ankle-angle loops compared to HCs (P<0.05, ES = 0.80), whereas the hip-angle/ankle-angle loops between the PwMS and HCs was not significant (P> 0.05). Similarly, the activation of leg muscles showed significant differences between PwMS and HCs (p ranged from 0.05-to 0.001; ES ranged from 1.30 to 1.89). The results indicate that the proposed knee-angle/hip-angle diagram is feasible and could be applied as a reliable tool in future studies aimed at assessing the acute and long-term effects of specific exercise programmes and/or pharmacological treatment in PwMS.

Background: The medial femoral trochlea (MFT) osteochondral flap is employed for reconstruction of unsalvageable scaphoid proximal pole nonunions. The convex surface of the cartilage-bearing proximal trochlea is used to replace the similarly contoured proximal scaphoid and articulate with the concave scaphoid fossa of the radius. A magnetic resonance imaging (MRI) comparison of the shape of the MFT as it relates to the native proximal scaphoid has not been previously performed. Our study aimed to quantifiably compare the shape of the MFT, proximal scaphoid, and scaphoid fossa. Methods: Using imaging processing software, we measured radius of curvature of the articular segments in MRI scans of 10 healthy subjects’ wrists and knees. Results: Compared with the scaphoid fossa, average ratio of the radius of circumference of the proximal scaphoid was 0.79 and 0.78 in the coronal and sagittal planes, respectively. Compared with the scaphoid fossa, average ratio of the radius of circumference of the MFT was 0.98 and 1.31 in the coronal and sagittal planes, respectively. The radius of curvature of the MFT was larger than the proximal scaphoid, in the coronal and sagittal planes. In the coronal plane, the MFT radius of curvature is nearly identical to the scaphoid fossa, a closer match than the scaphoid itself. In the sagittal plane, the radius of curvature of the MFT was larger than the radius of curvature of the scaphoid fossa. Conclusions: Our data suggest that the radius of curvature, in the sagittal and coronal planes, of the MFT and proximal scaphoid is disparate.

Deep learning models developed to predict knee joint kinematics are usually trained on inertial measurement unit (IMU) data from healthy people and only for the activity of walking. Yet, people with knee osteoarthritis have difficulties with other activities and there are a lack of studies using IMU training data from this population. Our objective was to conduct a proof-of-concept study to determine the feasibility of using IMU training data from people with knee osteoarthritis performing multiple clinically important activities to predict knee joint sagittal plane kinematics using a deep learning approach. We trained a bidirectional long short-term memory model on IMU data from 17 participants with knee osteoarthritis to estimate knee joint flexion kinematics for phases of walking, transitioning to and from a chair, and negotiating stairs. We tested two models, a double-leg model (four IMUs) and a single-leg model (two IMUs). The single-leg model demonstrated less prediction error compared to the double-leg model. Across the different activity phases, RMSE (SD) ranged from 7.04° (2.6) to 11.78° (6.04), MAE (SD) from 5.99° (2.34) to 10.37° (5.44), and Pearson’s R from 0.85 to 0.99 using leave-one-subject-out cross-validation. This study demonstrates the feasibility of using IMU training data from people who have knee osteoarthritis for the prediction of kinematics for multiple clinically relevant activities.

Introduction: En-bloc resection of a primary malignant sacral tumor with wide oncological margins impacts the biomechanics of the spinopelvic complex, deteriorating postoperative function. The closed-loop technique (CLT) for spinopelvic fixation (SPF) uses a single U-shaped rod to restore the spinopelvic biomechanical integrity. The CLT method was designed to provide a non-rigid fixation, however this hypothesis has not been previously tested. Here, we establish a computational method to measure the deformation of the implant and characterize the bony fusion process based on the 6-year follow-up (FU) data.Materials and Methods: Post-operative CT scans were collected of a male patient who underwent total sacrectomy at the age of 42 due to a chordoma. CLT was used to reconstruct the spinopelvic junction. We defined the 3D geometry of the implant construct. Using rigid registration algorithms, a common coordinate system was created for the CLT to measure and visualize the deformation of the construct during the FU. In order to demonstrate the cyclical loading of the construct, the patient underwent gait analysis at the 6th year FU. First, a region of interest (ROI) was selected at the proximal level of the construct, then the deformation was determined during the follow-up period. In order to investigate the fusion process, a single axial slice-based voxel finite element (FE) mesh was created. The Hounsfield values (HU) were determined, then using an empirical linear equation, bone mineral density (BMD) values were assigned for every mesh element, out of 10 color-coded categories (1st category = 0 g/cm3, 10th category 1.12 g/cm3).Results: Significant correlation was found between the number of days postoperatively and deformation in the sagittal plane, resulting in a forward bending tendency of the construct. Volume distributions were determined and visualized over time for the different BMD categories and it was found that the total volume of the elements in the highest BMD category in the first postoperative CT was 0.04 cm3, at the 2nd year, FU was 0.98 cm3, and after 6 years, it was 2.30 cm3.Conclusion: The CLT provides a non-rigid fixation. The quantification of implant deformation and bony fusion may help understate the complex lumbopelvic biomechanics after sacrectomy.

The braces of today are constructed to correct the frontal plane deformity of idiopathic adolescent scoliosis (AIS). The Spinaposture brace© (Spinaposture Aps, Copenhagen, Denmark) is a soft-fabric brace for AIS and is designed to enhance rotational axial stability by inducing a sagittal plane kyphotic correction. This prospective observational study evaluated the brace in fifteen patients with AIS. The initial average CA was 16.8° (SD: 2.8). They were followed prospectively every 3 to 6 months during their brace usage until skeletal maturity of 25 months and at long-term follow-up of 44 months. In- and out-of-brace radiographs were performed in six subjects at inclusion. This resulted in an immediate in-brace correction of 25.3 percent in CA (14.3°→10.8°) and induced a kyphotic effect of 14.9 percent (40.8°→47.9°). The average in-brace improvement at first follow-up was 4.5° in CA, and the CA at skeletal maturity was 11° (SD: 7.4°) and long-term 12.0° (SD: 6.8°). In conclusion, the Spinaposture brace© had an immediate in-brace deformity correction and a thoracic kyphotic effect. At skeletal maturity, the deformities improved more than expected when compared to that of the natural history/observation and similar to that of other soft braces. No long-term deformity progression was seen. To substantiate these findings, stronger designed studies with additional subjects are needed.

Abstract Background Anterior cruciate ligament (ACL) repair techniques are new emerging strategies prevailing, in selected cases, over standard reconstruction of the ACL with excision of its remnants. Mid-substance ACL tears represent a challenge for ACL repair techniques, and remnants-preserving ACL reconstruction (rp-ACLR) using an autograft remains the recommended treatment in this situation. However, morbidity associated with the autograft harvesting prompts the need for alternative surgical strategies based on the use of synthetic scaffolds. Relevant small animal models of mid-substance tears with ACL remnants preservation and reconstruction are necessary to establish the preliminary proof of concept of these new strategies. Methods A rat model of rp-ACLR using a tendinous autograft after complete mid-substance ACL transection was established. Twelve weeks following surgery, clinical outcomes and knee joints were assessed through visual gait analysis, Lachman tests, thigh perimeter measurements, magnetic resonance imaging, micro-computed tomography, and histology, to evaluate the morbidity of the procedure, accuracy of bone tunnel positioning, ACL remnants fate, osteoarthritis, and autograft bony integration. Results were compared with those obtained with isolated ACL transection without reconstruction and to right non-operated knees. Results and discussion Most operated animals were weight-bearing the day following surgery, and no adverse inflammatory reaction has been observed for the whole duration of the study. Autograft fixation with cortical screws provided effective graft anchorage until sacrifice. Healing of the transected ACL was not observed in the animals in which no graft reconstruction was performed. rp-ACLR was associated with a reduced degeneration of the ACL remnants (p = 0.004) and cartilages (p = 0.0437). Joint effusion and synovitis were significantly lower in the reconstructed group compared to the transected ACL group (p = 0.004). Most of the bone tunnel apertures were anatomically positioned in the coronal and/or sagittal plane. The most deviated bone tunnel apertures were the tibial ones, located in median less than 1 mm posteriorly to anatomical ACL footprint center. Conclusion This study presents a cost-effective, new relevant and objective rat model associated with low morbidity for the preliminary study of bio-implantable materials designed for remnants-preserving ACL surgery after mid-substance ACL tear.

Introduction Cervical spine (C-spine) injury is present in up to 10% of patients with maxillofacial fractures. Uncertainty over the status of the C-spine and permitted head movements may delay maxillofacial surgical intervention, resulting in prolonged patient discomfort and return to oral nutrition, reducing quality of life. This study aimed to investigate the effects on the C-spine of positioning patients for maxillofacial procedures by simulating intraoperative positions for common maxillofacial procedures. Methods Magnetic resonance imaging was used to assess the effects of head position in common intraoperative configurations – neutral (anterior mandible position), extended (tracheostomy position) and laterally rotated (mandibular condyle position) on the C-spine of a healthy volunteer. Results In the tracheostomy position, maximal movement occurred in the sagittal plane between the cervico-occipital junction and C4–C5, as well as at the cervico-thoracic junction. Minimal movement occurred at C2 (on C3), C5 (on C6) and C6 (on C7). In the mandibular condyle position, C-spine movements occurred in both rotational and sagittal planes. Maximal movement occurred above the level of C4, concentrated at atlanto-occipital and atlanto-axial (C1–2) joints. Conclusion Neck extension is likely to be relatively safe in injuries that are stable in flexion and extension, such as odontoid peg fracture and fractures between C5 and C7. Head rotation is likely to be relatively safe in fractures below C4, as well as vertebral body fractures, and laminar fractures without disc disruption. Early dialogue with the neurosurgical team remains a central tenet of safe management of patients with combined maxillofacial and C-spine injuries.