heating effects
Recently Published Documents

Aerosols can affect vertical thermal structure during heavily polluted episodes (HPEs). Here, we selected four typical HPEs in 2018, which were further subdivided into dust and haze events. The vertical distribution of aerosols extinction coefficient (EC) and variations in columnar optical properties were investigated based on sun-photometer and Lidar observation at an urban site in Beijing. The vertical characteristics in shortwave radiative heating rate (HR) of aerosols were studied using NASA/Goddard radiative transfer model along with observational data. In the haze episode, EC layer is less than 1.5 km and shows strong scattering, with single-scattering albedo (SSA440nm) of ~0.97. The heating effects are observed at the middle and upper atmosphere, and slight heating effects are found at the lower layer. The mean HR within 1.5 km can be up to 16.3 K day−1 with EC of 1.27 km−1, whereas the HR within 0.5 km is only 1.3 K day−1. In the dust episode, dust aerosols present the absorption with SSA440nm of ~0.88, which would heat the lower atmosphere to promote vertical turbulence, and the height of EC layer can be up to 2.0–3.5 km. In addition, the strong heating effects of dust layer produced cooling effects near the surface. Therefore, the accurate measurement of aerosols optical properties in HPEs is of great significance for modeling aerosols direct radiative effects.

Microclimate regulation is one of the most significant ecosystem services provided by wetlands. The present study attempted to investigate the cooling effect provided by Muthurajawela, a coastal Ramsar wetland using Remote Sensing and GIS. The variation of Land Surface Temperatures (LST) over different land use categories of natural (water bodies, marsh, thick vegetation, grassland) and anthropogenic (built-up areas, coconut cultivations and bare lands) areas in 2015 and 2020. Parameters including Satellite Brightness Temperature, Normalized Difference Vegetation Index, Proportion of Vegetation and Land Surface Emissivity were calculated along eight transects starting from the center of the water body and extending up to 5 km from the boundary of the wetland. The results revealed that LST over areas under natural land cover (2015 - mean 25.040C, 2020 - mean 23.360C) were significantly lower than that of areas under anthropogenic influence (2015 - mean 26.520C and 2020 - mean 26.220C). The lowest increase of LST was over the water body and the highest was over the built-up areas indicating the buffering capacity of wetlands. As air temperatures are highly linked to LST, our findings suggest that wetlands contribute to lower atmospheric temperature and offer cooling effects during dry months. Acknowledging the importance of wetlands in reducing temperature, at least in a local scale, justifies the need of conserving these ecosystems, as seeking mitigatory measures for climate change driven frequent heating effects is challenging.

The applications of SERS in therapeutic drug monitoring, or other fields of analytical chemistry, require the availability of sensitive sensors and experimental approaches that can be implemented in affordable ways. In this contribution, we show the production of cost-effective SERS sensors obtained by depositing Lee-Meisel Ag colloids on filter paper either by natural sedimentation or centrifugation. We have characterized the morphological and plasmonic features of the sensors by optical microscopy, SEM, and UV-Vis spectroscopy. Such sensors can be used to quantify by SERS the anti-epileptic drug Perampanel (in the concentration range 1 × 10−4–5 × 10−6 M) by spinning them during the micro-Raman measurements on the top of a custom device obtained from spare part hard disk drives. This approach minimizes laser-induced heating effects and allows averaging over the spatial non-uniformity of the sensor.

Abstract Dielectric Pocket Double-Gate-All-Around (DP-DGAA) MOSFETs are one of the preferred choices for ULSI applications because of significantly low off-current, reduced power dissipation, and high immunity to short channel effect. However, DP-DGAA MOSFETs suffer from self-heating owing to the unavailability of proper heat take-out paths. In this paper, the electrothermal (ET) simulations have been performed with hydrodynamic and thermodynamic transport models to analyze the self-heating effects (SHEs) in DP-DGAA MOSFETs. The electrothermal characteristics against various device parameters such as spacer length, device thickness, thermal contact resistance, and drain voltage have been investigated. The effect of SHE on the drive current has also been evaluated. Further, the impact of thermal contact resistance and ambient temperature variations of the device on SHE and thermal noise have been analyzed using Sentaurus TCAD simulator.

Abstract Conversion of temperature gradients to charge currents in quantum dot systems enables probing various concepts from highly efficient energy harvesting and fundamental thermodynamics to spectroscopic possibilities complementary to conventional bias device characterization. In this work, we present a proof-of-concept study of a device architecture where bottom-gates are capacitively coupled to an InAs nanowire and double function as local joule heaters. The device design combines the ability to heat locally at different locations on the device with the electrostatic definition of various quantum dot and barrier configurations. We demonstrate the versatility of this combined gating- and heating approach by studying, as a function of the heater location and bias, the Seebeck effect across the barrier-free nanowire, fit thermocurrents through quantum dots for thermometry and detect the phonon energy using a serial double quantum dot. The results indicate symmetric heating effects when the device is heated with different gates and we present detection schemes for the electronic and phononic heat transfer contribution across the nanowire. Based on this proof-of-principle work, we propose a variety of future experiments.

Abstract We report analysis of sub-Alfvénic magnetohydrodynamic (MHD) perturbations in the low-β radial-field solar wind employing the Parker Solar Probe spacecraft data from 2018 October 31 to November 12. We calculate wavevectors using the singular value decomposition method and separate MHD perturbations into three eigenmodes (Alfvén, fast, and slow modes) to explore the properties of sub-Alfvénic perturbations and the role of compressible perturbations in solar wind heating. The MHD perturbations show a high degree of Alfvénicity in the radial-field solar wind, with the energy fraction of Alfvén modes dominating (∼45%–83%) over those of fast modes (∼16%–43%) and slow modes (∼1%–19%). We present a detailed analysis of a representative event on 2018 November 10. Observations show that fast modes dominate magnetic compressibility, whereas slow modes dominate density compressibility. The energy damping rate of compressible modes is comparable to the heating rate, suggesting the collisionless damping of compressible modes could be significant for solar wind heating. These results are valuable for further studies of the imbalanced turbulence near the Sun and possible heating effects of compressible modes at MHD scales in low-β plasma.

Abstract We develop a model describing non-equilibrium processes under the excitation of resonant semiconductor nanostructures with ultrashort laser pulses with a duration of about 100 fs. We focus on the heating effects related to pulsed excitation with account on free carriers generation, thermalization, and relaxation. The heat exchange between the electron and phonon system is treated within the two-temperature model. We applied the developed model to describing pulsed heating of silicon nanocylinder on top of a dielectric substrate. We come up with estimations of the thermal damage threshold of the considered structures which provides the limits for the experimental conditions and ensures thermal stability of the samples.

We investigated the heat dissipation in heterostructure field-effect transistors (HFETs) using microRaman measurement of the temperature in active AIGaN/GaN. By varying the gate structure, the heat dissipation through the gate was clearly revealed. The temperature increased to 120 °C at the flat gate device although the inserted gate increased to only 37 °C. Our results showed that the inserted gate structure reduced the self-heating effect by three times compared to the flat gate structure. Temperature mapping using micro-Raman measurement confirmed that the temperature of the near gate area was lower than that of the near drain area. This indicated that the inserted gate electrode structure effectively prohibited self-heating effects.