Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                

433 MHZ RF Transmitter

Download as pdf or txt
Download as pdf or txt
You are on page 1of 4

433 Mhz RF Transmitter

433 Mhz RF Transmitter


Overview
range is required. This module uses the technique of ON-OFF keyed (OOKs) modulation. The transmitter operates from a 1.5-12V supply, making it ideal for battery-powered applications. The 433 RF Transmitte is ideal for remote control applications where low cost and longer

make the 433 RF Transmitte suitable for high volume applications.

best range performance. Output power and harmonic emissions are easy to control, making

FCC and ETSI compliance easy. The manufacturing-friendly SIP style package and low-cost

The transmitter employs a SAW-stabilized oscillator, ensuring accurate frequency control for

Features

433.92 MHz Frequency Low Cost 1.5-12V operation Small size

11mA current consumption at 3V 4 dBm output power at 3V Remote Lighting Controls

Applications

Remote Keyless Entry (RKE)


DNA Technology |N44-CB2-7,4th Scheme CIDCO | Nasik 422 009 Project Guidance | Kits |Tel: 0253-3023939|amolshah@dnatechindia.com www.dnatechindia.com| Mob: +91 922 514 5135

Page 1

433 Mhz RF Transmitter On-Site Paging

Mechanical Dimensions and Pin Description :

Automated Resource Management

Wireless Alarm and Security Systems Long Range RFID

Asset Tracking

Pin No

1 2 3 4

Pin Name

DATA VCC

GND

Transmitter ground. Connect to ground plane. be driven with CMOS level inputs.

Pin Description

Digital data input. This input is CMOS compatible and should Operating voltage for the transmitter. VCC should be degrade transmitter noise performance. 50 ohm antenna output. The antenna port impedance affects

bypassed with a .01uF ceramic capacitor and filtered with a output power and harmonic emissions. An L-C low-pass

1Kl-10k bps 3V-5V

0 Volts

Notes

4.7uF tantalum capacitor. Noise on the power supply will filter may be needed to sufficiently filter harmonic
DNA Technology |N44-CB2-7,4th Scheme CIDCO | Nasik 422 009 Project Guidance | Kits |Tel: 0253-3023939|amolshah@dnatechindia.com www.dnatechindia.com| Mob: +91 922 514 5135

ANT

emissions. Antenna can be single core wire of approximately

17.2cm : 434 Mhz

Whip Ant.

Page 2

433 Mhz RF Transmitter


17cm length or PCB trace antenna.

Operation
OOK(On Off Keying) modulation is a binary form of amplitude modulation. When a logical 0 (data line low) is being sent, the transmitter is off, fully suppressing the carrier. In this state, the supply. OOK is the modulation method of choice for remote control applications where power OOK data rate is limited by the start-up time of the oscillator. High-Q oscillators which have of the oscillator determines the maximum data rate that the transmitter can send. they transmit a 0, they exhibit significantly better power consumption than FSK transmitters. transmitter current is very low, less than 1mA. When a logical 1 is being sent, the carrier is fully

Theory

on. In this state, the module current consumption is at its highest, about 11mA with a 3V power consumption and cost are the primary factors. Because OOK transmitters draw no power when very stable center frequencies take longer to start-up than low-Q oscillators. The start-up time The oscillator start-up time is on the order of 40uSec, which limits the maximum data rate to

Data Rate

4.8 kbit/sec.

SAW stabilized oscillator

The transmitter is basically a negative resistance LC oscillator whose center frequency is tightly frequency devices that resonate at frequencies much higher than crystals.

controlled by a SAW resonator. SAW (Surface Acoustic Wave) resonators are fundamental

Characteristics:
DNA Technology |N44-CB2-7,4th Scheme CIDCO | Nasik 422 009 Project Guidance | Kits |Tel: 0253-3023939|amolshah@dnatechindia.com www.dnatechindia.com| Mob: +91 922 514 5135

Page 3

433 Mhz RF Transmitter

Parameter
Output Power

Symbol
-

Conditions
50 E load 434 MHz -

Min.
1 9 -

Value
3

Typ.
10 3

Max.
19 6

Unit
mW mA V

Supply Current Supply Voltage Data rate Range

Vcc -

Icc

300

1K

10K

Bps

DNA Technology |N44-CB2-7,4th Scheme CIDCO | Nasik 422 009 Project Guidance | Kits |Tel: 0253-3023939|amolshah@dnatechindia.com www.dnatechindia.com| Mob: +91 922 514 5135

Page 4

You might also like