Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                
Scribd Logo
Upload

Welcome to Scribd!

  • 259 views

    Xprog Errata Sheet 001

    Uploaded by

    Alex Navas Fonseca
    This errata provides information applicable to the following products: 1-002-0017 programming adapter rev.B or earlier. These changes allow you to work with secured ARM MCU via JTAG interface.

    Copyright:

    Attribution Non-Commercial (BY-NC)
    Download as PDF, TXT or read online from Scribd

    Xprog Errata Sheet 001

    Uploaded by

    Alex Navas Fonseca
    259 views1 page
    This errata provides information applicable to the following products: 1-002-0017 programming adapter rev.B or earlier. These changes allow you to work with secured ARM MCU via JTAG interface.

    Copyright

    © Attribution Non-Commercial (BY-NC)

    Available Formats

    PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    This errata provides information applicable to the following products: 1-002-0017 programming adapter rev.B or earlier. These changes allow you to work with secured ARM MCU via JTAG interface.

    Copyright:

    Attribution Non-Commercial (BY-NC)
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    259 views1 page

    Xprog Errata Sheet 001

    Uploaded by

    Alex Navas Fonseca
    This errata provides information applicable to the following products: 1-002-0017 programming adapter rev.B or earlier. These changes allow you to work with secured ARM MCU via JTAG interface.

    Copyright:

    Attribution Non-Commercial (BY-NC)
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    of 1

    XPROG-m Errata Sheet 001

    INTRODUCTION
    This errata provides information applicable to the following products: 1-002-0017 programming adapter Rev.B or earlier These changes allow you to work with secured ARM MCU via JTAG interface

    STEP1

    Remove this resistor

    STEP2
    1A

    1B 2B 3B 4B

    Prepare the four wires. About 5cm in length.

    2A 3A 4A

    STEP3

    1A

    Solder wire shown in the corresponding points at the bottom side

    2A 3A

    4A

    STEP4

    Solder wire shown in the corresponding points at the top side

    3B 2B 1B 4B

    www.tmt.lt

    2009 TMT

    You might also like