Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                

Microstrip Annular Ring Slot Antenna! For Mobile Applications

Download as pdf or txt
Download as pdf or txt
You are on page 1of 2

0 IEE 1996 1'9 July 1996 Electronics Letters Online No: 19961157 G. Forma and J.M.

Laheurte (Laboratoire d'Electronique, Antennes et Tdlt'communications, Universitt' de Nice - Sophia Antipolis, CNRS, 250 rue Albert Einstein, 06560 Valbonne, France)

References
1 2
GREISER, J.W :

'Coplanar stripline antenna', Microw. J., 1976, 19,

(lo), pp. 47-49


LIU, Y . , CHA, K., and ITOH, T.: 'Non-leaky coplanar (NLC) waveguides with conductor backing', IEEE Trans., 1995, MTT-43, ( 5 ) , pp. 1067-1072 3 GIAUFFRET, L , and LAHEURTE, J.M.: 'Theoretical and experimental characterisation of CPW-fed microstrip antennas'. IEE Proc. Microw. Antennas Propag., 1996, 143, (l), pp. 13-17 4 FORMA, G', and LAHEURTE, J M.: 'CPW-fed oscillating microstrip antennas', Electron. Lett., 1996, 32, (2), pp. 85-86

Microstrip annular ring slot antenna!; for mobile applications


J.C. Batchelor and R.J. Langley
Indexing terms: Microstrip antennas, Antennas, Mobile communication systems

, . h ? , . l , ? J

I___?

Fig. 1 Microstrip annular slot geometry

An annular slot on triplate feed is discussed which is suitable for use with vehicular mobile satellite systems. The slot is excited in a higher order mode and circularly polarised to give a conical radiation pattern. The slot can operate on a high dielectric base and a superstrate improves the gain.

Introduction; One aim of recent work regarding m0bil.e communications is to integrate an antenna with its associated R F circuitry into an MMIC device on silicon or gallium arsenide. Work has been done regarding the annular microstrip ring higher order TM,, mode with a possible application for mobile satellite communications in non-equatorial countries, [11. The higher order microstrip ring modes have a null in the direction normal to the plane of the patch and the TIM,, mode peaks at an elevation of 55" from the azimuthal plane. There are however, some disadvantages with using microstrip radiating elements, namely surface waves giving rise to diffraction from substrate edges, poor radiation efficiencies on high dielectric materials and high crosspolar levels for antennas fed electromagnetically through the substrate with a microstrip feed. To overcome the problems mentioned above an investigation into narrow annular microstrip slot antennas (width < U20) has been carried out to establish the properties of the first higher order mode which has not been reported on before. Slot antenna design: A slot antenna, shown on a triplate feed structure in Fig. 1, has the advantage of reducing cross-polarised fields by screening the feedline while also constraining all radiation to the forward hemisphere. The triplate feed structure can allow parallel plate modes to propagate which may give rise to problematic edge diffraction. Spurious radiation at low elevation angles and ripple in the main beam can be removed by mefallising the substrate edges andlor adding via pins. As the aperture fields exist at the air-dielectric interface, the electrical slot size is virtually unaffected by the dielectric constant of the substrate, a situation very different to that of ;I microstrip antenna where the structures fields permeate through both substrate and free space. The fundamental mode radiation pattern of a microstrip annular slot is well known, with ku = l, where wave number, k = 2nIX and a = average slot radius. This mode radiates with maximum gain in a direction normal to the plane of the slot. The antenna presented in this Letter was designed such that k a = 2, the aperture field distribution being shown in Fig. 2. The triplate feed was formed from Duroid 5870, E, = 2.33 and total height = 1.58mm. Resonance occurred at 7.1GHz for an average slot radius of 13.5mm with a slot width of lmm.

-1 OdBidivision

Fig. 3 Measured radiation pattern?


a Measured radiation patterns, ka = 2 b Radiation patterns with alumina superstrate
- - - -

E-plane H-plane

Slot antennas results; The E- and H-plane patterns were measured and are shown in Fig. 3a. The beam peaks at an elevation of 55" making the antenna suitable for higher latitude satellite applications. A 2:l SWR bandwidth of 2.6% was measured for the mode, a value that compares with that of the microstrip ring in the TM21 mode. The H-plane gain was 4.5dB hgher than that of the Eplane and exhibited asymmetry which was attributed to the feed. Adding an alumina superstrate, E, = 10.4, height = 0.6mm, reduced the feed asymmetry to 0.8dB and also caused the power in the E- and H-planes to equalise (Fig. 3b). Low elevation radiation in the E-plane was increased by the addition of the

ELECTRONICS LETTERS

29th August 1996

Vol. 32

No. 78

1635

superstrate due to diffraction from the alumina edges which were unscreened in this measurement. The resonant frequency was reduced to 6.1 GHz. The peak beam gain of the slot at ka = 2 was measured to be -2.6dBi. This was increased to 4.6dBi by adding the superstrate. A good prediction of the composite dielectric constant, caused by introducing the superstrate is given by eqn. 1 [2]

References c , and LANGLEY, R.J.: 'Microstrip ring antennas operating at higher order modes for mobile communications', ZEE Proc. Microis. Antennas Propagat., 1995, 142, (2), pp. 151-155 2 KARMAKER. N c., and BHATTACHARYYA, A.: 'Electromagnetically coupled patch antenna - theoretical and experimental inLestizations'. .Micron.. & Opt. Technol. Left., 1992, 5, (3), pp.
1
BATCHELOR. J
,

115-1 18
3
HIROSE. K..

and

NAKANO, H.:

'Dual-loop slot antenna with simple

feed'. Election. Left., 1989, 25, (18), pp. 1218-1219

where d and h refer to substrate and superstrate heights, respectively. The slot radius IS then given by

where h, is the wavelength in free space.

Low offset, high voltage class AB bipolar voltage-current converter


G. Stochino

Indexing t e r m : Operational transconductance amplifiers, Linear intepiuted circuits A new high voltage class AB bipolar voltage-current converter (VCCS), which features low offset voltage and is suitable for monolithic IC fabrication. is described. The architecture of the converter is particularly suited for the implementation of a precision VCCS with wide input and output voltage range. Some SPICE siinulations and experiiental results are also reported, w h c h demonstrate the effectiveness of the proposed

configuration.
Introduction: In a recent Letter [I] some circuit configurations for Fig. 4 Circularly polarised far-field immurement

Circularly polarised slot antennas: To be of practical use; a mobile antenna used in conjunction with a satellite system would need to be circularly polarised. Budgetary constraints in receiver manufacture require components to be inexpensive and so a non-complex method for producing circular polarisation was sought. A simple way to excite circularly polarised fields from annular slots operating at the ku = 1 mode has been reported by [3] where notches are placed 45" and 225" from the feed point. Fig. 4 shows a far field measurement extrapolated from the near field of the ka = 2 antenna, where four 2mm x 2mm notches were placed midway between the E- and H-planes at 22.5" and 112.5" from the feed. It can be seen that the radiation field was conical in all planes, the field independence around the azimuthal plane making the antenna suitable for mobile applications. Peak beam axial ratio was measured to be less than 3dB. Use of the notches removed the necessity to provide orthogonally phased feedlines beneath the slot and so reduced the component complexity significantly.

high speed class AB voltage controlled current sources (VCCS), %hich feature improved conversion accuracy, were proposed and discussed. However. the intrinsic input offset voltage and output offset current of these configurations are not better than their conventional counterpart. The aim of this Letter is to propose a new bipolar class AB VCCS architecture which, in addition to good conversion accuracy, provides improved offset figures and is particularly suitable for wide inpuvoutput voltage range implementations.

"cc

*-

7 7 - --

Conclusion: A slot antenna operating at a higher order mode has been proposed with a possible application for mobile systems as an alternative to microstrip antennas. The slot antenna has an advantage over microstrip patches because of the screened feed which prevents spurious radiation. Higher order mode fields can be excited that are both circularly polarised and conical in shape. Gains of over 4dB were measured when an alumina superstrate was added. A strong advantage of this type of antenna is its lack of dependency on the dielectric substrate making it suitable for integration with high E, semiconductor materials, a development of considerable interest to recent mobile communication design.
Acknowledgment: This work was supported by grants from the

<-L

VA
_ . _

IA

Fig. 1 Basic architecture of the proposed high speed, low offset, class A B voltage-current converter

UK Engineering and Physical Science Research Council.


0 IEE 1996
Electronics Letters Online No: 19961102
28 June 1996

The few high voltage devices are labelled (HV)


Circuit description: The architecture of the proposed new VCCS is shown in Fig. 1. Transistors Q3,Q4 and Qg in the upper half, and Q7,Q8 and QI0in the lower half, are connected to form two complementary Wilson current mirrors, which are driven by input

J.C. Batchelor and R.J. Langley (University of Kent, Cunterbury, Kent C T 2 7NT, United Kingdom)

1636

ELECTRONICS LETTERS

29th August 1996

Vol. 32

No. 18

You might also like