Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                
Scribd
Upload
201 views

Spring Load Calculation

The document summarizes the design specifications for a stainless steel spring, including the wire diameter, modulus of rigidity, mean diameter, number of turns, number of springs, free length, operating length, spring rate, spring force, face area calculations, spring pressure, and notes that the spring pressure on the seal face should be designed between 0.1 to 0.5 MPa. The only details that need to be changed are colored yellow.

Uploaded by

Suresh Kumar Mittapalli
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as XLS, PDF, TXT or read online on Scribd
201 views

Spring Load Calculation

The document summarizes the design specifications for a stainless steel spring, including the wire diameter, modulus of rigidity, mean diameter, number of turns, number of springs, free length, operating length, spring rate, spring force, face area calculations, spring pressure, and notes that the spring pressure on the seal face should be designed between 0.1 to 0.5 MPa. The only details that need to be changed are colored yellow.

Uploaded by

Suresh Kumar Mittapalli
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as XLS, PDF, TXT or read online on Scribd
You are on page 1/ 1

Change only the details coloured yellow

Spring details: Wire Diameter of Spring, (d) Modulus of Rigidity for Stainless Steel Springs (G) Mean Diameter of the spring(D) No. of turns (n) No. of Springs(Ns) Free length(FL) Operating length(OL)
d=
5 2

0.70 mm

G= G = 0.79 x 10 N/mm 79000.00 ( Modulus N/mm2 of rigidity for stainless steel) D= 3.40 mm

n= Ns= FL= OL= .

11.00 Dimensionless 20.00 Dimensionless 18.30 mm 14.00 mm ( OL must be more than the solid length )

Spring rate = Gd^4/(8D^3n) Spring Rate in kgf/mm


5.48 N/mm 0.56 Kgf/mm
(Since 1N =0.1019716 Kgf)

Spring Force ( Fs ) = Spring Rate* No.of Springs (Ns) *(FL OL)

48.09 kgf

Face Area Calculation


147.40 mm

Face ID
155.40 mm

Face OD Seal Face Area Seal face area in cm2 (Af) Spring Pressure ( Ps ) = Spring force(Fs)/ Face Area(Af) Spring pressure in Mpa
Spring Design 1901.58 mm2 19.02 cm2 2.53 kgf/cm2 0.25 Mpa

DESIGN OK

( 1 Kgf/cm2=0.0980665 Mpa )

Note: The spring pressure on seal face should be designed for 0.1 to 0.5 Mpa.( 1 Kg/cm2 to 5 kg/cm2 )

You might also like