Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                
Scribd Logo
Upload

Welcome to Scribd!

  • 109 views

    Problem 2.26: Solution

    Uploaded by

    Eric Kial
    (1) A transmission line with a characteristic impedance of 50 ohms is connected to a load consisting of a 75 ohm resistor and a capacitor of unknown capacitance. (2) The voltage standing wave ratio on the line was measured to be 3 at 10 MHz. (3) Using equations that relate the standing wave ratio to the load impedance and transmission line impedance, the unknown capacitance is calculated to be 241 pF.

    Copyright:

    Attribution Non-Commercial (BY-NC)
    Download as PDF, TXT or read online from Scribd

    Problem 2.26: Solution

    Uploaded by

    Eric Kial
    109 views1 page
    (1) A transmission line with a characteristic impedance of 50 ohms is connected to a load consisting of a 75 ohm resistor and a capacitor of unknown capacitance. (2) The voltage standing wave ratio on the line was measured to be 3 at 10 MHz. (3) Using equations that relate the standing wave ratio to the load impedance and transmission line impedance, the unknown capacitance is calculated to be 241 pF.

    Original Description:

    problem 2.26 solution

    Original Title

    2.26

    Copyright

    © Attribution Non-Commercial (BY-NC)

    Available Formats

    PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    (1) A transmission line with a characteristic impedance of 50 ohms is connected to a load consisting of a 75 ohm resistor and a capacitor of unknown capacitance. (2) The voltage standing wave ratio on the line was measured to be 3 at 10 MHz. (3) Using equations that relate the standing wave ratio to the load impedance and transmission line impedance, the unknown capacitance is calculated to be 241 pF.

    Copyright:

    Attribution Non-Commercial (BY-NC)
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    109 views1 page

    Problem 2.26: Solution

    Uploaded by

    Eric Kial
    (1) A transmission line with a characteristic impedance of 50 ohms is connected to a load consisting of a 75 ohm resistor and a capacitor of unknown capacitance. (2) The voltage standing wave ratio on the line was measured to be 3 at 10 MHz. (3) Using equations that relate the standing wave ratio to the load impedance and transmission line impedance, the unknown capacitance is calculated to be 241 pF.

    Copyright:

    Attribution Non-Commercial (BY-NC)
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    You are on page 1of 1

    Problem 2.

    26 A 50- lossless transmission line is connected to a load composed of a 75- resistor in series with a capacitor of unknown capacitance (Fig. P2.26). If at 10 MHz the voltage standing wave ratio on the line was measured to be 3, determine the capacitance C.

    RL = 75 Z0 = 50 C=?

    Figure P2.26: Circuit for Problem 2.26.

    Solution: | | = S1 31 2 = = = 0.5 S+1 3+1 4 where XC = 1 . C

    ZL = RL jXC , ZL Z 0 ZL + Z0 ZL Z 0 | | 2 = ZL + Z0 = | | 2 = Noting that:

    Z ZL 0 ZL + Z0

    + Z 2 Z (Z + Z ) ZL ZL 0 L L 0 2 ) ZL ZL + Z0 + Z0 (ZL + ZL

    Z0 (ZL + ZL ) = Z0 (RL jXC + RL + jXC ) = 2Z0 RL ,

    2 ZL ZL = (RL jXC )(RL + jXC ) = R2 L + XC , 2 2 R2 L + XC + Z0 2Z0 RL . 2 2 R2 L + XC + Z0 + 2Z0 RL

    | | 2 =

    Upon substituting |L | = 0.5, RL = 75 , and Z0 = 50 , and then solving for XC , we have XC = 66.1 . Hence C= 1 1 = = 2.41 1010 = 241 pF. XC 2 107 66.1

    You might also like