Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                

Eis Mercedes Commander

Download as pdf or txt
Download as pdf or txt
You are on page 1of 1

WWW.KEYPROGTOOLS.

COM
COMMANDER FOR MERCEDES
EIS (Electrical Ignition Switch)

This special function allows you to Read the EEPROM of EIS control unit and
Read/Write/Erase the EEPROM of ESL control units by direct connection to the
module.
Please, note that you can not read the complete EEprom of the EIS via K-line. The
EEprom that the program will read will not contain the password (8 digits), the 4
bytes of synchronization with ECU (Engine Control Unit) and the crypto key.
The corresponding addresses are:
Password addresses in EIS EEPROM: 0138 - 013F and in key EEprom 0103-010?
(1st variant) or 0101-0108(from last byte to first byte) (2d variant).
Synchronization with ECU (4 bytes) - addresses in EIS EEprom 012?-012F.
The "Open ESL" and "Close ESL" buttons are only working when the ESL EEPROM is
erased or in service mode.
In order to read the EEPROM of ESL CPU 1 and ESL CPU 2 the key should NOT be in
the ignition lock. Just plug the diagnostic cable of the interface into the diagnostic
plug of the car and open and close one of the doors of the car. After that you will
have about 10 seconds to connect to the EIS and read the EEPROM of ESL CPU 1,
or ESL CPU 2.

In the EZS control unit you will find the following processors:

W 202 (M C68H C05X32 x 2 contr oller )


W 203 (M C68H C908AZ60 contr oller )
W 208 (M C68H C05X32 x 2 contr oller )
W 209 (M C9S12DG128 contr oller )
W 210 (M C68H C05X32 x 2 contr oller )
W 211 (M C68H C912DG128A contr oller )
W 215 (M C68H C908AZ60 contr oller )
W 164 (M C9S12DJ 128 contr oller )
W 220 (M C68H C908AZ60, M C68H C05X32 x 2 contr oller )
W 230 (M C68H C908AZ60, M C68H C05X32 x 2 contr oller )
W 639 Vito (M C68H C908AZ60 contr oller )

You might also like