Build the phase90. You must use matched FETs for this circuit to work. Tweaking the value of the zener diode may be needed for some FETs. Its recommended to use sockets for the FETs and zener diode. Also, if using FETs other than those listed, they may need to be rotated 180 degrees, G marked pads must match GATE pin on the actual FETs used. Off board wiring except for the potentiometers are not shown on the layout. Trademarks remain property of their owners. Visit www.tonepad.com for more! 2 500k
150k
Q5
150k 22k
Q2
D2
Q1
Q3
09 ZEP
0.05
22k 22k
0.05
250k
22k 3M9
10k 0.05
15uF +
10k
10k 10k
10k
IC 2
10k 10k
0.05 10k
0.05 22k
56k
150k
IC 3
D1 10k
3002 PF
4k7 150k 150k
0.05
IC 1
0.01 10uF +
OUT 150k
470k 0.01
+9V R A T E
10k
470k
IN GND
Q4
1M
MOC.DAPENOT
Pots 1 - 500k rev. Log. 1 - 250k trim. Capacitors 6 - 0.05 F 2 - 0.01 F 1 - 10 F 1 - 15 F
Layout and presentation by Francisco Pea 2001 - 2007.
All rights reserved. Authorization for personal use only, any commercial use is forbidden. Permission for posting/serving limited to http://www.tonepad.com Permission refused for posting from other sites.
