Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                
Scribd
Upload
86 views22 pages

164 SRS / N-80 Connection Modification: ML 350 ML 500 SRS 9000 Codes

Uploaded by

Mr.P

How to repair the N-80 connector for the SCM module 164 contact faults. that set Driver Air bag codes.

Copyright:

Attribution Non-Commercial (BY-NC)
Download as PPT, PDF, TXT or read online from Scribd
Download as ppt, pdf, or txt

164 SRS / N-80 Connection Modification: ML 350 ML 500 SRS 9000 Codes

Uploaded by

Mr.P
86 views22 pages
How to repair the N-80 connector for the SCM module 164 contact faults. that set Driver Air bag codes.

Original Title

164 SRS MOD

Copyright

© Attribution Non-Commercial (BY-NC)

Available Formats

PPT, PDF, TXT or read online from Scribd

Did you find this document useful?

Is this content inappropriate?

How to repair the N-80 connector for the SCM module 164 contact faults. that set Driver Air bag codes.

Copyright:

Attribution Non-Commercial (BY-NC)
Download as PPT, PDF, TXT or read online from Scribd
Download as ppt, pdf, or txt
86 views22 pages

164 SRS / N-80 Connection Modification: ML 350 ML 500 SRS 9000 Codes

Uploaded by

Mr.P
How to repair the N-80 connector for the SCM module 164 contact faults. that set Driver Air bag codes.

Copyright:

Attribution Non-Commercial (BY-NC)
Download as PPT, PDF, TXT or read online from Scribd
Download as ppt, pdf, or txt
You are on page 1/ 22

164

SRS / N-80 Connection


Modification

ML 350
ML 500
SRS 9000 codes
Steering Wheel and N-80 removed.
Refer to applicable WIS Document
Connection point for N-80
Remove connector from steering
column by depressing both tabs
behind connector.
Tabs on both sides
Note position of tabs and
connector.
Using a small pocket screw driver,
gently release the secondary pin
latch.
Slide secondary latch out of
connector housing noting position.
Trim Back insulation about 4/5
inches using scissors as apposed to
a razor blade.
Using a small flat blade, depress the
lock tab of the pin being removed,
pushing lightly towards to rear.
Cut off Pin and strip wire insulation
back approximately 1 to 2 mm
Identify the wire repair harness
for correct connections to N-80
Cut the repair harness approximately
3 to 4 inches from pin being used.
Strip repair harness end to 1 to 2
mm, solder to existing SRS lead
using Raychem butt connector.
Loop all leads to allow a tension
free connection.
Repeat with all effected SRS
leads.
Tape all wires back into the
previously cut insulation. Tape with
MB cloth tape.
Reinstall secondary connector
pin latch.
Reinstall connector in mounting, N-
80 and steering wheel as per WIS
instructions.
See next page appendix for related
information in regards to this
modification.
 WIS Documents  Related wire diagram
 Notes on procedures  Related Tools
Tools:
 220 589 02 99 00  Cloth Tape
 Repair set.  A 006 989 84 85
 458-hl1802E  Raychem connector
 Heat gun  A 002 546 13 41
Wire Diagram Reference:
 PE 46.10-U-2101MAA
 PIN#
 AB 1
 #3 – Blue \ Black
 #4 – Black \ Yellow
 AB 2
 #5 – Blue \ Black
 #6 – Black \ Yellow

You might also like