Multi-band F-Panel Dual Polarization Half-power Beam Width Adjust.

Electrical Downtilt
XPol F-Panel 17102170 65 18dBi 08T
Type No. Frequency range 1710 1880 MHz Polarization Gain Half-power beam width Copolar +45/ 45 Electrical tilt continuously adjustable Sidelobe suppression for first sidelobe above horizon Front-to-back ratio (180 30) Cross polar ratio Maindirection Sector Impedance VSWR Intermodulation IM3 (2 x 43 dBm carrier) Max. power per input 0 60 +45, 45 2 x 17.5 dBi Horizontal: Vertical: 0 8 67 7

1710 2170 X 65 0 8

set by hand or by optional RCU (Remote Control Unit)

742 212
17102170 1850 1990 MHz +45, 45 2 x 17.7 dBi Horizontal: 65 Vertical: 6.7 0 8 1920 2170 MHz +45, 45 2 x 18 dBi Horizontal: 63 Vertical: 6.5 0 8 0 ... 2 ... 5 ... 8 T 20 ... 20 ... 18 ... 16 dB Copolar: > 30 dB Total power: > 25 dB Typically: 25 dB > 10 dB > 30 dB 50 < 1.5

0 ... 2 ... 5 ... 8 T 0 ... 2 ... 5 ... 8 T 17 ... 17 ... 15 .... 15 dB 20 ... 20 ... 18 ... 18 dB Copolar: > 30 dB Total power: > 25 dB Typically: 25 dB > 10 dB > 30 dB 50 < 1.5 Copolar: > 30 dB Total power: > 25 dB Typically: 25 dB > 10 dB > 30 dB 50 < 1.5 < 150 dBc

Isolation, between ports

300 W (at 50 C ambient temperature)

1710 1880 MHz: +45/ 45 Polarization

125 67

7
10 3 0 0 10

Horizontal Pattern

Vertical Pattern 0 8 electrical downtilt 1710 2170 45 1710 2170 +45

1850 1990 MHz: +45/ 45 Polarization

120 65

dB

dB

7-16
6.7

7-16

10

10

Mechanical specifications Input Connector position Adjustment mechanism Weight Wind load Frontal: Lateral: Rearside: 2 x 7-16 female Bottom 1x, Position bottom continuously adjustable 7.5 kg 130 N (at 150 km/h) 110 N (at 150 km/h) 310 N (at 150 km/h) 200 km/h 1574 x 172 x 92 mm 1302 / 155 / 69 mm
dB

Subject to alteration.

dB

3 0

3 0

Horizontal Pattern

Vertical Pattern 0 8 electrical downtilt

1920 2170 MHz: +45/ 45 Polarization

120 63 6.5

936.2051/i

Max. wind velocity

10 10

Packing size
dB

dB

3 0

3 0

Height/width/depth

Horizontal Pattern

Vertical Pattern 0 8 electrical downtilt

Internet: http://www.kathrein.de KATHREIN-Werke KG . Anton-Kathrein-Strae 1 3 . PO Box 10 04 44 . D-83004 Rosenheim . Germany . Telephone +49 8031 1 84-0 . Fax +49 8031 1 84-9 73

page 1 of 4

742 212

F-Panels Harmony of Design and Technology

Accessories (order separately)
Type No. 734 360 734 361 734 362 734 363 734 364 734 365 738 546 Description 2 clamps 2 clamps 2 clamps 2 clamps 2 clamps 2 clamps 1 clamp Remarks Mast: 34 60 mm dia. Mast: 60 80 mm dia. Mast: 80 100 mm dia. Mast: 100 120 mm dia. Mast: 120 140 mm dia. Mast: 45 125 mm dia. Mast: 50 115 mm dia. Mast: 110 220 mm dia. Mast: 210 380 mm dia. Downtilt angle: 0 10 Material Stainless steel Stainless steel Stainless steel Stainless steel Stainless steel Stainless steel Hot-dip galvanized steel Hot-dip galvanized steel Hot-dip galvanized steel Stainless steel Weight Units per approx. antenna 60 g 70 g 80 g 90 g 110 g 80 g 1.0 kg 2.7 kg 4.8 kg 1.0 kg 1 1 1 1 1 1 2 2 2 1 1302 1356 1386 Adjustment mechanism with integrated scale 54
45 +45

64 35

8.5

850 10002 1 clamp 850 10003 1 clamp 732 317 1 downtilt kit

For downtilt mounting use the clamps for an appropriate mast diameter together with the downtilt kit. Wall mounting: No additional mounting kit needed. Material: Reflector screen: Tin plated copper. Radiator: Tin plated zinc. Flat fiberglass radome: The max. radome depth is only 69 mm. Fiberglass material guarantees optimum performance with regards to stability, stiffness, UV resistance and painting. The colour of the radome is grey. All screws and nuts: Stainless steel. The metal parts of the antenna including the mounting kit and the inner conductors are DC grounded.

Grounding:

Environmental conditions: Kathrein cellular antennas are designed to operate under the environmental conditions as described in ETS 300 019-1-4 class 4.1 E. The antennas exceed this standard with regard to the following items: Low temperature: 55 C High temperature (dry): +60 C Ice protection: Due to the very sturdy antenna construction and the protection of the radiating system by the radome, the antenna remains operational even under icy conditions. Environmental tests: Kathrein antennas have passed environmental tests as recommended in ETS 300 019-2-4. The homogenous design of Kathreins antenna families use identical modules and materials. Extensive tests have been performed on typical samples and modules.

155 Bottom view Please note: As a result of more stringent legal regulations and judgements regarding product liability, we are obliged to point out certain risks that may arise when products are used under extraordinary operating conditions. The mechanical design is based on the environmental conditions as stipulated in ETS 300 019-1-4, which includes the static mechanical load imposed on an antenna by wind at maximum velocity. Extraordinary operating conditions, such as heavy icing or exceptional dynamic stress (e.g. strain caused by oscillating support structures), may result in the breakage of an antenna or even cause it to fall to the ground. These facts must be considered during the site planning process. The installation team must be properly qualified and also be familiar with the relevant national safety regulations. The details given in our data sheets have to be followed carefully when installing the antennas and accessories. The limits for the coupling torque of RF-connectors, recommended by the connector manufacturers must be obeyed. Any previous datasheet issues have now become invalid.
Subject to alteration. 936.2051/i

Internet: http://www.kathrein.de KATHREIN-Werke KG . Anton-Kathrein-Strae 1 3 . PO Box 10 04 44 . D-83004 Rosenheim . Germany . Telephone +49 8031 1 84-0 . Fax +49 8031 1 84-9 73

742 212

page 2 of 4

69

Instructions for Antennas with Adjustable Electrical Downtilt (General Example)

Description of the interface (protective cap removed):

1 2

Adjustment wheel with twist-lock function. Downtilt spindle with integrated scale.

Thread for fixing of the protective cap or the RCU (Remote Control Unit). Gearwheel for RCU-power drive.

To set the downtilt angle exactly, you must look horizontally at the scale. The lower edge of the gearwheel must be used for alignment purposes.

Manual adjustment procedure: (General example)

max. 0

0 max.

Remove protective cap.

Set downtilt angle by rotating the adjustment wheel.

Screw on the protective cap again.

936.2051/i

Subject to alteration.

Internet: http://www.kathrein.de KATHREIN-Werke KG . Anton-Kathrein-Strae 1 3 . PO Box 10 04 44 . D-83004 Rosenheim . Germany . Telephone +49 8031 1 84-0 . Fax +49 8031 1 84-9 73

page 3 of 4

742 212

Attachment of the RCU (General Example)

Attachment of the RCU (Remote Control Unit) for remote-controlled downtilt adjustment: (General example)

Remove the protective cap completely from the antenna. Check the proper functioning of the phase-shifter over the entire adjustment range, by twisting the adjustment wheel in such a way that the spindle moves completely in and out. Reset the downtilt to the previous value.

Completely remove the black adjustement wheel by simply pulling it downwards.

Push the attachment nut of the RCU down towards the housing. Place the RCU carefully over the adjustment spindle, observing the correct alignment of the RCU with regards to the antenna, i.e. the flat surfaces of the attachment fixture on the antenna side and those inside the RCU housing must lie flat against each other. Push-up the RCU carefully to the stop at the antenna. Please note! Do not twist the RCU in any way during attaching to the antenna, as this could damage the adjustment spindle.

Tighten the RCU attachment nut using a torque-wrench; wrench width = 41 mm, min. torque = 15 Nm, max. torque = 18 Nm. Connect the RCU control cable immediately after attachment of the RCU. Please note! In cases where a mechanical downtilt unit is installed, this must not be set for a downtilt of more than 14 degrees.

Internet: http://www.kathrein.de KATHREIN-Werke KG . Anton-Kathrein-Strae 1 3 . PO Box 10 04 44 . D-83004 Rosenheim . Germany . Telephone +49 8031 1 84-0 . Fax +49 8031 1 84-9 73

742 212

page 4 of 4

936.2051/i

Subject to alteration.