Professional Documents
Culture Documents
Spray-Type Deaerating Heaters: TABLE 12.2
Spray-Type Deaerating Heaters: TABLE 12.2
in their operation. Spring-loaded nozzles located in the top of the unit spray the water into a steam atmosphere that heats it. Simply stated, the steam heats the water, and at the elevated temperature the solubility of oxygen is extremely low and most of the dissolved gases are removed from the system by venting. The spray will reduce the dissolved oxygen content to 20-50 ppb, while the scrubber or trays further reduce the oxygen content to approximately 7 ppb or less. During normal operation, the vent valve must be open to maintain a continuous plume of vented vapors and steam at least 18 inches long. If this valve is throttled too much, air and nonconclensable gases will accumulate in the deaerator. This is known as air blanketing and can be remedied by increasing the vent rate. For optimum oxygen removal, the water in the storage section must be heated to within 5 F of the temperature of the steam at saturation conditions. From inlet to outlet, the water is deaerated in less than 10 seconds. Storage Section The storage section is usually designed to hold enough water for 10 minutes of boiler operation at full load. Limitations Inlet water should be virtually free of suspended solids that could clog spray valves and ports of the inlet distributor and the deaerator trays. In addition, spray valves, ports and deaerator trays may become plugged with scale that forms when the water being deaerated has high hardness and alkalinity levels. In this case, routine cleaning and inspection of the deaerator is very important.
TABLE 12.2 Deaerating Heater Troubleshooting Guide
Remedy 1. Insufficient venting-increase vent rate by opening the manually operated air vent valve. 2. Check steam pressure reducing valve for improper operation and hookup. Check valve for free operation, and see that control line is connected to the connection provided in the deaerator and not to the piping downstream of the valve. 3. Check water and, if possible, steam flow rates vs. design. Trays or scrubber and inlet valves are designed for specific flow ranges.
Temperature in storage tank does not correspond within 5 F of saturation temperature of the steam
1. Improper spray from spray nozzle. Check nozzle for sediment or deposit on seat or broken spring. 2. Excessive free air due to leaking stuffing boxes on pumps upstream of deaerator that have negative suction head. Repair stuffing box or seal with deaerated water.
1. Trays collapsed-possibly from interrupted steam supply or sudden supply of cold water causing a vacuum. 2. Condensate may be too hot. Water entering the deaerating heater must usually be cooled if the temperature is within 20 F of saturation temperature of the steam. Check the design specification to determine what inlet water temperature was originally intended.
1. Improper operation of inlet control valve. Adjust as necessary. 2. Check faulty operation of steam pressure reducing valve.
3. Check relief valves on the deaerator and in the main steam supply system for proper operation. Low pressure 1. Check for improper operation of steam pressure reducing valve.
Rule of Thumb The temperature of the bulk water in the storage section should be at least 2 F for each I psig of the steam supply, up to 30 psig. Example 5 psig steam 2F x 5 = 10F Mimimum bulk water temperature 10 psig steam 2F x 10 = 20F Minimum bulk water temperature Saturation temperature = 227 F 212F + 10F = 222F 222 F Saturation temperature = 240F 212 F + 20 F = 232 F 232 F