Rotair Block 4 Way Poppet Valves SC-300

RotairBlock Valve Pneumatic Directional Control
(Pages from SC-Master2 Catalog)

The Drive & Control Company
Rotair Block Valves

4/2 and 4/3, lever operated
4.17
Rotair Block Valves

Dimensions and repair kits
4.18
NOTICES TO PRODUCT USERS

1. WARNING: FLUID MEDIA
Bosch Rexroth pneumatic devices are designed and tested for use with filtered, clean, dry, chemical free air at pressures and temperatures within the specified limits of the device. For use with media other than air or for human life support systems, Bosch Rexroth must be consulted. Hydraulic cylinders are designed for operation with filtered, clean, petroleum based hydraulic fluid; operation using fire-resistant or other special types of fluids may require special packing and seals. Consult the factory. INSTALLATION! Do not attempt to install, operate or repair these devices without proper training in the technique of working on pneumatic or hydraulic systems and devices, unless under trained supervision. Compressed air and hydraulic systems contain high levels of stored energy. Do not attempt to connect, disconnect or repair these products when system is under pressure. Always exhaust or drain the pressure from system before performing any service work. Failure to do so can result in serious personal injury. MOUNTING! Devices should be mounted and positioned in such manner that they cannot be accidentally operated.
2. WARNING: MATERIAL COMPATIBILITY

Damage to product seals or other parts caused by the use of noncompatible lubricants, oil additives or synthetic lubricants in the air system compressor or line lubrication devices voids Bosch Rexroth's warranty and can result in product failure or other malfunction. See lubrication recommendations below. AIR LINE LUBRICANTS! In service higher than 18 cycles per minute or with continuous flow of air through the device, an air line lubricator is recommended. * (Do not use line lubrication with vacuum products.) However, the lubricator must be maintained since the oil will wash out the grease, and lack of lubrication will greatly shorten the life expectancy. The oils used in the lubricator must be compatible with the elastomers in the device. The elastomers are normally BUNA-N, NEOPRENE, VITON, SILICONE and HYTREL. Bosch Rexroth recommends the use of only petroleum-based oils without synthetic additives, and with an aniline point between 180 and 210 F. COMPRESSOR LUBRICANTS! All compressors (with the exception of special "oil free" units) pass oil mist or vapor from the internal crankcase lubricating system through to the compressed air. Since even small amounts of non-compatible lubricants can cause severe seal deterioration (which could result in component and system failure) special care should be taken in selecting compatible compressor lubricants. It is recommended that users review the National Fluid Power Association "Recommended Guide Lines For Use Of Synthetic Lubricants In Pneumatic Fluid Power Systems" (NFPA T1-1978).
4. WARNING: APPLICATION AND USE OF PRODUCTS

The possibility does exist for any device or accessory to fail to operate properly through misuse, wear or malfunction. The user must consider these possibilities and should provide appropriate safe guards in the application or system design to prevent personal injury or property damage in the event of malfunction.
5. WARNING: CONVERSION, MAINTENANCE AND REPAIR

When a device is disassembled for conversion to a different configuration, maintenance or repair, the device must be tested for leakage and proper operation after being reassembled and prior to installation. MAINTENANCE AND REPAIR! Maintenance periods should be scheduled in accordance with frequency of use and working conditions. All Bosch Rexroth products should provide minimum of 1,000,000 cycles of maintenance free service when used and lubricated as recommended. However, these products should be visually inspected for defects and given an "in system" operating performance and leakage test once a year. Where devices require major repair as result of the one million cycles, one year, or routine inspection, the device must be disassembled, cleaned, inspected, parts replaced as required, rebuilt and tested for leakage and proper operation prior to installation. See individual catalogs for specific cycle life estimates.
6. PRODUCT CHANGES
Product changes including specifications, features, designs and availability are subject to change at any time without notice. For critical dimensions or specifications, contact factory.
3. WARNING: INSTALLATION AND MOUNTING

*Many Bosch Rexroth pneumatic components can operate with or The user of these devices must conform to all applicable electrical, without air line lubrication; see individual sales catalogs for details. mechanical, piping and other codes in the installation, operation or repair of these devices. --Refer to the appropriate service catalog for parts and service information.
LIMITATIONS OF WARRANTIES & REMEDIES

Bosch Rexroth warrants its products sold by it to be free from defects in material and workmanship to the following: For twelve months after shipment Bosch Rexroth will repair or replace (F.O.B. our works), at its option, any equipment which under normal conditions of use and service proves to be defective in material or workmanship at no charge to the purchaser. No charge will be made for labor with respect to defects covered by this Warranty, provided that the work is done by Bosch Rexroth or any of its authorized service facilities. However, this Warranty does not cover expenses incurred in the removal and reinstallation of any product, nor any downtime incurred, whether or not proved defective. All repairs and replacement parts provided under this Warranty policy will assume the identity, for warranty purposes, of the part replaced, and the warranty on such replacement parts will expire when the warranty on the original part would have expired. Claims must be submitted within thirty days of the failure or be subject to rejection. This Warranty is not transferable beyond the first using purchaser. Specifically, excluded from this Warranty are failures caused by misuse, neglect, abuse, improper operation or filtration, extreme temperatures, or unauthorized service or parts. This Warranty also excludes the use of lubricants, fluids or air line additives that are not compatible with seals or diaphragms used in the products. This Warranty sets out the purchaser's exclusive remedies with respect to products covered by it, whether for negligence or otherwise. Neither, Bosch Rexroth nor any of its affiliates will be liable for consequential or incidental damages or other losses or expenses incurred by reason of the use or sale of such products. Our liability (except as to title) arising out of the sale, use or operation of any product or parts, whether on warranty, contract or negligence (including claims for consequential or incidental damage) shall not in any event exceed the cost of replacing the defective products and, upon expiration of the warranted period as herein provided, all such liability is terminated. THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, WHETHER FOR MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE OR OTHERWISE. No attempt to alter, amend or extend this Warranty shall be effective unless authorized in writing by an officer of Bosch Rexroth Corporation. Bosch Rexroth reserves the right to discontinue manufacture of any product, or change product materials, design or specifications without notice.
Bosch Rexroth Corporation Pneumatics 1953 Mercer Road P Lexington, KY 40511-1021 Telephone (859) 254-8031 L Facsimile (859) 254-4188 pneumatics@boschrexroth-us.com www.boschrexroth-us.com
International offices: Asia: China Russia India Singapore Japan South Korea Malaysia
Australia Europe: Austria Belgium Bulgaria Czech Republic Denmark Finland France Germany Greece Hungary Italy
Factory Automation Regional sales offices:

Central Bosch Rexroth Corporation 5150 Prairie Stone Parkway Hoffman Estates, IL 60192-3707 Telephone (847) 645-3600 Facsimile (847) 645-0804 Great Lakes Bosch Rexroth Corporation 1701 Harmon Road Auburn Hills, MI 48326-1549 Telephone (248) 393-3330 Facsimile (248) 393-2893 Northeast Bosch Rexroth Corporation 99 Rainbow Road East Grandby, CT 06026-0000 Telephone (860) 844-8377 Facsimile (860) 844-8595 Bosch Rexroth Corporation 2315 City Line Road Bethlehem, PA 18017-2131 Telephone (610) 694-8300 Facsimile (610) 694-8467 Southeast Bosch Rexroth Corporation 14001 South Lake Drive Charlotte, NC 28273-5544 Telephone (704) 583-4338 Facsimile (704) 583-0523 West Bosch Rexroth Corporation 11 Goddard Irvine, CA 92618-4600 Telephone (949) 450-2777 Facsimile (949) 450-2790
North American offices: Bosch Rexroth Corporation Corporate Headquarters 5150 Prairie Stone Parkway Hoffman Estates, IL 60192-3707 Telephone (847) 645-3600 Facsimile (847) 645-0804
Bosch Rexroth Corporation Industrial Hydraulics 2315 City Line Road Bethlehem, PA 18017-2131 Telephone (610) 694-8300 Facsimile (610) 694-8467 Bosch Rexroth Corporation Electric Drives and Controls 5150 Prairie Stone Parkway Hoffman Estates, IL 60192-3707 Telephone (847) 645-3600 Facsimile (847) 645-6201 Bosch Rexroth Corporation Linear Motion and Assembly Technologies 816 E. Third Street Buchanan, MI 49107 Telephone (269) 695-0151 Facsimile (269) 695-5363 14001 South Lakes Drive Charlotte, NC 28273 Telephone (800) 438-5983 Facsimile (704) 583-0523
Bosch Rexroth Corporation Mobile Hydraulics 145 Southchase Boulevard Fountain Inn, SC 29644-9018 Telephone (864) 967-2777 Facsimile (864) 962-5338
Bosch Rexroth Canada 3426 Mainway Drive Burlington, Ontario L7M 1A8 Telephone (905) 335-5511 Facsimile (905) 335-4184 www.boschrexroth.ca Bosch Rexroth, S.A. de C.V. Calle Neptuno # 72 Unidad Industrial Vallejo CP 07700 Mexico, D.F. Telephone (555) 754-1711 Facsimile (555) 752-5943 Further contacts: www.boschrexroth.com/addresses
Netherlands Norway Poland Portugal Romania Slovakia Spain Sweden Switzerland Turkey Ukraine United Kingdom
North America: Canada United States Mexico South America: Argentina Venezuela Brazil
The data specified herein only serves to describe the product. No statements concerning a certain condition or suitability for a certain application can be derived from our information. The given information does not release the user from obligation of own judgment and verification. It must be remembered that our products are subject to a natural process of wear and aging. This document, as well as the data, specifications and other information set forth in it, are the exclusive property of Bosch Rexroth Corp. Without their consent it may not be reproduced or given to third parties.
Printed in the United States April 2006
2006 Bosch Rexroth Corporation

Rotair Block 4 Way Poppet Valves SC-300

Uploaded by

Copyright:

Available Formats

Rotair Block 4 Way Poppet Valves SC-300

Uploaded by

Document Information

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Rotair Block 4 Way Poppet Valves SC-300

Uploaded by

Copyright:

Available Formats

RotairBlock Valve Pneumatic Directional Control

(Pages from SC-Master2 Catalog)

Rotair Block Valves

Rotair Block Valves

NOTICES TO PRODUCT USERS

2. WARNING: MATERIAL COMPATIBILITY

4. WARNING: APPLICATION AND USE OF PRODUCTS

5. WARNING: CONVERSION, MAINTENANCE AND REPAIR

3. WARNING: INSTALLATION AND MOUNTING

LIMITATIONS OF WARRANTIES & REMEDIES

Factory Automation Regional sales offices:

2006 Bosch Rexroth Corporation

You might also like