USP 9 Pin
USP 9 Pin
USP 9 Pin
D-Type-25 Pin No. Pin 2 Pin 3 Pin 4 Pin 5 Pin 6 Pin 7 Pin 8 Pin 20 Pin 22
D-Type-9 Pin Abbreviation Full Name No. Pin 3 TD Transmit Data Pin 2 RD Receive Data Pin 7 RTS Request To Send Pin 8 CTS Clear To Send Pin 6 DSR Data Set Ready Pin 5 SG Signal Ground Pin 1 CD Carrier Detect Data Terminal Pin 4 DTR Ready Pin 9 RI Ring Indicator
Pin Functions
Abbreviation Full Name TD Transmit Data RD Receive Data CTS Clear to Send DCD Data Carrier Detect DSR DTR Data Set Ready Data Terminal Ready Request To Send Ring Indicator
Function Serial Data Output (TXD) Serial Data Input (RXD) This line indicates that the Modem is ready to exchange data. When the modem detects a "Carrier" from the modem at the other end of the phone line, this Line becomes active. This tells the UART that the modem is ready to establish a link. This is the opposite to DSR. This tells the Modem that the UART is ready to link. This line informs the Modem that the UART is ready to exchange data. Goes active when modem detects a ringing signal from the PSTN.
RTS RI
Null Modems
A Null Modem is used to connect two DTE's together. This is commonly used as a cheap way to network games or to transfer files between computers using Zmodem Protocol, Xmodem Protocol etc. This can also be used with many Microprocessor Development Systems.
Above is my preferred method of wiring a Null Modem. It only requires 3 wires (TD, RD & SG) to be wired straight through thus is more cost effective to use with long cable runs. The theory of operation is reasonably easy. The aim is to make to computer think it is talking to a modem rather than another computer. Any data transmitted from the first computer must be received by the second thus TD is connected to RD. The second computer must have the same set-up thus RD is connected to TD. Signal Ground (SG) must also be connected so both grounds are common to each computer. The Data Terminal Ready is looped back to Data Set Ready and Carrier Detect on both computers. When the Data Terminal Ready is asserted active, then the Data Set Ready and Carrier Detect immediately become active. At this point the computer thinks the Virtual Modem to which it is connected is ready and has detected the carrier of the other modem. All left to worry about now is the Request to Send and Clear To Send. As both computers communicate together at the same speed, flow control is not needed thus these two lines are also linked together on each computer. When the computer wishes to send data, it asserts the Request to Send high and as it's hooked together with the Clear to Send, It immediately gets a reply that it is ok to send and does so. Notice that the ring indicator is not connected to anything of each end. This line is only used to tell the computer that there is a ringing signal on
the phone line. As we don't have a modem connected to the phone line this is left disconnected. LoopBack Plug
This loopback plug can come in extremely handy when writing Serial / RS232 Communications Programs. It has the receive and transmit lines connected together, so that anything transmitted out of the Serial Port is immediately received by the same port. If you connect this to a Serial Port an load a Terminal Program, anything you type will be immediately displayed on the screen. This can be used with the examples later in this tutorial.
Figure 2 : Loopback Plug Wiring Diagram
Please note that this is not intended for use with Diagnostic Programs and thus will probably not work. For these programs you require a differently wired Loop Back plug which may vary from program to program.