Professional Documents
Culture Documents
Objectives: 3G 2G Ultra-Broadband
Objectives: 3G 2G Ultra-Broadband
It is a successor
to 3G and 2G standards, with the aim to provide ultra-broadband (gigabit-speed) internet access
to mobile as well as stationary users. Although 4G is a broad term that has had several different
and more vague definitions, 4G to refer to IMT Advanced (International Mobile
Telecommunications Advanced), A 4G cellular system must have target peak data rates of up to
approximately 100 Mbit/s for high mobility such as mobile access and up to approximately 1
Gbit/s for low mobility such as nomadic/local wireless access,. A 4G system is expected to
provide a comprehensive and secure all-IP based solution where facilities such as IP telephony,
ultra-broadband Internet accessand HDTV streamed multimedia should be provided to users
Objectives
4G is being developed to accommodate the QoS and rate requirements set by further
development of existing 3G applications like wireless broadband access, Multimedia Messaging
Service (MMS), video chat, mobile TV, but also new services like HDTV content, minimal services
like voice and data, and other services that utilize bandwidth. It may be allow roaming with
wireless local area networks, and be combined withdigital video broadcasting systems.
The 4G working group[has defined the following as objectives of the 4G wireless communication
standard:
According to the members of the 4G working group, the infrastructure and the terminals of 4G will
have almost all the standards from 2G to 4G implemented. Although legacy systems are in place
to adopt existing users, the infrastructure for 4G will be only packet-based (all-IP). Some
proposals suggest having an open Internet platform. Technologies considered to be early 4G
include: Flash-OFDM, the 802.16e mobile version of WiMax (also known as WiBro in South
Korea), and HC-SDMA (see iBurst)COMPONENTS:
[Access schemes
As the wireless standards evolved, the access techniques used also exhibited increase in
efficiency, capacity and scalability. The first generation wireless standards used
plain TDMA and FDMA. In the wireless channels, TDMA proved to be less efficient in handling
the high data rate channels as it requires large guard periods to alleviate the multipath impact.
Similarly, FDMA consumed more bandwidth for guard to avoid inter carrier interference. So in
second generation systems, one set of standard used the combination of FDMA and TDMA and
the other set introduced an access scheme called CDMA. (This enabled the third generation
systems to use CDMA as the access scheme IS-2000, UMTS, HSXPA, 1xEV-DO, TD-CDMA and
TD-SCDMA. However, the issue with CDMA is that it suffers from poor spectrum flexibility and
scalability.
The other important advantage of the above mentioned access techniques is that they require
less complexity for equalization at the receiver. This is an added advantage especially in
the MIMO environments since the spatial multiplexing transmission of MIMO systems inherently
requires high complexity equalization at the receiver.
[edit]IPv6 support
Unlike 3G, which is based on two parallel infrastructures consisting of circuit switched and packet
switched network nodes respectively, 4G will be based on packet switching only. This will
require low-latency data transmission.
By the time that 4G is deployed, the process of IPv4 address exhaustion is expected to be in its
final stages. Therefore, in the context of 4G,IPv6 support is essential in order to support a large
number of wireless-enabled devices. By increasing the number of IP addresses, IPv6 removes
the need for Network Address Translation (NAT), a method of sharing a limited number of
addresses among a larger group of devices, although NAT will still be required to communicate
with devices that are on existing IPv4 networks.
As of June 2009, Verizon has posted specifications that require any 4G devices on its network to
support IPv6.[15]
SDR is one form of open wireless architecture (OWA). Since 4G is a collection of wireless
standards, the final form of a 4G device will constitute various standards. This can be efficiently
realized using SDR technology, which is categorized to the area of the radio convergence.
[