Liquid Electricity
Liquid Electricity
Liquid Electricity
With an electrolyte solution the consumer delivers the spent electrolyte back
to the filling station where it is re-charged by either local power
generation or the national power network. Just pump the spent electrolyte
out and pump in freshly charged electrolyte literally, liquid electricity. The
discharged liquid is also reusable: it can be recharged and then pumped into
other vehicle, which makes it an eco-friendly solution. The MIT researchers
have named their new battery design the semisolid flow cell. The battery
stores electric energy as a liquid called Cambridge Crude. When the energy
in the liquid is exhausted, all users have to do is head to a charging station to
pump out the old liquid and pump in a new batch of fully charged liquid.
Recharging of this liquid will take place at the refueling station using special
recharging equipment that will be part of the overall system. Liquid
electricity takes the form of a vanadium redox battery technology. We can
change the electrolyte in these type of batteries.
INTRODUCTION
Transportation is one of the fastest growing energy demand sector. We
currently spend huge amounts of time and energy getting oil . While electric
vehicles (EVs) are stated to be the vehicles of the future, a number of factors
are holding people back from switching over from regular vehicles right
now. Researchers from MIT have developed a new battery that is said to
solve these problems. We just need to swap the electrolytes in these
batteries. The discharged liquid is also reusable: it can be recharged and then
pumped into other vehicle, which makes it an eco-friendly solution.
Liquid electricity is a fictional liquid substance that often appeared in
comedy short films of the silent film era. It is the "distilled essence of
electricity" in liquid form, a (usually) glowing substance easily stored in
bottles. It provides fantastic energy and super-speed when used as a fuel for
automobiles, aircraft, and machines of all sorts. One variant of liquid
electricity could be drunk by humans, who often did so for humorous effect
in silent film comedies.
The use of "liquid electricity" as a comedic plot device was often used by
filmmakers as a way to present "speeded-up motion" and demonstrate the
use of this special effect in film. The motion picture industry was in its
infancy in the early 20th century, and the use of slow motion and fast motion
effects
were
new
novelty
to
movie-going
audiences.
In
CONCEPT
A vanadium redox battery consists of an assembly of power
cells. in which the two electrolytes are separated by
a proton exchange membrane. The electrolyte in the
positive half-cells contains VO2+ and VO2+ ions, the
electrolyte in the negative half-cells, V3+ and V2+ ions.
The
electrolytes
may
be
prepared
by
electrolytically
downsizing that boggles the mind. The staff at National Power was reduced
from 12,000 to 4000. Ouch, that hurts.
But, somehow, in the midst of this downsizing, National Power management
acknowledged they could not survive the long term if they focused solely on
cutting costs. New high-margin products and services were needed.
Therefore, engineers and scientists were selected and charged with creating a
new future for National Power.
One team focused on building a bigger, better energy storage system.
National Power's chemists set out to investigate electrolytes, ultimately
selecting sodium bromide and sodium polysulfide. To charge what is, in
effect, a reversible fuel, sodium ions are transferred through an ion exchange
membrane. Charged fluids are stored in individual tanks, which are sized
according to a customer's energy needs. Electricity is extracted by reversing
the process.
The open circuit voltage of individual cells is approximately 1.5 V dc. A
commercial 100-kW module comprised of 200 cells will thus output 300 V
dc. Modules are linked hydraulically in parallel, electrically in series to give
the desired voltage. Approximately 16 m superscript 3 (21 yd superscript 3)
of each electrolyte is needed for each megawatt-hour of storage. A powerconditioning unit provides the interface between the grid and the direct
current modules.
Systems can be designed to respond within 20 msec, which enables load
shaping and voltage shifting. Systems also can be designed with large tanks
to provide megawatt-hours to be dispersed over hours or days. After four
CONCLUSION
REFERENCES
www.google.com
www.wikipedia.com
www.seminartopic.com