Prolon PL-RSC - E
Prolon PL-RSC - E
Benefits
Local temperature
Tenant override button
+/
40 to 90 F
5 to 30 C
PLRSA
X
X
PLRSF
X
X
PLRSC
X
X
X
X
X
SPECIFICATIONS
Operating Conditions:
Storage Conditions:
Sensor:
Set point Potentiometer:
F
41.0
42.8
44.6
46.4
48.2
50.0
51.8
53.6
55.4
57.2
59.0
60.8
62.6
64.4
66.2
68.0
69.8
71.6
73.4
75.2
77.0
78.8
80.6
82.4
84.2
86.0
87.8
89.6
Kohm
23.652
22.602
21.604
20.656
19.755
18.897
18.082
17.306
16.567
15.864
15.194
14.556
13.949
13.369
12.817
12.291
11.789
11.310
10.853
10.416
10.000
9.601
9.219
8.855
8.508
8.175
7.858
7.554
WIRING
Generic wiring all models
1
2
Normally open
Momentarily closed
Override button
4
Fig.3 Generic PL wall sensor wiring
Wiring terminal
Security screw
Fig. 3 PL wall sensor cover removal and wiring terminal location
B) Installation:
1- Remove security screw on the bottom of thermostat cover.
2- Open up by pulling on the bottom side of thermostat.
3- Pull out cables 6 out of the wall.
4- Wall surface must be flat and clean.
5- Insert cable in the central hole of the base.
6- Flip printed circuit board to access mounting hole
7- Align the base and mark the location of the two mounting
holes on the wall. Install proper side of base up.
8- Install anchors in the wall.
9- Insert screws in mounting holes on each side of the base.
DO NOT OVERTIGHTEN
10- Strip each wire 1/4 inch.
11- Insert each wire according to wiring diagram.
12- Gently push back into hole excess wring back into the wall.
13- Press back printed circuit board into place
Flip printed circuit
14- Install the cover, top side
board to access
15- Install security screw.
Wall Anchor
Security Screw
mounting hole
All PL series controls are for use as operating controls only and are not safety devices. These instruments have
undergone rigorous tests and verifications prior to shipment to ensure proper and reliable operation in the field.
Whenever a control failure could lead to personal injury and/or loss of property, it becomes the responsibility of the
user / installer / electrical panel designer to incorporate safety devices (such as relays, flow switch, thermal
protections, etc) and/or alarm systems to protect the entire system against such catastrophic failures. Any
abusive use of the product will void the warranty.
028-0108
PL-RSC_E
No part of this document may be photocopied or reproduced by any means, or translated to another language without prior written consent of Prolon.
All specifications are nominal and may change as design improvements are introduced.
Prolon shall not be liable for damages resulting from misapplication or misuse of its products.
All other trademarks are the property of their respective owners.