A Class I Incisor Relationship Is Defined by The British Standards Incisor Classification As Follows

A Class I incisor relationship is defined by the British Standards incisor classification as follows:
the lower incisor edges occlude with or lie immediately below the cingulum plateau of the upper
central incisors. Therefore Class I malocclusions include those where the anteroposterior
occlusal relationship is normal and there is a discrepancy either within the arches and/or in the
transverse or vertical relationship between the arches.
8.1. AETIOLOGY
8.1.1. Skeletal
In Class I malocclusions the skeletal pattern is usually Class I, but it can also be Class II or Class
III with the inclination of the incisors compensating for the underlying skeletal discrepancy (Fig.
8.1), i.e. dento-alveolar compensation. Marked transverse skeletal discrepancies between the
arches are more commonly associated with Class II or Class III occlusions, but milder transverse
discrepancies are often seen in Class I cases. Increased vertical skeletal proportions and anterior
open bite can also occur where the anteroposterior incisor relationship is Class I.
8.1.2. Soft tissues
In most Class I cases the soft tissue environment is favourable (for example resulting in dentoalveolar compensation) and is not an aetiological factor. The major exception to this is
bimaxillary proclination, where the upper and lower incisors are proclined. This may be racial in
origin and can also occur because lack of lip tonicity results in the incisors being moulded
forwards under tongue pressure.
Fig. 8.1. (a) Class I incisor relationship on Class I skeletal pattern; (b) Class I incisor relationship
on a Class II skeletal pattern; (c) Class I incisor relationship on a Class III skeletal pattern.
(a)
(b)
(c)
P.85
8.1.3. Dental factors
Dental factors are the main aetiological agent in Class I malocclusions. The most common are
tooth/arch size discrepancies, leading to crowding or, less frequently, spacing.
The size of the teeth is genetically determined and so, to a great extent, is the size of the jaws.
Environmental factors can also contribute to crowding or spacing. For example, premature loss
of a deciduous tooth can lead to a localization of any pre-existing crowding.
Local factors also include displaced or impacted teeth, and anomalies in the size, number, and
form of the teeth, all of which can lead to a localized malocclusion. However, it is important to
remember that these factors can also be found in association with Class II or Class III
malocclusions.
8.2. CROWDING
Crowding occurs where there is a discrepancy between the size of the teeth and the size of the
arches. Approximately 60 per cent of Caucasian children exhibit crowding to some degree. In a
crowded arch loss of a permanent or deciduous tooth will result in the remaining teeth tilting or
drifting into the space created. This tendency is greatest when the adjacent teeth are erupting.
Crowding can either be accepted or relieved. Before deciding between these alternatives the
following should be considered:
the position, presence, and prognosis of remaining permanent teeth;
the degree of crowding which is usually calculated in millimetres per arch or quadrant;
the patient's malocclusion and any orthodontic treatment planned, including anchorage
requirements;
the patient's age and the likelihood of the crowding increasing or reducing with growth;
the patient's profile.
These aspects of treatment planning are considered in more detail in Chapter 7, Sections 7.6 and
7.7.
In a Class I case with mild crowding (12 mm per quadrant) acceptance, or perhaps extraction of
second molars, should be considered unless a significant increase in crowding is anticipated. In
cases with moderate crowding (35 mm per quadrant) extraction of premolars is usually
indicated. Where the crowding is severe (more than 5 mm per quadrant) space maintenance is
definitely indicated prior to the extraction of, probably, the first premolars. Occasionally the
extraction of two teeth per quadrant is indicated, but this severity of crowding is the province of
the specialist.
After relief of crowding a degree of natural spontaneous movement will take place. In general,
this is greater under the following conditions:

A Class I Incisor Relationship Is Defined by The British Standards Incisor Classification As Follows

Uploaded by

Copyright:

Available Formats

A Class I Incisor Relationship Is Defined by The British Standards Incisor Classification As Follows

Uploaded by

Document Information

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

A Class I Incisor Relationship Is Defined by The British Standards Incisor Classification As Follows

Uploaded by

Copyright:

Available Formats

A Class I incisor relationship is defined by the British Standards incisor classification as follows:

the position, presence, and prognosis of remaining permanent teeth;

the patient's profile.

You might also like