Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                

Teltronic NEBULA PDF

Download as pdf or txt
Download as pdf or txt
You are on page 1of 2

NEBULA TETRA INFRASTRUCTURE

NEBULA

TETRA - INFRASTRUCTURE

Services supported

Main Technical Features

Mobility management
Registration/De-registration.
Cell reselection (handover).
Security class 3
Authentication (terminal and mutual).
Air Interface Encryption DCK.
Protocols TEA1, TEA2 & TEA3.
Over the air rekeying OTAR.
Enable/Disable.
E2EE, including Line Dispatcher or Telephone Gateway.
Voice services
Individual /Group, Semiduplex / Duplex, PABX/ PSTN,
Normal/Priority/Emergency
Multiple group management.
Main supplementary services:
Dynamic Group Number Assignment (DGNA).
Late Entry(LE).
Ambience Listening (AL).
Calling Line Identification (CLI).
Talking Party Identification (TPI).
Priority Call (PC).
Preemptive Priority Call (PPC).
Call Retention (CR).
Barring of Outgoing Calls (BOC).
Barring of Incoming Calls (BIC).
Data services
Status to individual or group address.
SDS (type 1, 2, 3 & 4) to individual or group address (with or without TL).
Simultaneous Status & SDS data on a voice call.
SCCH Secondary Control Channel.
Circuit Mode Data.
Packet Mode Data.

Available Links:
Synchronous:
- E1(G703/G704), V35, ISDN BRI(S/T), G703 codirectional.
Asynchronous:
- Level 2: VLAN, WLAN, WIMAX.
- Level 3: Low level Routers with IRB or L2TP (CISCO routers
from 1700).
Frequency Bands:
RX/TX: 350-370, 380-400, 410-430, 450-470 MHz (full band switching)
RX: 806 - 825 MHz / TX: 851 870 MHz
Processors:
CNC & NMS server: CompactPCI.
Other boards: RISC 32 bits (50 MIPS).
Transmitter (100% duty cycle)
Transmitted power: 40 W (46 dBm). Control from 0,6 to 40W in 2db steps
[32 W for the 350-370 MHz band]
Current consumption per carrier: 200W
Receiver
Receiver Class A. Diversity 2 and 3.
Typical Static/dynamic sensitivity: -117,5/-108,5 dBm.
Internal Synchronisation:
Internal OCXO. Frequency accuracy: 0,2 ppm (11 years maintenance
free)
Gateways
PABX / PSTN telephone.
3rd PARTY PORTAL. Enables connection of 3rd party applications.
Enables voice, status, SDS and packet data.
SMS to GSM.
VoIP for Line Dispatcher.
VoIP for Voice Recorder.
Remote maintenance Gateway.

professional personal communication

Modern Ethernet / IP
TETRA infrastructure

Teltronic conducts continous reseach and development for all products and therefore reserves the right to modify equipment

Polgono Malpica, Calle F-Oeste


50057 Zaragoza (Spain)
Tels. +34 976 465656 +34 902 418016
Fax +34 976 465720
www.teltronic.es
E-mail: cial@teltronic.es
nebula_ing_v4

TETRA Infrastructure

NEBULA TETRA INFRASTRUCTURE


SBS DIAGRAM

Distributed Switching
There is no need for a large
centralised Hardware Switch, as the
switching is distributed by Ethernet.
As a consequence the switch
capacity is scalable and very flexible.
And its easier to achieve the level
of redundancy required.

Acronysm
SCN: System Control Node
SBS: Site Base Station
CNC: Central Node Controller
SNI: Site Node Interface
NMS: Network Management System
MAM: Maintenance Alarm Module
BSR: Base Station Repeater
LSC: Local System Controller
N2A: NEBULA IP Interface Access

SCN DIAGRAM

Synchronous Links

ETHERNET / IP Architecture !!

Distributed intelligence
Intelligent carrier manages the
TETRA layer 2, and so enables:
- To support up to 32 carriers per
SBS
-And higher CNC capacity
Enhanced LSC (Local Site
Controller) in Fall Back mode
provides full voice and data services
with all the local carriers.
Telephone gateways can also be
located in SBS, providing distributed
telephone interconnection

No need for GPS or external sync


As only carriers are synchronous,
an internal SYNC board provides
the synchronisation required for a
multisite system (with handover and
roaming).
Additionally GPS can also be used
as an alternative synchronisation
signal.

CONNECTIVITY !!
Synchronous & asynchronous LINKS
(between the node and a site)
As a backbone its feasible to use the most
standard synchronous links, or as an
alternative new, asynchronous possibilities.
3rd. PARTY PORTAL
The powerful N2A protocol provides the
means to integrate applications from 3rd.
party companies, for voice and data.

Beyond the TETRA technology


With additional features and tools, to be
closer to customers and system integrators,
reducing the integration time of external
applications. For example:
- High efficiency AVL solutions.
- Circuit mode data for broadcasting pictures
or low scan video.
- E2EE (end to end encryption)giving highest
level of security, including interconnection
to Line Dispatchers and Telephone
gateways.

EASY & FRIENDLY !!


Modern VoIP Line Dispatcher &
Recorder
Digital & Intuitive Line Dispatcher
PC clients, with VoIP connection.
Digital & Friendly VoIP recorder.

Asynchronous Links

Friendly NMS Network


management system
NMS permits easy configuration and
maintenance of the system, even
remotely.
Hot Swapping & Plug & Play
Insert a new or changing a faulty
unit can accomplished in real time.

TETRA-Portfolio
Teltronic offers a full range of mobile,
portable, and dispatcher radio terminals
for voice and data transmision, as well as
professional solutions based on TETRA
technology.

You might also like