Design of Fit Between Die and Insert
Design of Fit Between Die and Insert
Design of Fit Between Die and Insert
ISSN:2277-1581
01 October 2016
Hand forging
Press forging.
ALTERNATIVE SOLUTION:
Based on operations.
1.
2.
Press dies
1.
INTRODUCTION
Up setter dies
Trimming dies
2.
Open die
Closed die
COMPANY PROFILE
doi : 10.17950/ijset/v5s10/1002
Page 457
ISSN:2277-1581
01 October 2016
Diameter of die= D
Diameter of insert= d
d=Dx1.0015
3.2.2
IJSET@2016
doi : 10.17950/ijset/v5s10/1002
Page 458
Limited, Mumbai
1210 kg.
25600 kg.
=80 blows/min.
IJSET@2016
= 610 mm.
Page 459
ISSN:2277-1581
01 October 2016
Crushing stress= total force/crushing area
Crushing area= Total force / crushing
Stress =17497470.19/(470*10^6)=0.0372m
Cost effective
Simple in assembling
Improve productivity.
4.1 Merits
Cost effective
Simple in assembling
Improve productivity
ACKNOWLEDGMENT.
REFERENCE.
i.
ii.
Steel & industrial forgings limited (sifl) athani. P.o, thrissur680581,kerala, india
IJSET@2016
doi : 10.17950/ijset/v5s10/1002
Page 460