Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                
Scribd Logo
Upload

Welcome to Scribd!

  • 16 views

    Properties Window Showing The Volume

    Uploaded by

    BillChayangkulTan
    The document provides specifications for two 3D modeling assignments: 1) Designing a coil spring with an outside diameter of 62mm, length of 280mm, pitch of 20mm over 14 coils, and wire diameter of 8mm. 2) Reproducing the given heat sink design without dimensions on the 3D model. Both assignments require printing a 3D view with properties window showing the volume.

    Copyright:

    © All Rights Reserved
    Download as DOCX, PDF, TXT or read online from Scribd

    Properties Window Showing The Volume

    Uploaded by

    BillChayangkulTan
    16 views2 pages
    The document provides specifications for two 3D modeling assignments: 1) Designing a coil spring with an outside diameter of 62mm, length of 280mm, pitch of 20mm over 14 coils, and wire diameter of 8mm. 2) Reproducing the given heat sink design without dimensions on the 3D model. Both assignments require printing a 3D view with properties window showing the volume.

    Original Title

    LW8 F16.docx

    Copyright

    © © All Rights Reserved

    Available Formats

    DOCX, PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    The document provides specifications for two 3D modeling assignments: 1) Designing a coil spring with an outside diameter of 62mm, length of 280mm, pitch of 20mm over 14 coils, and wire diameter of 8mm. 2) Reproducing the given heat sink design without dimensions on the 3D model. Both assignments require printing a 3D view with properties window showing the volume.

    Copyright:

    © All Rights Reserved
    Download as DOCX, PDF, TXT or read online from Scribd
    Download as docx, pdf, or txt
    16 views2 pages

    Properties Window Showing The Volume

    Uploaded by

    BillChayangkulTan
    The document provides specifications for two 3D modeling assignments: 1) Designing a coil spring with an outside diameter of 62mm, length of 280mm, pitch of 20mm over 14 coils, and wire diameter of 8mm. 2) Reproducing the given heat sink design without dimensions on the 3D model. Both assignments require printing a 3D view with properties window showing the volume.

    Copyright:

    © All Rights Reserved
    Download as DOCX, PDF, TXT or read online from Scribd
    Download as docx, pdf, or txt
    You are on page 1of 2

    University of California

    Mechanical Engineering Department


    E 26

    Lab. work #8 Spring and heat sink

    Fall 2016

    1 You are asked to design a spring assembly with the specifications given below. Create the 3D model of a
    spring with attachments at the ends as shown. Print the solid model, on a single page, oriented as shown in
    figure 1 below. Do not dimension the model. All dimensions are in mm. Printout a 3D view and include the
    Properties window showing the volume.
    The spring should have the following properties:
    Spring diameter (outside diameter) = 62 mm, length = 280 mm,
    Pitch (distance between each coil) = 20 mm (14 coils), and wire diameter = 8 mm

    13

    Front View
    Figure 1

    Detail of the top section

    Figure 1

    2 Reproduce the object (heat sink) shown below. Print out an isometric view as shown on one page with your
    name. Use the dimensions provided (mm) but do not dimension the 3D model. Printout a 3D view and include
    the Properties window showing the volume.

    ky

    Figure 1

    You might also like