Fosroc Cebex 100 0811

24
CI/SfB:
August 2011
Fosroc Cebex 100
constructive solutions
Expanding and plasticising grout admixture
Properties
Uses
Chloride content:
Cebex 100 is an admixture for site batched cementitious

grouts where a reduced water/cement ratio and positive expansion is required. Applications include bed grouting, duct
grouting, non-shrink infilling and jointing.
Advantages
Gaseous expansion system compensates for plastic
shrinkage and settlement in properly designed cementitious
grout.
Reduced water/cement ratio in the grout mix ensures low
permeability and long term durability in service.
Gives high grout fluidity with low water/cement ratio, thus
making placement or injection of the grout easy.
No metallic iron content to corrode and cause staining or
deterioration due to rust expansion in the grout.
Composition allows high early strength development in
grouts, without the use of chlorides.
Standard compliance
Cebex 100 is a suitable pre-stressing grout admixture when
complying with BS 8110 Part 1, 1997, Annex A.
Description
Cebex 100 is supplied as a powder admixture. The material
is a combination of a plasticising agent and a gas producing
expansion medium. The plasticising agent allows the use
of a reduced water/cement ratio with consequent increased
strengths and durability. The expansive medium counteracts
the natural settlement and plastic shrinkage of the grout and
aids stability and cohesion.
Sufficient restrained expansion is developed to ensure a high
degree of interfacial contact.
Specification clauses
Supplier specification
All grouting (specify details and areas of application) must be
carried out using a cement based grout, incorporating Cebex
100 manufactured by Fosroc and applied strictly in accordance
with the manufacturers technical data sheet.
Nil to BS 5075
Compressive
The plasticising action of
Strength:
Cebex 100 allows reduction of

the water/cement ratio of

cementitious grouts whilst

maintaining flow properties.

This gives improvement in

strength and long term

durability when cured under
restraint.
Setting times:

Cebex 100 does not

significantly affect the setting
times of cement based grouts.
Expansion
Character:

The controlled positive

expansion in unset grouts
incorporating Cebex 100
overcomes plastic settlement
when measured in
accordance with ASTM C827.
An unrestrained expansion of
up to 4% is typical.
Time for:
expansion:

15 minutes to 2 hours.
Temperatures over 20 o C
may slightly reduce these times.
Compatibility:

Cebex 100 is compatible with

all types of Portland cement.
Cebex 100 may be used in

mixes containing certain other
Fosroc admixtures. Consult
Fosroc for further information.
Instructions for use

Mixing
For best results a mechanically powered grout mixer must
be used. For quantities up to 50 kg a slow speed drill fitted
with a Conbextra mixing paddle is suitable. Larger quantities will require a high shear vane mixer. It is essential that
machine mixing capacity and labour availability is adequate to
enable the grouting operation to be carried out continuously.
This may require the use of a holding tank with provision
for gentle agitation to maintain fluidity. The selected water
content should be accurately measured into the mixer. Slowly
add the cement (and sand if required) and Cebex 100. Mix
continuously for 5 minutes, making sure that a smooth even
consistency is obtained.
Page 1
24
CI/SfB:
August 2011
Fosroc Cebex 100

Application
Storage
Areas to be grouted should be prepared to ensure substrates

are clean, sound, and then pre-wetted. The unrestrained
surface area of the grout must be kept to a minimum. Place
the grout within 20 minutes of mixing to gain the full benefit
of the expansion process. Adopt usual placing or pumping
procedures ensuring a continuous operation.
Cebex 100 has a shelf life of 12 months if kept in a dry store in

its original packaging. High temperature and humidity storage
may reduce this period.
Curing
On completion of the grouting operation, any exposed areas
which are not to be cut back should be thoroughly cured by
means of water application, Concure curing membrane or
wet hessian.
Precautions
Health and safety
For further information refer to appropriate Product Safety
Data Sheet.
Cleaning
Grouts mixed with Cebex 100 should be removed from tools
and equipment with clean water immediately after use. Remove
cured material mechanically or with Fosroc Acid Etch.
Estimating
Packaging
Cebex 100 is supplied in packs containing 24 x 227g units.
Dosage
OPC
Concreting
Water
Cebex Approx
sand
100
yield
50 kg
- 20 to 22 litres 227 g 36 litres
50 kg
50 kg
22 to 24 litres 227 g
57 litres
Note: For grout, mortar or concrete mixes with an aggregate/
cement ratio more than 1, use 4 x 227 g units of Cebex 100
per 100 kg of cement.
Effects of overdosing
Drastic overdosing of Cebex 100 increases expansion and
may cause frothing.
Fosroc and Cebex are trademarks of

Fosroc International Limited
Important note
Fosroc products are guaranteed against defective materials and manufacture and are sold subject to its standard Conditions for the
Supply of Goods and Services, copies of which may be obtained on request. Whilst Fosroc endeavours to ensure that any advice, recommendation, specification of information it may give is accurate and correct, it cannot, because it has no direct or continuous control over
where or how its products are applied, accept any liability either directly or indirectly arising from the use of its products, whether or not in
accordance with any advice, specification, recommendation of information given by it.
Fosroc Limited
Drayton Manor Business Park,
Coleshill Road, Tamworth,
Staffordshire B78 3TL. UK
telephone: fax:
+44 0 (1827) 262222
+44 0 (1827) 262444
email:
enquiryuk@fosroc.com
Certificate number FM 610
www.fosroc.com
Page 2

Fosroc Cebex 100 0811

Uploaded by

Copyright:

Available Formats

Fosroc Cebex 100 0811

Uploaded by

Document Information

Original Description:

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Fosroc Cebex 100 0811

Uploaded by

Copyright:

Available Formats

24

Fosroc Cebex 100

Expanding and plasticising grout admixture

Cebex 100 is an admixture for site batched cementitious

Cebex 100 does not

The controlled positive

Cebex 100 is compatible with

Cebex 100 may be used in

Instructions for use

Fosroc Cebex 100

Areas to be grouted should be prepared to ensure substrates

Cebex 100 has a shelf life of 12 months if kept in a dry store in

Fosroc and Cebex are trademarks of

You might also like