CEBEX300
CEBEX300
CEBEX300
Principal Application
Bed and duct cementitious grouting. The admixture must be aluminium-free and chloride-free
and shall be added to the grout in the proportions 225g of
Non-shrink cementitious in-filling and jointing. admixture per 50 kg of cement. The admixture shall provide
an expansion of 1-4% in the plastic grout by means of a
Non-metallic, high quality grouting.
gaseous system. The admixture must be stored, handled
and placed strictly in accordance with the manufacturer's
Key features instructions.
Gaseous expansion system eliminates plastic All grouting (specify details and areas of application) must
shrinkage. be carried out using a cement based grout incorporating
Cebex 300 manufactured by the Fosroc Group of
Low permeability ensures long term performance in Companies applied strictly in accordance with the
service. manufacturer's technical data sheet.
High fluidity provides easy placement by pouring or
injection. Performance technical data
No metallic iron.
Chloride content - Nil
Formulated for use in Middle East conditions.
Compressive strength
Product in brief Plasticising action in Cebex 300 provides a flowing grout
with low water/cement ratio. The addition of Cebex 300 can
Cebex 300 is supplied as a powder admixture for improve the compressive strength of cement based grouts
cementitious grouts and concrete. by approximately 15% when cured under restraint.
Page 1
Cebex 300
(Formerly known as Conbex 300)
Dosage 225 gm per 50 kg cement. Grouts mixed with Cebex 300 should be removed from tools
and equipment immediately after use with clean water.
Typical mixes Remove cured material mechanically or with Fosroc Acid
Etch.
OPC 5 mm sand Water Cebex Yield
content content 300 (approx.)
Precautions
50 kg - 18-22 ltr 225 g 36 ltr
50 kg 50 kg 20-24 ltr 225 g 57 ltr
Health and safety
Note: For grout, mortar or concrete mixes with an
aggregate/cement ratio more than 1 use 450 g When mixing grouts with Cebex 300, gloves should be
Cebex 300 per 50 kg of cement. worn. Splashes of grout to the skin or eyes should be
washed off with clean water. In the event of prolonged
Overdosing irritation seek medical advice.
Drastic overdosing of Cebex 300 increases expansion and Fire - Cebex 300 is non-flammable.
may cause frothing and reduced strength.
Mixing Storage
For best results a mechanically powered grout mixer must Cebex 300 has a shelf life of 12 months if kept in a dry store
be used. For quantities up to 50 kg a slow speed drill fitted in its original packaging. High temperature and humidity
with a high shear paddle is suitable. Larger quantities will storage may reduce this.
require a high shear vane mixer. It is essential that machine
mixing capacity and labour availability is adequate to enable Packaging
the grouting operation to be carried out continuously. This
may require the use of a holding tank with provision for Cebex 300 is supplied in packs containing:
gentle agitation to maintain fluidity.
225 g units Other forms of packaging may be
The selected water content should be accurately measured or 5 kg units available for special orders
into the mixer. Slowly add the cement (and sand if required)
and Cebex 300. Mix continuously for 5 minutes making
sure that a smooth even consistency is obtained. Supply
On completion of the grouting operation exposed areas Cebex 300 is one of a wide range of grouting products
which are not to be cut back should be thoroughly cured by specially developed and manufactured by Fosroc for the
means of water application, Concure curing membrane or construction, civil engineering and mining industries. Other
wet hessian. product ranges include admixtures, curing membranes,
repair mortars, adhesives, protective coatings, anchoring
resins and joint sealants.
Important note:
Fosroc products are guaranteed against defective materials and manufacture and are sold subject to its standard Conditions
for the Supply of Goods and Services, copies of which may be obtained on request. Whilst Fosroc endeavours to ensure that
any advice, recommendation, specification of information it may give is accurate and correct, it cannot, because it has no direct
or continuous control over where or how its products are applied, accept any liability either directly or indirectly arising from the
use of its products, whether or not in accordance with any advice, specification, recommendation of information given by it.
Registered Office: Industrial Area, Phase 4, Road No. 414, Street No. 407
Page 2 FO SA/CEBEX 300/07/03/A