Method Statement FOR Acoustic Ceiling Tiles
Method Statement FOR Acoustic Ceiling Tiles
FOR
Acoustic Ceiling Tiles
Revisions Details:
Rev.
0
Date of
Issue
Prepared
6/15/2011
AH
Originator:
Reviewed
Engineering
QA/QC
Manager
Manager
Approved
Project Director
Description
Date of issue:
Page No. 1 of 12
Identification
Document Number
Contract No.
Location
---
AUD.
Discipline
Issuer
Doc. Type
AH
MS
Number
Rev.
CONTENTS
Sr.
Subject
Page No.
1.0
Scope
2.0
Reference
3.0
General
4.0
Resources
4.1
Materials List
5.0
Installation Procedure
6.0
Safety
1. SCOPE:
This Method Statement provides the control sequence of construction and methodology that
will be used for the installation of acoustic ceiling tiles supplied by M/s OPTIMA
INTERNATIONAL.
2. REFERENCES:
o Submitted technical submittal for acoustic treatment.
o Approved drawings.
3. GENERAL:
Installation is to be in accordance with the drawings, project specifications and the product
manufacturers recommendations.
4. RESOURCES:
4.1. Material List:
Acoustic ceiling tiles.
Ceiling grid system components
INSTALLATION PROCEDURE:
Product information;
Product name : suspending ceiling T24 bearing system
Product Code: T24 main bearing (3,6m), auxiliary bearing (0.6, 1.2mm), side profile L (3.0m)
Product name: glass wool panel
Sequence of Montage
1- Specififying reference point according to basement.
2- According to reference point, frame with 3000 mm length is mounted to the wall.
8mm screw mounted to
brace clamp
Brace clamp
Brace clamp
3- To fix the rib structure which will be formed by using profiles and to balance the
montage, firstly expansion bolts are mounted to ceiling with 60 -120cm gap distance.(1)
4- Suspensions (made of galvanized steel wire) are passed through the hole of expansion
bolt. In order to get the exact balance; 2. suspension stick is connected to bearing system
by the help of lever adjustment component which has double spring. Here, suspension
stick may be cut by using steel truss to meet the system.
Double Spring
Existing ceiling
Existing wall
Aluminium T profile
Example;
6- Suspending system starts with main bearing. there is no any screwing in the joint.
7- Auxiliary bearings(1200x600mm ) should be mounted in accordance with the sizes across main bearings
8- In order to get the balance of rib structure (grid) ;suspension system is mounted to the main bearing by the
holes on the main bearing.
Suspending
stick
Double
spring
Existing
ceiling
Suspending kit
Level adjusting
spring
Aluminium T profile
Aluminium T profile
Suspended ceiling panel for insulation
10- Tiles/panels may be shaped easily by cutting if the montage place has smaller dimensions than 60x60
mm.
11- Joints should be in the same level while locating the panels.
Correct joint
Wrong joint
SAFETY:
Proper scaffolding shall be used and safety harness to be used and secured, if
required.
All personal protective equipment shall be used as appropriate according to
the nature of the job.