Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                
Scribd Logo
Upload

Welcome to Scribd!

  • 144 views

    Helicoil Technical Informations

    Uploaded by

    agox194
    Helicoil Technical Informations

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd

    Helicoil Technical Informations

    Uploaded by

    agox194
    144 views1 page
    Helicoil Technical Informations

    Copyright

    © © All Rights Reserved

    Available Formats

    PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    Helicoil Technical Informations

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    144 views1 page

    Helicoil Technical Informations

    Uploaded by

    agox194
    Helicoil Technical Informations

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    of 1

    Technical information

    HELICOIL Plus thread inserts

    Free Running Screwlock


    W W
    notch notch

    d1

    d1
    tang tang

    W and d1 are the control values for thread inserts (Free Running and Screwlock)
    before they have been installed. The length can only be measured for installed thread
    inserts.

    Holding thread Assembly

    Prior to tapping, counter-bore 90 and deburr.


    Outside diameter of countersink = DHC + 0.1 mm.

    d = Nominal thread diameter t1 = Minimum depth of tapped hole according to


    P = Thread pitch DIN 76 Part 1 (guide value)
    d1 = Outside diameter of thread insert prior to installa- t2 = The nominal length of the thread insert corre-
    tion sponds to the minimum length of the full parent
    thread for blind holes or the minimum plate
    W = Number of threads prior to installation thickness for a through hole.
    DHC = Outside diameter of the parent thread t3 = Maximum screw-in depth when the tang is not
    D1HC = Crest diameter removed
    B = Suitable twist drill diameter. Please note: t5 = Distance of the thread insert from the joint face =
    D1HC is critical for selecting the correct twist drill 0.25 to 0.5 P, if t2 corresponds to the above-
    diameter. mentioned minimum value

    When you use HELICOIL Plus thread inserts for volume production, we recommend to add at least
    1 x P to values t1 and t2.

    Bllhoff Group
    Subject to technical change. Reprinting, even in extract form, only permitted Please find your local contact on www.boellhoff.com
    with express consent.Observe protective note according to ISO 16016. or contact us under info@boellhoff.com

    You might also like