Chapter 6 Rate of Return Analysis: ROR Calculation
Chapter 6 Rate of Return Analysis: ROR Calculation
Chapter 6 Rate of Return Analysis: ROR Calculation
Hello Class, we are moving right along. We have only 3 chapters to go. While the last
one was relatively easy, this chapter requires a little work. You are finally getting to the
point where you know enough to start analyzing projects. The Rate of Return (ROR) is
sometimes called the Internal Rate of Return (IRR), Return on Investment (ROI) and
Profitability Index (PI). Rate of Return is the rate paid on the unpaid balance of an
investment so that the final payment brings the balance exactly to zero with interest
considered. The rate of return is expressed as a percentage per period. (-100% < i <
.
A return of -100% means the entire investment is lost. The definition above does not
state that the rate of return is on the initial amount of the investment, but rather it is on
the unrecovered balance and varies from period to period. Review example on page
144 145 to understand this concept. Table 6.2 if the 10% return is always figured on
the initial investment of $1000. Column six in year 4 shows a remaining unrecovered
amount of $138.12 is recovered in the 4th year.
ROR Calculation
The Rate of Return and Present Worth are set up exactly the same. The only
differences are what is given and what is sought. The PW based ROR equation is
generalized by:
0 = PWD + PWR
Multiple alternatives have a different solution. They are explained 6.5. I will also
covered later in this lecture
You may also obtain one or more i values. This is covered in 6.6 and 6.7 in your book.
Please read and know what reinvestment of i * for ROR on page 148. Be careful,
remember to reinvest any leftover capital at the MARR rate. The write up on Page 139
140 Proves that the project with the highest interest rate is not always the best choice.
This is because we have to use any leftover capital and invest it at the MARR.
When considering ROR analysis for more than one alternative, you need to understand
the following:
Alternatives must have equal lives. Select the one that has the longest life. (make sure
that you go to at least one cycle then restructure the cash flow of the second so that it
emulates the same n. If they are unequal adjust using the LCM (Least Common
Multiple)
When doing incremental Analysis for two projects set up a table as shown below. Table
6.4 in your book
Notice that if you take the difference used press total and subtract the new press total,
the will equal the increments total. This will always be and will act as a check for you.
Once the cash flows are tabulated determine the incremental rate of return on the extra
amount by the larger investment amount (when there is cash left over) required by the
larger investment alternative, (See table 6.5). noticed how the cash flow for A goes to 3
years twice so that it can equal the 6 year period of B. t* represents the return over n
years.
This will make problems long and arduous. Make sure that you list all values. It is easy
to make mistakes in this type of calculation. Pay attention to signs.
There is a unique, real number, i* value for a conventional series. A non conventional
series ( table 6-10) has more than one sign change and multiple roots may exist.
When applying this rule zero cash flow values are disregarded. Problem 6,8 is a good
example to know and understand.
Read the section on using spreadsheet and calculator functions. They will make your
life a lot easier.
Good summary on this chapter on page 170. Do yourself a favor and read it.