Product Specifications

RVV2NPX310.211R
Multiband Antenna, 694960 MHz 65 horizontal beamwidth, 2x 1695-2690 MHz 65
horizontal beamwidth and dual beam 1695-2180 MHz 33 horizontal beamwidth,
internal electrical tilt with manual override. Bands cascaded SRET
l Integrated Internal Remote Electrical Tilt (RET), with independent control of electrical
tilt with manual override on all arrays

l All Internal RET actuators are connected in Cascaded SRET configuration

Electrical Specifications
HB Dual HB Dual
LB LB LB HB HB HB
Beam2 Beam2
694 790 890 1695 1920 2300
Frequency Band, MHz 16951920 19202180
790 890 960 1920 2180 2690
Gain, dBi 16.2 16.5 16.7 17.5 18.2 18.8 17.2 18.8
Beam Centers, Horizontal, degrees 31 28
Beamwidth, Horizontal, degrees 69 68 68 62 62 61 36 32
Beamwidth, Vertical, degrees 10.1 8.9 8.3 7.5 6.7 5.5 7.7 6.9
Beam Tilt, degrees 010 010 010 010 010 010 010 010
USLS (First Lobe), dB 18 18 18 18 18 18 18 18
Null Fill, dB -22 -22 -22 -22 -22 -22 -22 -22
Front-to-Back Ratio at 180, dB 31 33 34 35 38 38 28 33
Front-to-Back Total Power at 180
27 27 27 27 27 29 24 27
30, dB
Isolation, dB 28 28 28 30 30 30 25 25
Isolation, Beam to Beam, dB 18 18
1.5 | 1.5 | 1.5 |
VSWR | Return Loss, dB 14.0 14.0 14.0
1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.43 | 15.0 1.43 | 15.0

PIM, 3rd Order, 2 x 20 W, dBc -150 -150 -150 -150 -150 -150 -150 -150
Input Power per Port, maximum,
300 300 300 250 250 250 250 250
watts
Polarization 45 45 45 45 45 45 45 45
Impedance 50 ohm 50 ohm 50 ohm 50 ohm 50 ohm 50 ohm 50 ohm 50 ohm

Electrical Specifications, BASTA*

Frequency Band, 1695 1920 2300 1695 1920
694790 790890 890960
MHz 1920 2180 2690 1920 2180
Gain by all Beam
15.9 16.4 16.6 17.1 17.9 18.3 16.4 18.4
Tilts, average, dBi
Gain by all Beam
0.5 0.2 0.2 0.6 0.4 0.6 1.2 0.6
Tilts Tolerance, dB
0 | 15.9 0 | 16.4 0 | 16.6 0 | 17.1 0 | 18.0 0 | 18.3 0 | 16.4 0 | 18.4
Gain by Beam Tilt,
5 | 15.9 5 | 16.4 5 | 16.7 5 | 17.1 5 | 18.0 5 | 18.3 5 | 16.3 5 | 18.4
average, dBi
10 | 15.9 10 | 16.5 10 | 16.5 10 | 17.2 10 | 17.8 10 | 18.2 10 | 16.4 10 | 18.3

Beamwidth,
Horizontal 0.8 0.6 1 2.9 2.8 5.8 2 2.3
Tolerance, degrees
Beamwidth, Vertical
0.6 0.4 0.3 0.5 0.5 0.4 0.4 0.4
Tolerance, degrees
USLS, beampeak to
20 above 18 18 18 18 18 18 18 18
beampeak, dB
CPR at Boresight, dB 15 16 16 20 20 20 12 10
CPR at Sector, dB 11 11 13 11 11 8 7 5

* CommScope supports NGMN recommendations on Base Station Antenna Standards (BASTA). To learn more about the benefits of BASTA,
download the whitepaper Time to Raise the Bar on BSAs.

2017CommScope, Inc. All rights reserved. All trademarks identified by or are registered trademarks, respectively, of CommScope.
All specifications are subject to change without notice. See www.commscope.com for the most current information. Revised: November 30, page 1 of 5
2016 March 1, 2017
Product Specifications
RVV2NPX310.211R

Array Layout

General Specifications
Operating Frequency Band 1695 2180 MHz | 1695 2690 MHz | 694 960 MHz
Antenna Type Sector
Band Multiband
Performance Note Outdoor usage

Mechanical Specifications
RF Connector Quantity, total 10
RF Connector Quantity, low band 2

2017CommScope, Inc. All rights reserved. All trademarks identified by or are registered trademarks, respectively, of CommScope.
All specifications are subject to change without notice. See www.commscope.com for the most current information. Revised: November 30, page 2 of 5
2016 March 1, 2017
Product Specifications
RVV2NPX310.211R

RF Connector Quantity, high band 8

RF Connector Interface 7-16 DIN Female
Grounding Type RF connector inner conductor and body grounded to reflector and
mounting bracket
Radiator Material Low loss circuit board
Radome Material Fiberglass, UV resistant
Reflector Material Aluminum
RF Connector Location Bottom
Wind Loading, frontal 1248.0 N @ 150 km/h
280.6 lbf @ 150 km/h
Wind Loading, lateral 389.0 N @ 150 km/h
87.5 lbf @ 150 km/h
Wind Loading, rear 1298.0 N @ 150 km/h
291.8 lbf @ 150 km/h
Wind Speed, maximum 241 km/h | 150 mph

Dimensions
Length 2763.5 mm | 108.8 in
Width 350.0 mm | 13.8 in
Depth 208.0 mm | 8.2 in
Net Weight, without mounting kit 46.1 kg | 101.6 lb

Remote Electrical Tilt (RET) Information

Input Voltage 1030 Vdc
Internal RET High band (4) | Low band (1)
Power Consumption, idle state, maximum 2.0 W
Power Consumption, normal conditions, maximum 13.0 W
Protocol 3GPP/AISG 2.0 (Single RET)
RET Interface 8-pin DIN Female | 8-pin DIN Male
RET Interface, quantity 1 female | 1 male

Packed Dimensions
Length 2985.0 mm | 117.5 in
Width 436.0 mm | 17.2 in
Depth 320.0 mm | 12.6 in
Shipping Weight 68.5 kg | 151.0 lb

Regulatory Compliance/Certifications
Agency Classification
RoHS 2011/65/EU Compliant by Exemption
China RoHS SJ/T 11364-2006 Above Maximum Concentration Value (MCV)
ISO 9001:2008 Designed, manufactured and/or distributed under this quality management system

2017CommScope, Inc. All rights reserved. All trademarks identified by or are registered trademarks, respectively, of CommScope.
All specifications are subject to change without notice. See www.commscope.com for the most current information. Revised: November 30, page 3 of 5
2016 March 1, 2017
Product Specifications
RVV2NPX310.211R

Included Products
T-029-GL-E Adjustable Tilt Pipe Mounting Kit for 2.0"-4.5" (50-115mm) OD round members for panel antennas. Includes
2 clamp sets.

* Footnotes
Performance Note Severe environmental conditions may degrade optimum performance

2017CommScope, Inc. All rights reserved. All trademarks identified by or are registered trademarks, respectively, of CommScope.
All specifications are subject to change without notice. See www.commscope.com for the most current information. Revised: November 30, page 4 of 5
2016 March 1, 2017
Product Specifications
T-029
029--GL
GL--E
Adjustable Tilt Pipe Mounting Kit for 2.0"-4.5" (50-115mm) OD round members for
panel antennas. Includes 2 clamp sets.

General Specifications
Mount Type Pipe mounts
Application Outdoor
Includes Brackets | Hardware
Package Quantity 1

Mechanical Specifications
Color Silver
Material Type Galvanized steel
Mechanical Tilt 08

Dimensions
Antenna-to-Pipe Distance 85.0 mm | 3.3 in
Bracket-to-Bracket Distance 1400.0 mm | 55.1 in
Compatible Diameter, maximum 115.0 mm | 4.5 in
Compatible Diameter, minimum 50.0 mm | 2.0 in
Compatible Length, maximum 2850.0 mm | 112.2 in
Compatible Length, minimum 1500.0 mm | 59.1 in
Net Weight 6.0 kg | 13.2 lb

Regulatory Compliance/Certifications
Agency Classification
RoHS 2011/65/EU Compliant by Exemption
China RoHS SJ/T 11364-2006 Above Maximum Concentration Value (MCV)
ISO 9001:2008 Designed, manufactured and/or distributed under this quality management system

2017CommScope, Inc. All rights reserved. All trademarks identified by or are registered trademarks, respectively, of CommScope. page 5 of 5
All specifications are subject to change without notice. See www.commscope.com for the most current information. Revised: November 5, 2016 March 1, 2017