RVVPX310R-V

6-port sector antenna, 2x 698–960 and 4x 1710–2690 MHz, 65° HPBW,

3x RET with manual override. Bands cascaded SRET.
l Integrated Internal Remote Electrical Tilt (RET), with independent control of electrical tilt with manual
override on all arrays

l All Internal RET actuators are connected in “Cascaded SRET

SRET”” configuration

Electrical Specifications
Frequency Band, MHz 698–790 790–890 890–960 1710–1920 1920–2170 2300–2690
Gain, dBi 15.2 16.0 16.5 16.0 17.0 17.4
Beamwidth, Horizontal, degrees 71 68 62 67 61 59
Beamwidth, Vertical, degrees 9.9 8.8 7.8 8.5 7.4 6.0
Beam Tilt, degrees 0– 10 0– 10 0– 10 0– 10 0– 10 0– 10
USLS (First Lobe), dB 18 16 16 18 18 18
Null Fill, dB -22 -22 -22 -22 -22 -22
Front
Front--to
to--Back Ratio at 180°, dB 35 35 31 31 34 34
CPR at Boresight, dB 14 17 16 17 20 13
CPR at Sector, dB 10 14 10 15 10 1
Isolation, dB 25 25 25 25 25 25
Isolation, Intersystem, dB 30 30 30 30 30 30
VSWR | Return Loss, dB 1.43 | 15.0 1.43 | 15.0 1.43 | 15.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0
PIM, 3rd Order, 2 x 20 W, dBc -150 -150 -150 -150 -150 -150
Input Power per Port, maximum,
300 300 300 250 250 250
watts
Polarization   ±45° ±45° ±45° ±45° ±45° ±45°
Impedance   50 ohm 50 ohm 50 ohm 50 ohm 50 ohm 50 ohm

Electrical Specifications, BASTA*

Frequency Band, MHz 698–790 790–890 890–960 1710–1920 1920–2170 2300–2690
Gain by all Beam Tilts, average, dBi 15.1 15.8 16.1 15.8 16.9 17.2
Gain by all Beam Tilts Tolerance,
±0.7 ±0.5 ±0.4 ±0.8 ±0.8 ±0.9
dB
0 ° | 14.9 0 ° | 15.6 0 ° | 16.0 0 ° | 15.9 0 ° | 17.0 0 ° | 17.3
Gain by Beam Tilt, average, dBi 5 ° | 15.2 5 ° | 15.9 5 ° | 16.2 5 ° | 15.8 5 ° | 16.9 5 ° | 17.3
10 ° | 15.3 10 ° | 15.9 10 ° | 16.2 10 ° | 15.8 10 ° | 16.7 10 ° | 17.1
Beamwidth, Horizontal Tolerance,
±1.3 ±2.4 ±2.4 ±3.9 ±4.1 ±5.5
degrees
Beamwidth, Vertical Tolerance,
±0.7 ±0.5 ±0.2 ±0.8 ±0.6 ±0.6
degrees
USLS, beampeak to 20° above
18 17 17 18 18 18
beampeak, dB
Front
Front--to
to--Back Total Power at 180°
27 27 22 30 31 33
± 30°, dB
CPR at Boresight, dB 15 18 16 17 20 14
CPR at Sector, dB 10 14 9 15 11 1

* CommScope
CommScope® ® supports NGMN recommendations on Base Station Antenna Standards (BASTA). To learn more about the benefits of BASTA, download the
whitepaper Time to Raise the Bar on BSAs.

page 1 of 4
October 24, 2018

©2018 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope.All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: February 12, 2018
RVVPX310R-V

Array Layout

page 2 of 4
October 24, 2018

©2018 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope.All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: February 12, 2018
RVVPX310R-V

General Specifications
Operating Frequency Band 1710 – 2690 MHz   |   698 – 960 MHz
Antenna Type Sector
Band Multiband
Performance Note Outdoor usage
 

Mechanical Specifications
RF Connector Quantity, total 6
RF Connector Quantity, low band 2
RF Connector Quantity, high band 4
RF Connector Interface 7-16 DIN Female
Grounding Type RF connector inner conductor and body grounded to reflector and mounting bracket
Radiator Material Aluminum   |   Low loss circuit board
Radome Material ASA, UV stabilized
Reflector Material Aluminum
RF Connector Location Bottom
Wind Loading, frontal 844.0 N @ 150 km/h
189.7 lbf @ 150 km/h
Wind Loading, lateral 605.0 N @ 150 km/h
136.0 lbf @ 150 km/h
Wind Speed, maximum 250 km/h   |   155 mph
 

Dimensions
Length 2490.0 mm   |   98.0 in
Width 296.0 mm   |   11.7 in
Depth 244.0 mm   |   9.6 in
Net Weight, without mounting kit 29.0 kg   |   63.9 lb
 

Remote Electrical Tilt (RET) Information

Input Voltage 10–30 Vdc
Internal RET High band (2)   |   Low band (1)
Power Consumption, idle state, maximum 2W
Power Consumption, normal conditions, maximum 13 W
Protocol 3GPP/AISG 2.0 (Single RET)
RET Interface 8-pin DIN Female   |   8-pin DIN Male
RET Interface, quantity 1 female   |   1 male
 

Packed Dimensions
page 3 of 4
October 24, 2018

©2018 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope.All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: February 12, 2018
RVVPX310R-V

Length 2677.0 mm   |   105.4 in

Width 374.0 mm   |   14.7 in
Depth 363.0 mm   |   14.3 in
Shipping Weight 54.0 kg   |   119.0 lb

Regulatory Compliance/Certifications
Agency Classification
RoHS 2011/65/EU Compliant by Exemption
China RoHS SJ/T 11364-2006 Above Maximum Concentration Value (MCV)
ISO 9001:2008 Designed, manufactured and/or distributed under this quality management system

Included Products
T -029
029--GL
GL--E — Adjustable Tilt Pipe Mounting Kit for 2.0"
2.0"--4.5" (50
(50--115mm) OD round members for panel antennas. Includes 2 clamp sets.

* Footnotes
Performance Note Severe environmental conditions may degrade optimum performance

page 4 of 4
October 24, 2018

©2018 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope.All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: February 12, 2018