R2V2PX310R

8-port sector antenna, 4x 694–960 and 4x 1710–2690 MHz, 65° HPBW,

4x RET with manual override.
l Integrated Internal Remote Electrical Tilt (RET), with independent control of electrical tilt with manual
override on all arrays

l All Internal RET actuators are connected in “Cascaded SRET

SRET”” configuration

OBSOLETE
This product was discontinued on: December 31, 2018
Replaced By
RRVV
RRVV--65D
65D--R4 8-port sector antenna, 4x 694
694––960 and 4x 1695
1695––2690 MHz, 65° HPBW, 4x RET

Electrical Specifications
Frequency Band, MHz 694–790 790–890 890–960 1710–1920 1920–2170 2300–2690
Gain, dBi 15.9 16.4 16.7 16.1 17.3 17.7
Beamwidth, Horizontal, degrees 64 62 59 61 58 58
Beamwidth, Vertical, degrees 10.2 8.9 8.1 8.4 7.4 5.9
Beam Tilt, degrees 0– 10 0– 10 0– 10 0– 10 0– 10 0– 10
USLS (First Lobe), dB 16 16 15 18 18 18
Front
Front--to
to--Back Ratio at 180°, dB 32 33 32 31 32 35
CPR at Boresight, dB 15 21 20 22 20 10
CPR at Sector, dB 10 13 12 13 10 4
Isolation, Cross Polarization, dB 25 25 25 25 25 25
Isolation, Inter
Inter--band, dB 28 30 30 27 28 30
VSWR | Return Loss, dB 1.43 | 15.0 1.43 | 15.0 1.43 | 15.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0
PIM, 3rd Order, 2 x 20 W, dBc -150 -150 -150 -150 -150 -150
Input Power per Port, maximum,
300 300 300 250 250 250
watts
Polarization   ±45° ±45° ±45° ±45° ±45° ±45°
Impedance   50 ohm 50 ohm 50 ohm 50 ohm 50 ohm 50 ohm

Electrical Specifications, BASTA*

Frequency Band, MHz 694–790 790–890 890–960 1710–1920 1920–2170 2300–2690
Gain by all Beam Tilts, average, dBi 15.5 16.1 16.3 15.9 16.9 17.7
Gain by all Beam Tilts Tolerance,
±0.5 ±0.3 ±0.3 ±0.6 ±0.5 ±0.6
dB
0 ° | 15.5 0 ° | 16.1 0 ° | 16.4 0 ° | 15.9 0 ° | 17.0 0 ° | 17.7
Gain by Beam Tilt, average, dBi 5 ° | 15.5 5 ° | 16.0 5 ° | 16.3 5 ° | 15.9 5 ° | 16.9 5 ° | 17.7
10 ° | 15.5 10 ° | 16.1 10 ° | 16.3 10 ° | 16.0 10 ° | 16.7 10 ° | 17.6
Beamwidth, Horizontal Tolerance,
±2.3 ±2.3 ±2.4 ±2.8 ±2.6 ±4.8
degrees
Beamwidth, Vertical Tolerance,
±0.7 ±0.5 ±0.3 ±0.6 ±0.6 ±0.6
degrees
USLS, beampeak to 20° above
16 16 15 18 19 19
beampeak, dB

page 1 of 3
June 13, 2019

©2019 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope.All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: January 22, 2019
R2V2PX310R

Front
Front--to
to--Back Total Power at 180°
26 27 25 29 30 30
± 30°, dB
CPR at Boresight, dB 16 23 20 26 20 12
CPR at Sector, dB 10 13 10 14 11 4

* CommScope
CommScope® ® supports NGMN recommendations on Base Station Antenna Standards (BASTA). To learn more about the benefits of BASTA, download the
whitepaper Time to Raise the Bar on BSAs.

General Specifications
Operating Frequency Band 1710 – 2690 MHz   |   694 – 960 MHz
Antenna Type Sector
Band Multiband
Performance Note Outdoor usage
 

Mechanical Specifications
RF Connector Quantity, total 8
RF Connector Quantity, low band 4
RF Connector Quantity, high band 4
RF Connector Interface 7-16 DIN Female
Grounding Type RF connector inner conductor and body grounded to reflector and mounting
bracket
Radiator Material Brass   |   Low loss circuit board
Radome Material ASA, UV stabilized
Reflector Material Aluminum
RF Connector Location Bottom
Wind Loading, frontal 2008.0 N @ 150 km/h
451.4 lbf @ 150 km/h
Wind Loading, lateral 460.0 N @ 150 km/h
103.4 lbf @ 150 km/h
Wind Speed, maximum 250 km/h   |   155 mph
 

Dimensions
Length 2490.0 mm   |   98.0 in
Width 641.0 mm   |   25.2 in
Depth 244.0 mm   |   9.6 in
Net Weight, without mounting kit 60.0 kg   |   132.3 lb
 

Remote Electrical Tilt (RET) Information

Input Voltage 10–30 Vdc
Internal RET High band (2)   |   Low band (2)
Power Consumption, idle state, maximum 2W

page 2 of 3
June 13, 2019

©2019 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope.All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: January 22, 2019
R2V2PX310R

Power Consumption, normal conditions, maximum 13 W

Protocol 3GPP/AISG 2.0 (Single RET)
RET Interface 8-pin DIN Female   |   8-pin DIN Male
RET Interface, quantity 2 female   |   2 male
 

Packed Dimensions
Length 2677.0 mm   |   105.4 in
Width 719.0 mm   |   28.3 in
Depth 363.0 mm   |   14.3 in
Shipping Weight 90.0 kg   |   198.4 lb

Regulatory Compliance/Certifications
Agency Classification
RoHS 2011/65/EU Compliant by Exemption
ISO 9001:2015 Designed, manufactured and/or distributed under this quality management system
China RoHS SJ/T 11364-2014 Above Maximum Concentration Value (MCV)

Included Products
T -029
029--GL
GL--E — Adjustable Tilt Pipe Mounting Kit for 2.0"
2.0"--4.5" (60
(60--115mm) OD round members for panel antennas. Includes 2 clamp sets.

ATCB B01--C50 — AISG RET Control Cable, 0.5 m

ATCB--B01

* Footnotes
Performance Note Severe environmental conditions may degrade optimum performance

page 3 of 3
June 13, 2019

©2019 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope.All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: January 22, 2019