Rev:

Units
C
14.6L 14.6L
Std Metric 1500 1800
General Engine Data
Type N/A V-type 4 cycle
Number of cylinders N/A 8
Aspiration N/A Turbo Charge Air Cooled
Bore in mm 5.04 128 5.04 128
Stroke in mm 5.59 142 5.59 142
Displacement in^3 L 892 14.6 892 14.6
Compression Ratio N/A 10.5
Mean Piston Speed ft/min m/s 1398 7.1 1677 8.52
Gross Standby Power Rating1,2,3 Per ISO 3046 at the Flywheel
NG Hp kW 339 253 459 342
LP Hp kW 229 171 319 238
MEP (@ rated Load on NG) psi bar 201 13.8 226 15.6
MEP (@ rated Load on LP) psi bar 136 9.4 157 10.9
Gross Prime Power Rating1,2,3 Per ISO 3046 at the Flywheel
NG Hp kW 305 228 390 291
LP Hp kW 206 154 271 202
MEP (@ rated Load on NG) psi bar 181 12.5 192 13.3
MEP (@ rated Load on LP) psi bar 122 8.4 134 9.2
RPM Range (Min-Max) RPM 1500-1800
Rotation Viewed from Flywheel N/A Counter Clockwise
Firing Order N/A 1-5-7-2-6-3-4-8-1
Dry Weight
Fan to Flywheel lb kg 3150 1429 3150 1429
Rad to Flywheel lb kg 4450 2018 4450 2018
Wet Weight
Fan to Flywheel lb kg 3291 1475 3291 1475
Rad to Flywheel lb kg 4757 2155 4757 2155
CG
Distance from FW housing in mm 18 449 18 449
Distance above center of crankshaft in mm 6 159 6 159
Engine Mounting
Maximum Allowable Bending Moment at Rear of Block lb ft Nm 4425 6000 4425 6000
Moment of Inertia About Roll Axis lb ft^2 kg m^2
Flywheel housing N/A SAE No.1
Flywheel N/A No. 14
Number of Flywheel Teeth N/A 160
Exhaust System
Type Water Cooled Manifold
Maximum allowable Back pressure in HG kPa 3 10.2 3 10.2
Standard Catalyst Back pressure in HG kPa 1.5 5.1 1.5 5.1
Exhaust Outlet Pipe Size
Maximum Turbine Inlet Temperature F C 1382 750 1382 750
Exhaust Flow at Rated Power lb/hr kg/hr 2094 950 2782 1301
Exhaust Flow at Rated Power @1350F cfm m^3/min 1596 45.2 1895 53.6
Air Induction System
Maximum allowable Intake Air Restriction with Air Cleaner
Clean inH2O kPa 5 1.24 5 1.24
Dirty inH2O kPa 15 3.74 15 3.74
Combustion Air required (entire engine) lb/hr kg/hr 1975 896 2625 1227
Combustion Air required (entire engine) cfm m^3/min 502 14 687 19

10 11/2/2015
 Rev:
Units
C
14.6L 14.6L
Std Metric 1500 1800
Electrical System
Minimum Recommended Battery Capacity AH 200
Cold Cranking Current
Engine only CCA 1000
Engine with Drive train CCA 1000
Maximum Allowable Resistance of Starting Circuit Ohms 0.002
Starting Motor Power HP kW 9.4 7 9.4 7
Battery Charging Alternator
Voltage Volts 24
Current Amps 45
Coil primary Resistance Ohms 
Spark Plug p/n IFR7F-4D
Spark plug gap inches mm .015" (-0/+.008") .38mm (-0/+.2mm)
Cooling System
Coolant Capacity
Engine only gal L 9.5 43.2 9.5 43.2
Engine with Radiator gal L 28 127 28 127
Engine Coolant Flow gal/min L/min 151 570 180 680
Water Pump Speed RPM 2547 3056
Heat rejected to Cooling water at rated Load btu/min kcal/sec 13094 55 16189 68
Maximum Intake Air Temperature (IAT) F C 155 68 155 68
ECU IAT Warning F C 140 60 140 60
ECU IAT Shutdown F C 155 69 155 69
Maximum Coolant Friction Head External to the engine psi bar 5.8 0.4 5.8 0.4
Maximum Air Restriction Across a Radiator inH2O mmH2O 0.5 12.8 0.5 12.8
Standard Thermostat Range
Cracking Temperature F C 160 71 160 71
Full Open Temperature F C 185 85 185 85
Maximum Allowable Pressure Cap psi bar 14.7 1 14.7 1
Ambient Clearance Open Genset (water) (Air-to-Boil)
Specified F C 142 61 142 61
Acutal F C 147 64
Ambient Clearance (Oil)
Specified F C 142 61 142 61
Acutal F C 150 66
CAC Rise over Ambient (Charge)
Specified F C 15 9 15 9
Acutal F C 13 8
Maximum Allowable Top Tank Temperature F C 230 110 230 110
ECU Warning F C 220 104 220 104
ECU Shutdown F C 230 110 230 110
Fan Power HP kW 13 9.7 22 16.4
Fan Diameter, including blades in mm 45 1143 45 1143
Fan Speed RPM 1200 1440
Cooling Fan Air Flow @ 1" Static H2O Pressure and 125F @ radiator CFM m^3/min 25,714 728 30,000 849
Charge Air Cooler
Compressor Outlet Temperature F C 250 121 285 163
Compressor Flow Rate per CAC lb/hr kg/hr 1047 475 1391 650
Heat Rejection per CAC btu/min kW TBD 2669 46.9

11 11/2/2015
 Rev:
Units
C
14.6L 14.6L
Std Metric 1500 1800
Lubrication System

SAE 15W-40 Low Ash Gas engine oil

Oil Specification (.25-.5% by wt), API CD/CF or higher
Oil Pressure
Idle
Min Psi Bar 13 0.9 13 0.9
Max Psi Bar 43.5 3 43.5 3
Rated Speed
Min Psi Bar 43.5 3 43.5 3
Max Psi Bar 94.5 6.5 94.5 6.5
Maximum Allowable Oil Temperature F C 250 121 250 121
Engine Oil Capacity
Min Qts L 26.5 25 26.5 25
Max Qts L 32.75 31 32.75 31
Oil Filter Capacity Qts L 7.5 7.1 7.5 7.1
ECU Oil Pressure Warning5 psi 30
ECU Oil Pressure Shut Down5 psi 25
Fuel System
Fuel Consumption6
NG Ft3/hr kg/hr 2485 56 2782 63
LP Ft3/hr kg/hr 780 42 926 49
Maximum EPR Rated Pressure psi kPa 1.0 6.9 1.0 6.9
Maximum Running pressure to Electronic Pressure Regulator (EPR) inH2O kPa 11.0 2.7 11.0 2.7
Minimum Running pressure to EPR inH2O kPa 7.0 1.7 7.0 1.7
Minimum Gas Supply Pipe Size 2 x 1-1/4" NPT

Maximum EPR Rated Pressure psi kPa 1.0 6.9 1.0 6.9
Maximum Running Pressure to EPR inH2O kPa 11.0 2.7 11.0 2.7
Minimum Running Pressure to EPR inH2O kPa 7.0 1.7 7.0 1.7
Minimum LPG Supply Pipe Size4 2 x 1-1/4" NPT
1
Standby and overload ratings based on ISO3046.
2
All ratings are gross flywheel horsepower corrected to 77oF at an altitude of 328feet with no
cooling fan or alternator losses using heating value for NG of 1015 BTU/SCF.
3
Production tolerances in engines and installed components can account for power variations of
+/- 5%. Altitude, temperature and excessive exhaust and intake restrictions should be applied to
power calculations.
4
The preceeding pipe sizes are only suggestions and piping sizes may vary with temperature,
pressure, distance from supply and application of local codes. Gas must be available at
adequate volume and pressure for engine at the EPR.
5
>1400RPM
6
See PSI HD Technical Spec. 56300002 - Fuel Specification

12 11/2/2015