A300 B4 Refresher Course Exam

A300 B4 Refresher Course Exam
Avionics B2
1. WHAT POWER SOURCE NORMALLY SUPPLIES THE AC BUS 2?

A. Generator 2
B. The APU Generator
C. The Static Inverter
2. THE DC GROUND / FLIGHT BUS 6 PP IS NORMALLY SUPPLIED FROM?

A. The Batteries
B. The Essential TRU
C. The DC normal BUS
3. WHAT IS NORMALLY INDICATED BY THE CSD OIL TEMPERATURE INDICATORS?

A. The oil outlet temperature
B. The oil inlet temperature
C. The oil temperature rise
4. FROM WHERE IS THE GENERATOR CONTROL UNIT NORMALLY SUPPLIED?

A. From the Batteries
B. From the AC Essential BUS
C. From the permanent magnet generator (PMG) inside the respective generator
5. THE AC ESSENTIAL BUS IS NORMALLY SUPPLIED FROM?

A. AC BUS 1
B. AC BUS 2
C. The static inverter
6. WHAT IS THE TASK OF A BATTERY CHARGE LIMITER UNIT?

A. To monitor the charge and discharge current of the responsive battery
B. To charge the battery
C. To supply the ampere meter on the control panel
7. WHICH BATTERY IS TAKEN TO POWER THE REFUEL ON BATTERY CIRCUIT?

A. That one which is switched on
B. All batteries in parallel
C. Only battery 1
Page 1 of 7
8. A HIGH OIL TEMPERATURE IN THE APU OIL SYSTEM SHUTS DOWN THE APU?
A. After a time delay of 20 seconds
B. Immediately
C. After a time delay of 3 seconds
9. WITH THE FD-BARS ON /OFF SWITCH IN THE OFF POSITION?

A. The FD-BARS are out of view
B. The FD disengage
C. The yaw bar only will be out of view
10. THE ENGAGEMENT OF BOTH APS IS POSSIBLE?

A. After engagement of both FDS
B. After the selection of the APPR mode
C. After the selection of the LAND mode
11. THE RED AP OFF LIGHT ILLUMINATES?

A. In all cases of AP disengagement
B. In case of AP disengagement due to a detected failure
C. Automatically after touch down
12. IS IT POSSIBLE TO ENGAGE THE AP ON THE GROUND?

A. No
B. Yes
C. Yes, if all the logic condition are fulfilled and the LG relay circuit breaker are opened to
simulate in flight condition
13. FD1 AND FD2 ARE ENGAGED. WHAT HAPPENS ON THE ADIs IF API IS ENGAGED IN
CMD?
A. Nothing
B. Roll bar appear
C. Pitch bar goes out of view
14. WHAT IS CONFIGURATION OF A MAGNETIC INDICATOR WHEN IT HAS NO

ELECTRICAL SUPPLY?
A. Inline
B. Cross line
C. Amber
15. IS THE MASTER WARNING CONTROLLER SUPPLIED BY?

A. The NORM BUS
B. The ESS BUS
C. Both
Page 2 of 7
16. WHAT DOES THE RECOIL PUSH BUTTON DO?
A. It recoil cancelled warning light if the failure still exist
B. It cancel the take-off inhibit function
C. Both A and B
17. HOW MANY SMOKE DETECTION BOXES ARE INSTALLED?

A. 1
B. 2
C. 3
18. THE SMOKE DETECTORS ARE?

A. Not testable on the A/C
B. Simultaneously tested by a push button
C. Individually testable by a Rotary selector
19. WHAT IS FIRE DETECTION ELECTRICAL SUPPLY?

A. 28 CDC
B. 115 VAC
20. WHERE IS THE RAT TEST SOCKET LOCATED?

A. On the RAT leg
B. On the RAT TEST selector
C. Behind the refuel defuel selector panel on the LH air conditioning scoop
21. WHERE IS THE QUANTITY AMPLIFIER LOCATED?

A. Cargo Compartment
B. Avionics Compartment
C. Flight Deck
22. THE STAND BY AIR DATA SYSTEM PROVIDES INDICATION OF AIRPLANE?

A. Altitude speed and Mach no
B. Altitude speed
C. Only Altitude
23. AMBER LIGHT WILL ILLUMINATE WHEN THE SELECTED ALTITUDE ON AFCS AND
ACTUAL AIRPLANE ALTITUDE IS?
A. Between 500 to 1000
B. Between 100 to 500
C. Between 1000 to 2000
Page 3 of 7
24. WHEN ADI TESTED BY MEANS OF TEST PUSH BUTTON ON ADI?
A. Causes G Flag to appear
B. Displacement of pitch roll indication by 10
C. Both A and B are correct
25. WHEN ADI DETECTS A FAULT?

A. Magnetic heading flag will appear
B. G Flag appear on left side of indicator to indicate attitude data failure
C. DH light will appear on ADI
26. TWO MAGNETIC FAULT ANNUCIATORS OF H.F SYSYTEM?

A. Is located on CM1 Panel
B. Is located on CM2 Panel
C. Is located on CM3 Panel
27. AMBER LIGHT ON VHF TX/RX UNIT ILLUMINATES WHEN?

A. It is on transmit mode
B. It is on receive mode
C. Both on transmit and receive mode
28. SELCAL CONTROLLER IS LOCATED AT?

A. In cockpit
B. In cockpit in rear of center pedestal
C. In cockpit near 2nd observer panel
29. CVR IS LOCATED IN?

A. FWD Cargo
B. AFT Cargo
C. AFT air plenum
30. VHF2 ANT IS LOCATED AT?

A. Bottom of fuselage
B. Top of fuselage
C. Tail area bottom of fuselage
31. DME SHOWS?

A. Mean DME standby
B. Mean DME standby + No computed data
C. Both A and B
32. GPWS WORKS FROM?

A. 50 to 2450
B. 50 to 1500
C. 50 Only
Page 4 of 7
33. LRRA ONE (1) IS LOCATED ON?
A. Z 152
B. Z 162
C. 21 VU
34. WX/RADDAR USES?

A. 1 TX/RX unit + 2 ANTs
B. 1 TX/RX unit + 1 ANTs
C. 2 TX/RX unit + 1 ANTs
35. ATC TRANSPONDER ARE LOCATED AT WX/?

A. #1 on 85 VU and #2 on 86 VU
B. On 21 VU
C. On 22 VU
36. THE FREQUENCY ON MAKER IS?

A. 100 KHZ
B. 75 KHZ 1
C. 75 MHZ
37. LAND 2 IS ILLUMINATED ON THE FPIs?

A. Two FDs are engaged in LAND
B. Two FDs and one AP are engaged in APPR
C. One AP and one FD are engaged in LAND
38. ADF RXs ARE LOCATED IN?

A. AFT Cargo
B. FWD Cargo
C. Air Plenum Chamber
39. THE GAIN PROGRAMMER BEGINS REDUCING THE RADIO DEVIATION SIGNAL
WHEN?
A. The outer marker is sensed
B. The glide slope mode has been selected
C. The aircraft attains a radio altitude of 1000 ft
40. ILS TRANSFER SWITCH IS LOCATED AT?

A. CM3 instrumental panel
B. CM1 instrumental panel
C. CM2 instrumental panel
Page 5 of 7
Page 6 of 7
Page 7 of 7

A300 B4 Refresher Course Exam

Uploaded by

Copyright:

Available Formats

A300 B4 Refresher Course Exam

Uploaded by

Document Information

Original Description:

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

A300 B4 Refresher Course Exam

Uploaded by

Copyright:

Available Formats

A300 B4 Refresher Course Exam

1. WHAT POWER SOURCE NORMALLY SUPPLIES THE AC BUS 2?

2. THE DC GROUND / FLIGHT BUS 6 PP IS NORMALLY SUPPLIED FROM?

3. WHAT IS NORMALLY INDICATED BY THE CSD OIL TEMPERATURE INDICATORS?

4. FROM WHERE IS THE GENERATOR CONTROL UNIT NORMALLY SUPPLIED?

5. THE AC ESSENTIAL BUS IS NORMALLY SUPPLIED FROM?

6. WHAT IS THE TASK OF A BATTERY CHARGE LIMITER UNIT?

7. WHICH BATTERY IS TAKEN TO POWER THE REFUEL ON BATTERY CIRCUIT?

9. WITH THE FD-BARS ON /OFF SWITCH IN THE OFF POSITION?

10. THE ENGAGEMENT OF BOTH APS IS POSSIBLE?

11. THE RED AP OFF LIGHT ILLUMINATES?

12. IS IT POSSIBLE TO ENGAGE THE AP ON THE GROUND?

14. WHAT IS CONFIGURATION OF A MAGNETIC INDICATOR WHEN IT HAS NO

15. IS THE MASTER WARNING CONTROLLER SUPPLIED BY?

17. HOW MANY SMOKE DETECTION BOXES ARE INSTALLED?

18. THE SMOKE DETECTORS ARE?

19. WHAT IS FIRE DETECTION ELECTRICAL SUPPLY?

20. WHERE IS THE RAT TEST SOCKET LOCATED?

21. WHERE IS THE QUANTITY AMPLIFIER LOCATED?

22. THE STAND BY AIR DATA SYSTEM PROVIDES INDICATION OF AIRPLANE?

25. WHEN ADI DETECTS A FAULT?

26. TWO MAGNETIC FAULT ANNUCIATORS OF H.F SYSYTEM?

27. AMBER LIGHT ON VHF TX/RX UNIT ILLUMINATES WHEN?

28. SELCAL CONTROLLER IS LOCATED AT?

29. CVR IS LOCATED IN?

30. VHF2 ANT IS LOCATED AT?

31. DME SHOWS?

32. GPWS WORKS FROM?

34. WX/RADDAR USES?

35. ATC TRANSPONDER ARE LOCATED AT WX/?

36. THE FREQUENCY ON MAKER IS?

37. LAND 2 IS ILLUMINATED ON THE FPIs?

38. ADF RXs ARE LOCATED IN?

40. ILS TRANSFER SWITCH IS LOCATED AT?

You might also like