River Features

River Features
Typically, a river valley can be divided into three sections; the upper
course, the middle course and the lower course. There are particular river
features which we can expect to find in each of these sections. We shall
examine each section of the river along with their various features in some
detail. The diagram below shows the three sections of a river.
Notice the differences in gradient and the shape of the river valley from one section to the next
River Features found in the Upper Course

This is the part of the river closest to the source. The gradient is steep. The
river is small and flows quickly. Some features expected in this section of
the river are V- shaped valleys, interlocking spurs, a river bed with large
rocks and stones,gorges, fast flowing rapids and waterfalls.
V-shaped valleys:
The river flows quickly cutting down into its bed. This process is is known
as vertical erosion. It forms deep valleys with steep sides know as V-shaped
valleys. Take a look at the V-shaped valley in the picture below.
This V-shaped valley is located in Ecuador (South America)
Interlocking spurs:
As the river meanders around obstacles, erosion is concentrated on the

outside of the bends. At the same time, vertical erosion is taking place. The
result is ridges of high land which project toward the river decreasing in
height toward the river. These ridges alternate on either side of the river
and are called interlocking spurs. Click here for a diagram showing
interlocking spurs.
These interlocking spurs were formed by one of the tributaries of the River Severn in the UK
Waterfalls:
When a river plunges vertically over a rock face, the result is a waterfall.
Waterfalls are formed in several ways, for example, a river may plunge
over the edge of a plateau. It is common for waterfalls to form where a
river crosses a band of hard rock or resistant rock. This is shown in the
video below.
Gorges:
As a waterfall retreats upstream, it leaves behind a narrow steep sided

feature known as a gorge. Gorges can also be formed in other ways. The
Grand Canyon of the Colorado River in the USA formed as the surrounding
land was uplifted. Take a look at the photos below.
Katherine Gorge was carved out by the Katherine river in Australia
The Grand Canyon was created by the Colorado river in the USA
Watch this video about how gorges can be created by waterfalls.

Rapids:
At rapids, a river flows very fast down a steep slope. The river bed is rough
and rocks are exposed at the surface. There may be alternating bands of
hard and soft rocks which cause an uneven river bed. These conditions
create a zone of turbulent water called rapids. The picture below shows
Scales Rapids in the Gauley River in the USA.
Scales Rapids
River Features found in the Middle Course

In this part of the river, the gradient is not as steep as it was in the upper
course. Lateral erosion (erosion of the banks) is now more effective than
vertical erosion. The river develops a wider, more open appearance. Some
deposition now takes place. Meanders (bends in the river) are more
common. Typical features found in the middle course are:
River cliffs and slip-off slopes:
As a river meanders, the outside banks of the meander are undercut. This
creates river cliffs. On the inside of the meander, where the water flows
more slowly, deposition takes place. This gives rise to a gentle slope known
as a slip-off slope.
This diagram shows how river cliffs and slip off slopes are formed
River Features found in the Lower Course

This is the part of the river nearest the sea. Here, the gradient is even
gentler. The river flows even more slowly and the volume of water is
greater. Deposition is much more important than erosion in this part of the
river. Some features usually found in this section are:
Flood Plain:
In the middle and lower courses of a river, alluvium is deposited on the

valley floor, mainly where the river floods. The wide flat deposits which
result are known as the flood plain of the river. Flood plains vary from a
few hundred meters to several kilometers across.
Diagram showing the flood plain of a river
Ox-bow lakes:
These are shallow crescent shaped lakes formed when a meander is

abandoned by a river. Sometimes a meander becomes so pronounced that
only a narrow neck of land separates the two ends of it.When the river is in
flood, this neck is broken and the river starts to flow a shorter, more direct
route. Deposition takes place, sealing off the ends of the meander and
creating an ox-bow lake. Take a look at the animation below which shows
the formation of an ox bow lake.
This ox bow lake is found on the island of Borneo in the South China Sea
This photo, taken near The Last Frontier Boutique Resort is courtesy of
TripAdvisor
Levees:
When a river is in flood, it deposits material on its flood plain. The heaviest
material is deposited near the river. After successive floods, natural
embankments called levees are created alongside the river. This is shown
in the diagram below.
Natural levees are formed as a result of many floods depositing sediment on the banks of the
river
Braiding:
This occurs when a river divides for various distances into two or more
channels. The channels are separated by islands of sediment called bars.
Braiding occurs when the river carries a large load or when the volume of
the water in the river changes rapidly from season to season.
This photo shows braiding in a riverʼs channel
Deltas:
Much of the material carried by a river ends up in the sea. If the conditions
are favorable, this sediment may accumulate until it rises above the surface
of the sea. This area of flat land, built up from silt and alluvium where a
river flows into the sea is called a delta.The build-up of sediment
eventually interferes with the flow of the river, causing it to split up into
several channels called distributaries.
Relatively few rivers have deltas. Deltas form most easily under the
following conditions:
when the river carries a large volume of sediment
when the sea is relatively calm,so the sediment is not carried away by
waves or strong currents.
where the sea is not too deep
when the river flows slowly
when the vertical difference between high tide and low tide (tidal
range) is not too great.
The Nile Delta in Egypt is a piece of land that was built as the Nile dumped
sediment into the Mediterranean Sea. Take a look at the photo of the Nile
Delta and the diagram below it.
The Nile Delta (green area on the coast) was built up by the River Nile as it dumped sediment
into the Mediterranean Sea
Diagram of the Nile Delta
Take the River Quiz!
References
http://en.wikipedia.org/wiki/File:Nile_Delta
http://greenfieldgeography.wikispaces.com
http://web.mst.edu/~rogersda/levees
http://www.wired.com/wiredscience
http://www.geocaching.com
http://www.gauleyriverrapids.com
http://www.outback-australia-travel-secrets.com
http://tripwow.tripadvisor.com
Related Pages
Water
Rivers
Limestone Features
Waves
Coastal Features

River Features - Geo For CXC

Uploaded by

Copyright:

Available Formats

River Features - Geo For CXC

Uploaded by

Document Information

Original Description:

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

River Features - Geo For CXC

Uploaded by

Copyright:

Available Formats

River Features found in the Upper Course

This V-shaped valley is located in Ecuador (South America)

As the river meanders around obstacles, erosion is concentrated on the

As a waterfall retreats upstream, it leaves behind a narrow steep sided

Watch this video about how gorges can be created by waterfalls.

River Features found in the Middle Course

River cliffs and slip-off slopes:

River Features found in the Lower Course

In the middle and lower courses of a river, alluvium is deposited on the

These are shallow crescent shaped lakes formed when a meander is

when the river carries a large volume of sediment

where the sea is not too deep

when the river flows slowly

Take the River Quiz!

You might also like