Sinkholes

Sinkholes
It is a frightening thought to imagine the ground below your feet or house suddenly collapsing and forming a big hole in the
ground. Sinkholes rarely happen, but when they strike, tragedy can occur. Sinkholes happen when the ground below the land
surface cannot support the land surface. They happen for many reasons; read on to educate yourself about sinkholes.
More than 110 sinkholes formed in the Dover area of Florida

during a freeze event in January 2010. Ground water levels
dropped to record-setting lows as farmers pumped water to
irrigate their plants for protection from the cold temperatures.
The sinkholes destroyed homes, roads and sections of
cultivated areas.
Credit: Ann Tihansky, USGS, Public domain
Sinkholes are common where the rock below the land surface is
limestone, carbonate rock, salt beds, or rocks that can naturally
be dissolved by groundwater circulating through them. As the
rock dissolves, spaces and caverns develop underground.
Sinkholes are dramatic because the land usually stays intact for
a while until the underground spaces just get too big. If there is
not enough support for the land above the spaces, then a sudden
collapse of the land surface can occur. These collapses can be
small, or, as this picture shows, or they can be huge and can
occur where a house or road is on top.
The most damage from sinkholes tends to occur in Florida, Texas, Alabama, Missouri, Kentucky, Tennessee, and
Pennsylvania.
What is a "sinkhole"?
A sinkhole is an area of ground that has no natural external surface drainage--when it rains, the water stays inside the sinkhole
and typically drains into the subsurface. Sinkholes can vary from a few feet to hundreds of acres and from less than 1 to more
than 100 feet deep. Some are shaped like shallow bowls or saucers whereas others have vertical walls; some hold water and
form natural ponds.
Typically, sinkholes form so slowly that little change is noticeable, but they can form suddenly when a collapse occurs. Such
a collapse can have a dramatic effect if it occurs in an urban setting.
Areas prone to collapse sinkholes
The map below shows areas of the United States where certain rock types that are susceptible to dissolution in water occur.
In these areas the formation of underground cavities can form, and catastrophic sinkholes can happen. These rock types are
evaporites (salt, gypsum, and anhydrite) and carbonates (limestone and dolomite). Evaporite rocks underlie about 35 to 40
percent of the United States, though in many areas they are buried at great depths.
Types of sinkholes
Since Florida is prone to sinkholes, it is a good place to use to discuss some different types of sinkholes and the geologic and
hydrologic processes that form them. The processes of dissolution, where surface rock that are soluble to weak acids, are
dissolved, and suffusion, where cavities form below the land surface, are responsible for virtually all sinkholes in Florida.
DISSOLUTION SINKHOLES
Dissolution of the limestone or dolomite is most intensive where the water first contacts the rock surface. Aggressive
dissolution also occurs where flow is focused in preexisting openings in the rock, such as along joints, fractures, and bedding
planes, and in the zone of water-table fluctuation where groundwater is in contact with the atmosphere.
Rainfall and surface water percolate through joints in the limestone. Dissolved carbonate rock is carried away from the surface
and a small depression gradually forms. On exposed carbonate surfaces, a depression may focus surface drainage,
accelerating the dissolution process. Debris carried into the developing sinkhole may plug the outflow, ponding water and
creating wetlands. Gently rolling hills and shallow depressions caused by solution sinkholes are common topographic features
throughout much of Florida.
Source: Land Subsidence in the United States, USGS, Public domain
COVER-SUBSIDENCE SINKHOLES
Cover-subsidence sinkholes tend to develop gradually where the covering sediments are permeable and contain sand. In
areas where cover material is thicker, or sediments contain more clay, cover-subsidence sinkholes are relatively uncommon,
are smaller, and may go undetected for long periods.
1. Granular sediments spall into secondary openings in the underlying carbonate rocks.
2. A column of overlying sediments settles into the vacated spaces (a process termed “piping”).
3. Dissolution and infilling continue, forming a noticeable depression in the land surface.\
4. The slow downward erosion eventually forms small surface depressions 1 inch to several feet in depth and diameter.
In areas where cover material is thicker, or sediments contain more clay, cover-subsidence sinkholes are relatively
uncommon, are smaller, and may go undetected for long periods.

COVER-COLLAPSE SINKHOLES
Cover-collapse sinkholes may develop abruptly (over a period of hours) and cause catastrophic damages. They occur where
the covering sediments contain a significant amount of clay. Over time, surface drainage, erosion, and deposition of sinkhole
into a shallower bowl-shaped depression. Over time, surface drainage, erosion, and deposition of sediment transform the
steep-walled sinkhole into a shallower bowl-shaped depression.
1. Sediments spall into a cavity
2. As spalling continues, the cohesive covering sediments form a structural arch.
3. The cavity migrates upward by progressive roof collapse.
4. The cavity eventually breaches the ground surface, creating sudden and dramatic sinkholes.

Sinkholes can be human-induced
New sinkholes have been correlated to land-use practices, especially from groundwater pumping and from construction and
development practices. Sinkholes can also form when natural water-drainage patterns are changed and new water-diversion
systems are developed. Some sinkholes form when the land surface is changed, such as when industrial and runoff-storage
ponds are created. The substantial weight of the new material can trigger an underground collapse of supporting material,
thus causing a sinkhole.
The overburden sediments that cover buried cavities in the aquifer systems are delicately balanced by groundwater fluid
pressure. The water below ground is actually helping to keep the surface soil in place. Groundwater pumping for urban water
supply and for irrigation can produce new sinkholes in sinkhole-prone areas. If pumping results in a lowering of groundwater
levels, then underground structural failure, and thus, sinkholes, can occur.
Source:
http://water.usgs.gov/edu/sinkholes.html

Sinkholes

Uploaded by

Copyright:

Available Formats

Sinkholes

Uploaded by

Document Information

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Sinkholes

Uploaded by

Copyright:

Available Formats

Sinkholes

More than 110 sinkholes formed in the Dover area of Florida

Source: Land Subsidence in the United States, USGS, Public domain

Source: Land Subsidence in the United States, USGS, Public domain

You might also like