Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                

Telkomsel Lte FDD Interworking Strategy For l1800 Amp U900 U2100

Download as pdf or txt
Download as pdf or txt
You are on page 1of 10

Huawei confidential

Telkomsel LTE
Interworking Strategy
(LTE1800
+ U900 + U2100 + GSM)
www.huawei.com
Overview of Interworking Strategy
Idle Mode

• Reselection within same LTE frequency layer: Intra-frequency reselection based on coverage
• Reselection between L900, L1800 are Inter-Frequency reselection based on coverage
• LTE  U900/U2100/G1800: Reselection based on coverage (G900 not involved since only S1/1/1 )
• U900/U2100/G1800/G900  LTE: Reselection based on priority (L1800 has higher priority than L900)
• 2G/3G interworking to L900 will be deleted after all L900 shutdown

Same priority
LTE LTE LTE L1800
within LTE
Different Priority
L900
from 3G/2G

F1, F2, F3 Higher priority for


UMTS 2100 UMTS 2100 UMTS 2100
U2100 L2U reselection

Low priority for L2U


reselection. If U900
UMTS 900 UMTS 900 F4 U900
already continuously
coverage then can set
high priority

GSM 1800 GSM 1800 GSM 1800 G1800

GSM 900 Coverage Trigger 


G900
Priority Trigger 
Inter-RAT  – Idle Mode Cell Reselection
• Propose to set L900 to higher reselection priority than U2100 & GSM1800/900.
• LTE capable UE always prefer to camp on LTE due to higher cell priority than UMTS/GSM.
• UE prefer to reselect to U2100 only when LTE signal is low and UMTS signal fulfill the cell
reselection triggering threshold. Only U2100 is not available and U900 is available then reselect to
U900.

•  Absolute priority will be set for both LTE and UMTS network to facilitate cell reselection preference
to LTE network.

•  Absolute priority ranges from 0 to 7, where 7 indicate the highest priority and 0 indicate the lowest
priority.
Telkomsel
Priority
System
7 LTE 1800

6 LTE 900 Range use for LTE/Future Use


 L900 and L1800 are same
priority within LTE layer  5

 U2100 and U900 are same 4 UMTS 2100

priority within 3G layer  3 UMTS 900


Range use for UMTS

1 GSM
Range use for GSM
0
Overview of Interworking Strategy
Connected Mode
• HO within LTE same frequency: Intra-frequency handover based on coverage
• HO between LTE different frequency: Inter-Freq HO triggered by coverage, and by LTE cell load (MLB: Mobility Load Balance)
• LTE  U2100/G1800: Inter-RAT PS Redirection for PS service, CSFB by redirection for CS service (G900 not involved).
Blind redirection will be adapt when U900 co-located with LTE
• UMTS & GSM LTE: Redirection for PS Service (fast return only co-locate with LTE), 3G to LTE service based redirection

 U900 is not considered


for L2U interworking for
LTE LTE LTE LTE  connection mode
mobility before U900 is
continuous coverage.
 Also U900 quality need
to monitor considering
U2100 U2100 U2100 F1~F4 UMTS
uplink interference on
900MHz band.
U900

CSFB
GSM 1800 GSM 1800 GSM 1800 G1800
Load Based redirection (MLB)
Coverage Based PS redirection
GSM 900 GSM 900 GSM 900 G900
G->L Fast Return
U->L Fast Return
 Fast Return will not enable on U900 cells since it has bigger coverage than L1800.
 In future if U900 is verified good performance and continuous coverage, then can U2L service based redirection

consider Interworking to U900 instead of U2100 by blind redirection


Thank you
www.huawei.com

You might also like