Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                

DSA002

Download as pdf or txt
Download as pdf or txt
You are on page 1of 1

DIGITAL-LOGIC AG Kyocera KCS057QV1AJ-G23

Kyocera KCS057QV1AJ-G23

Model KCS057QV1AJ- Filename LC_KCS57.XXX


G23
Manufacturer Kyocera Bios code LC
Resolution 320x240 Bios/Table version V1.0/V1.0
Number of Colors Color Used Controller 69000
Technology STN-Color Date of adaption 7.01
Interface Digital Size 5,7“

LCD signal LCD connector pin Controller signal


CP 3 CLK
LOAD 2 LP
FRM 1 FLM
DISP 4 EVDD

VEE* 7 EVEE*
VDD 5 EVDD or VCC (5V)
VSS 6 GND

D0 15 P7
D1 14 P6
D2 13 P5
D3 12 P4
D4 11 P3
D5 10 P2
D6 9 P1
D7 8 P0

Voltage description Voltage level Maximum current Note


VDD +5V DC 4.5mA
VEE +26.0 DC 11.3mA

* The voltages for the lcd have to be switched in correct power-up and -down sequence.
Use EVEE pin on the board to switch the external generated VEE. On some boards, this output is in TTL
level only. An external FET or relais is needed for save switching of VEE.

Never connect VEE direct to the board or LCD! Ask Digital-Logic LCD-support for further information.

Please refer to the Digital-Logic LCD-manual for further information.

The BIOS will start in flat panel - only mode. The CRT output is switched off !
If you need the CRT (without LCD at the same time) use the DOS tool ct.com to switch on the CRT
temporarily. This tool is available from Digital-Logic.

You might also like